light Mercury Villager 1997 s Service Manual

Controls and Features
103
%*
[CF31200(ALL)01/96]
Liftgate
[CF31300(ALL)01/96]
Opening the Liftgate
[CF31400(ALL)01/96]
To unlock the liftgate with the key, insert the key into the lock
and turn it counterclockwise. To make the gate swing up to the
fully opened position, pull back and upward on the handle. The
liftgate will not unlock if the optional liftgate window is open.
[CF31500(ALL)01/96]
17-1/2 pica art:0040121-F
Opening the liftgate
[CF31600(ALL)01/96]
You can also unlock the liftgate using the optional power door
lock system, or the optional keyless entry system. However, it
cannot be opened until you release the latch by reaching under
the license plate light shield and lifting up on the handle.
File:05vxcfn.ex
Update:Thu May 30 09:49:09 1996

Controls and Features
105
*
[CF32000(ALL)01/96]
RWARNING
Make sure that the liftgate door and/or window are
closed to prevent exhaust fumes from being drawn into
the vehicle. This will also prevent passengers and cargo
from falling out. If you must drive with the liftgate door
or window open, keep the vents open so outside air
comes into the vehicle.
[CF32100(ALL)01/96]
Closing the Liftgate
[CF32200(ALL)01/96]
To close the liftgate, reach up and pull the handle on the inner
trim panel downward.
[CF32300(ALL)01/96]
When you have pulled down the liftgate enough so that you
can reach the license plate light shield, push the shield down
and forward to close the liftgate. At this point, the liftgate is not
locked.
[CF32400(ALL)01/96]
The liftgate has an intermediate and a fully closed position.
Make sure the liftgate is fully closed before you drive your
vehicle.
File:05vxcfn.ex
Update:Thu May 30 09:49:09 1996

Controls and Features
115
[CF73600(ALL)05/96]
By pressing the UNLOCK button on the transmitter once, you
can unlock the driver's side door. Pressing the UNLOCK button
a second time within six (6) seconds of unlocking the driver's
door will unlock the other doors. The interior lamp will turn on
and stay on for thirty (30) seconds.
[CF73700(ALL)05/96]
By pressing the LOCK button on the transmitter once, all the
doors will lock, the parking lamps flash twice and the horn
chirps. When the LOCK button is pushed with all the doors
locked, the parking lamps flash twice and the horn chirps to
confirm that the doors are already locked.
[CF73800(ALL)01/96]
Using the Panic Alarm
[CF73900(ALL)01/96]
If you are near your vehicle and feel threatened, you may
activate the alarm to call attention to it.
[CF74000(ALL)04/96]
To activate the PANIC alarm, push and hold the PANIC button
on the remote for longer than 1.5 seconds. The horn will sound
and the headlamps and tail lights will flash for thirty (30)
seconds. To turn off the alarm, press the LOCK or UNLOCK
buttons or hold the PANIC button down for longer than 1.5
seconds.
%*
[CF74100(ALL)03/96]
Replacing the Batteries
[CF74200(ALL)01/96]
The remote entry transmitter is powered by two coin type
Sanyo CR2016 3 volt batteries (included). If you notice a
significant decrease in operating range, the batteries should be
replaced. Replacement batteries can be purchased at most
pharmacies, watch stores or at your Ford or Lincoln-Mercury
dealer.
[CF74300(ALL)01/96]
NOTE: The operating range of the remote entry system can
also be affected by weather conditions (such as very
cold temperatures) or structures around the vehicle
(buildings, other vehicles, radio and TV towers, etc.).
Typical operating range will allow you to be up to 49
feet (15 meters) away from your vehicle.
File:05vxcfn.ex
Update:Thu May 30 09:49:09 1996

Controls and Features
117
*
[CF75100(ALL)01/96]
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING
TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.
[CF75200(ALL)01/96]
Replacement/Additional Transmitters
[CF75300(ALL)01/96]
In the event a transmitter is lost or an additional remote
transmitter needs to be set, you must change the ID code.
Follow the steps below to change the ID code of your system,
or return the remaining transmitter(s) to your dealer for
reprogramming of your remote entry system. This is necessary
to prevent unauthorized use of the lost transmitter.
[CF75400(ALL)01/96]
ID Code Programming Procedure
[CF75500(ALL)01/96]
NOTE: All transmitters must be programmed (or
reprogrammed) at the same time. If the programming
mode is entered and the transmitters are not
programmed (or reprogrammed) at the same time, they
will not operate with the system.
[CF75600(ALL)01/96]1.
Enter vehicle and close and lock all doors.
[CF75700(ALL)01/96]2.
Insert and remove key from ignition six times within ten (10)
seconds. The instrument panel lights will flash twice.
[CF75800(ALL)01/96]3.
Turn ignition key to the ACC position.
[CF75900(ALL)01/96]4.
Press the LOCK button on the remote transmitter once.
[CF76000(ALL)01/96]5.
To enter additional remote controllers (including the
original), unlock, then lock the driver's door using the power
door lock switch.
File:05vxcfn.ex
Update:Thu May 30 09:49:09 1996

