service reset Mercury Villager 1997 Owner's Manuals

Starting
215
*
[TO09020(ALL)03/96]
Once the shut-off switch is activated, you must reset the switch
by hand before you can start your vehicle.
[TO09025(ALL)01/96]
The fuel pump shut-off switch reset button is located below the
hood release handle.
[TO09030(ALL)01/96]
10-1/2 pica
art:0040048-C
Fuel pump shut-off switch reset button location
*
[TO09035(ALL)03/96]
RWARNING
If you see or smell fuel, do not reset the switch or try to
start your vehicle. Have all the passengers get out of the
vehicle and call the local fire department or a towing
service.
*
[TO09040(ALL)01/96]
If your engine cranks, but does not start after a collision:
*
[TO09045(ALL)01/96]1.
Turn the key in the ignition to the OFF position.
*
[TO09050(ALL)03/96]2.
Check under the vehicle for leaking fuel.
*
[TO09055(ALL)01/96]3.
If you do not see or smell fuel, push the fuel pump shut-off
reset button down. If the red button is already set, you may
have a different mechanical or electrical problem.
*
[TO09060(ALL)01/96]4.
Turn the ignition key to the ON position for a few seconds,
then turn it to the OFF position.
File:08vxton.ex
Update:Thu May 30 09:53:35 1996

318
%*
[MC38590(ALL)03/96
]
How to Prepare Your Vehicle for
Inspection/Maintenance (I/M) Testing
*
[MC38595(ALL)05/96]
In some localities it may become a legal requirement to pass an
Inspection/Maintenance (I/M) test of the On-Board Diagnostic
(OBD) II system. If the vehicle's powertrain system or its battery
has just been serviced, the OBD II system is reset to a not ready
for I/M testing condition. To prepare for I/M testing, the law
specifies that additional mixed city and highway driving is
required to complete the check of the OBD II system.
*
[MC38602(ALL)03/96]
The driving modes required to reach the ready condition consist
of a minimum of 30 minutes of city and highway driving as
described below.
*
[MC38607(ALL)03/96]
n
20 minutes of driving in stop and go city-type traffic with at
least four idle periods.
*
[MC38612(ALL)03/96]
n
10 minutes of driving on an expressway or highway.
*
[MC38617(ALL)05/96]
Before completing the above driving modes, the engine must be
warmed up and at operating temperature. Once started, the
vehicle must not be turned off during the above driving modes.
If the vehicle owner is unable to meet the I/M requirements by
using these driving patterns, an authorized service center can
perform a detailed OBD II drive cycle as it would any other
type of repair work.
%*
[MC38700(ALL)03/96]
Lights and Bulb Replacement
*
[MC38800(ALL)01/96]
It is a good idea to check the operation of the following lights
frequently:
*
[MC38900(ALL)01/96]
n
headlamps
*
[MC38950(ALL)01/96]
n
high-mount brakelamp
*
[MC39000(ALL)01/96]
n
tail lamps
*
[MC39100(ALL)01/96]
n
brakelamps
File:11vxmcn.ex
Update:Mon Jun 10 15:17:05 1996