118
[CF76100(ALL)01/96]6.
Press the LOCK button on a new remote transmitter. The
instrument panel lights will flash twice, indicating code is
entered.
[CF76200(ALL)01/96]7.
Repeat steps 5 and 6 as needed (up to four remote
transmitters may be programmed).
[CF76300(ALL)01/96]
Anti-Theft System (If equipped)
[CF76400(ALL)05/96]
This system helps protect your vehicle against break-ins or theft
by monitoring all doors, the hood and the liftgate lock cylinder.
%*
[CF76500(ALL)01/96]
When an unauthorized entry occurs, the system triggers and
will:
[CF76600(ALL)01/96]
n
flash the headlamps and hazard lamps
*
[CF76700(ALL)01/96]
n
honk the horn
*
[CF76800(ALL)01/96]
n
disable the starting circuit to prevent the vehicle from being
started
[CF76900(ALL)01/96]
To arm the system
*
[CF77000(ALL)01/96]1.
Remove the key from the ignition.
[CF77100(ALL)05/96]2.
Lock the doors by using either the power door lock switch
or by turning the key in either the driver or passenger door
lock cylinder. The parking lights will flash and the horn
chirps to let you know that the system has been armed. The
anti-theft indicator light on the right side of the steering
wheel will light and remain on.
File:05vxcfn.ex
Update:Thu May 30 09:49:09 1996

Controls and Features
119
[CF77200(ALL)01/96]
13-1/2 pica
art:0040329-A
Anti-theft indicator light
[CF77300(ALL)03/96]
NOTE: If your vehicle is equipped with a factory installed
remote keyless entry system, the system can be armed
by closing all the doors and pressing the LOCK
button on the remote transmitter.
[CF77400(ALL)05/96]3.
Close all doors. The anti-theft indicator light will stay on for
approximately 30 seconds and then flash once every 2.5
seconds.
[CF77500(ALL)01/96]
NOTE: Be sure to close all the doors completely. If the doors
are not completely closed, the alarm indicator light
will remain on steadily. The anti-theft system is
armed only when the anti-theft indicator light remains
on steadily for approximately 30 seconds after the last
door is closed, and then flashes every 2.5 seconds.
File:05vxcfn.ex
Update:Thu May 30 09:49:09 1996

Controls and Features
121
[CF78400(ALL)01/96]
Disarming a triggered anti-theft system
[CF78500(ALL)05/96]
The alarm can be disarmed by:
[CF78600(ALL)01/96]
n
unlocking the driver or passenger doors
[CF78700(ALL)03/96]
n
unlocking the doors with the remote keyless entry
transmitter (if equipped)
[CF78800(ALL)01/96]
n
putting the key in the ignition and turning it to the ACC
position
[CF78900(ALL)01/96]
NOTE: The flashing lights and honking horn will shut off
automatically within 2 minutes 30 seconds after the
system is triggered. It will trigger again if another
intrusion occurs. However, the starter circuit remains
disabled until the system is disarmed.
[CF79000(ALL)05/96]
NOTE: Factory installed remote keyless entry systems will
only operate with the ignition in the OFF position.
File:05vxcfn.ex
Update:Thu May 30 09:49:09 1996

130
[SS00190(ALL)01/96]
Rear Seat Cupholders (available on some models)
[SS00192(ALL)01/96]
Your vehicle may also have rear seat cupholders built into the
side panels.
[SS00194(ALL)01/96]
RWARNING
Objects stored on the ledges below the rear side
windows can become dangerous projectiles during a
sudden stop or collision. Put small objects only in the
storage compartments.
[SS00196(ALL)01/96]
Third Row Seat Storage Compartment (If equipped)
[SS00198(ALL)01/96]
Your vehicle may come equipped with a folding
cupholder/storage tray/storage compartment built into the
passenger's side of the third row seat. Find the indented ledge
on the right of the cupholder and pull it up to reveal the
storage compartment.
[SS00200(ALL)01/96]
Power Point Electrical Outlet (If equipped)
[SS00202(ALL)01/96]
Your vehicle may be equipped with a 12 volt power point
outlet located just below the rear seat audio controls. The power
point can be used in place of the cigarette lighter for optional
electrical accessories.
[SS00204(ALL)05/96]
NOTE: Do not plug the cigarette lighter into this power point
electrical outlet. Use the cigarette lighter.
File:06vxssn.ex
Update:Thu Jun 6 10:54:22 1996

Seating and Safety Restraints
131
%*
[SS00600(ALL)02/96]
Important Safety Belt Information
*
[SS00700(ALL)05/96]
The use of safety belts helps to restrain you and your
passengers in case of a collision. In most states and in Canada,
the law requires their use.
*
[SS00800(ALL)02/96]
Safety belts provide best restraint when:
*
[SS00900(ALL)02/96]
n
the seatback is upright
*
[SS01000(ALL)02/96]
n
the occupant is sitting upright (not slouched)
*
[SS01100(ALL)02/96]
n
the lap belt is snug and low on the hips
*
[SS01200(ALL)02/96]
n
the shoulder belt is snug against the chest
*
[SS01300(ALL)02/96]
n
the knees are straight forward
*
[SS01400(ALL)02/96]
To help you remember to fasten your safety belt, a warning
light may come on and a chime may sound. SeeSafety Belt
Warning Light and Chimein theInstrumentationchapter.
*
[SS01900(ALL)02/96]
See the following sections in this chapter for directions on how
to properly use these safety belts. Also seeSafety Restraints for
Childrenin this chapter for special instructions about using
safety belts for children.
File:06vxssn.ex
Update:Thu Jun 6 10:54:22 1996

134
[SS10450(ALL)01/96]
7-1/2 pica art:0040314-A
Unfastening the combination lap and shoulder belts Ð front and rear outboard
seating positions
[SS10500(ALL)01/96]
Third-row passengers should be aware that the proper safety
belt for their seating position is slightly behind their seat. They
should not use the second-row safety belts which are in front of
the third seat.
[SS10600(ALL)01/96]
17-1/2 pica
art:0040004-A
Fastening the rear seat combination lap and shoulder belt
File:06vxssn.ex
Update:Thu Jun 6 10:54:22 1996