warning Mercury Villager 1998 s User Guide

How to Take Care of and Clean Your CD Changer and
Discs
To ensure the continued performance of your Ford Compact Disc
Changer, carefully read the following precautions:
mAlways handle the disc by its edge. Never touch the playing
surface.
mBefore playing, inspect the disc for any contamination. If
needed, clean the disc with an approved disc cleaner, such as the
DiscwashertCompact Disc Cleaner or the Allsop 3t
Compact Disc Cleaner, by wiping from the center out to the
edges.Do not use a circular motion to clean.
mDo not clean discs with solvents such as benzene, thinner,
commercially available cleaners or antistatic spray
intended for analog records.
mDo not expose the disc to direct sunlight or heat sources such
as defroster and floor heating ducts. Do not leave any discs in
a parked car in direct sunlight where there may be a
considerable rise in temperature or damage may result.
mAfter playing, store the disc in its case.
mIf a disc has already been inserted, do not try to insert another
disc. Doing so may damage the disc changer.
mDo not insert anything other than a disc into the disc changer.
WARNING
The laser beam used in the compact disc player is harmful
to the eyes. Do not attempt to disassemble the case.
Electronic Sound Systems
45

WARNING
Operating with the function selector control in off or in
the recirculated air mode for extended periods of time in
cold weather can result in fog buildup on interior glass
surfaces.
mThe Mix () button directs approximately equal amounts
of air to the windshield and floor outlets with a small
amount to the side windows.
mThe Defrost (
) button directs air to the windshield and
front side windows with a small amount going to the floor
outlets.
mThe Panel (
) button directs air to the instrument panel
outlets.
mThe Panel/Floor (
) button directs approximately equal
amounts of air to the instrument panel outlets and the floor
outlets.
mThe Floor (
) button directs most of the system's air
supply to the floor outlets with a small amount going to the
windshield and side window defrosters.
Air Outlets
Air intake selector button
The typical air intake selection is outside air. However, for
recirculated air, the air intake selector button may be activated.
When the air intake selector button is activated (indicator light is
on), it prevents the intake of outside air. This is the typical
selection when using the air conditioner (if equipped). It
recirculates interior air for faster cooling. The recirculated air
function also helps to prevent the intake of dusty or unpleasant air.
Controls and Features
57

WARNING
The Daytime Running Light (DRL) system will not
illuminate the tail lamps and parking lamps. Turn on your
headlamps at dusk. Failure to do so may result in a
collision.
Lighting Up the Instrument Panel
The instrument panel lights can be turned on by turning the
headlamp control knob to either the first or second position. You
can brighten or dim the instrument panel lights with the DIM
switch. The DIM switch is located near the headlamp controls.
Pushing and holding the right side of the switch will continue to
brighten the lights until the maximum brightness is reached.
Release the switch to maintain the desired brightness. To dim the
instrument panel lights, push the left side of the switch.
Autolamp On/Off Delay System (If equipped)
The autolamp sets the headlamps to turn on and off automatically.
You can use the autolamp to:
mturn on the headlamps automatically at night
mturn off the headlamps automatically during daylight
The instrument panel brightness control
Controls and Features
79

Ignition
Understanding the Positions of the Ignition
Your vehicle's ignition has four positions. They are:
OFF/LOCK allows you to shut off the engine and all
accessories and locks the gearshift lever. Removing the key then
locks the steering wheel.
ACCESSORY allows you to operate some of your vehicle's
electrical accessories while the engine is not running. For example,
you can use ACCESSORY to turn on the radio, windshield
wipers, or operate the cigarette lighter without starting the engine.
ON allows you to test your vehicle's warning lights to make
sure they work before you start the engine. The key returns to the
ON position once the engine is started and remains in this
position while the engine runs.
START cranks the engine. Release the key once the engine starts
so that you don't damage the starter. The key should return
to the ON position when you release it.
The ignition positions
86

WARNING
Always warm up the windshield with the defroster before
you use the washer fluid. In freezing weather, the
washer solution may freeze on the windshield and obscure
your vision.
For information about refilling the washer fluid or replacing your
windshield wiper blades, seeWindshield washer fluid and Wipers
in the Index.
Gearshift Lever
The gearshift lever on your vehicle is mounted on the steering
column. On the end of the gearshift lever is the Overdrive On/Off
button. To learn about the operation of the gearshift lever and
the Overdrive On/Off button, see theDrivingchapter.
Gearshift lever location
90

Tilt Steering
WARNING
Never adjust the steering wheel when the vehicle is
moving.
To change the position of the steering column, pull the release lever
on the column down. Move the steering wheel to the desired
position and raise the lever to lock the steering wheel in place.
Tilt release lever location
Controls and Features
91

When the CRUISE indicator blinks, press the speed control OFF
switch and have the system checked by your Ford or
Lincoln-Mercury dealer.
The CRUISE indicator light may blink if the CRUISE CONT. ON
switch is pressed while pushing the RES/ACCEL,
COAST/SET, or CANCEL buttons located on the left side of the
steering wheel.
Power Sunroof (If equipped)
The power sunroof controls are found in the overhead console.
The power sunroof operates with the ignition in the ON position.
To open the sunroof, press and hold the OPEN side of the
switch. Release the switch when the sunroof reaches the desired
position. To close the sunroof, press the CLOSE side of the switch.
When the sunroof panel is closed, you can raise the sunroof to the
vent position by pressing the UP side of the switch. To lower the
moonroof from the vent position, press the DOWN side of the switch.
WARNING
Do not let children play with the moon roof. They may
seriously hurt themselves.
Remove any snow, water or other foreign matter from the
sunroof before you open it.
Power sunroof controls
96

WARNING
Make sure that the liftgate door and/or window are closed
to prevent exhaust fumes from being drawn into the
vehicle. This will also prevent passengers and cargo from
falling out. If you must drive with the liftgate door or
window open, keep the vents open so outside air comes into
the vehicle.
Closing the Liftgate
To close the liftgate, reach up and pull the handle on the inner
trim panel downward.
When you have pulled down the liftgate enough so that you can
reach the license plate light shield, push the shield down and
forward to close the liftgate. At this point, the liftgate is not locked.
The liftgate window in the open position
104

You can lock the liftgate by pushing in the lock lever before you
begin to close the liftgate. You can also lock the liftgate by
closing the liftgate, inserting your key and turning it clockwise
until you hear the lock lever engage. If you turn it too far, the
optional liftgate window will open. The liftgate can also be
locked with the optional power door locks.
The liftgate area is intended only for cargo, not passengers. It
cannot be opened from inside the vehicle.
After the lock lever is depressed, the liftgate must be unlocked
with the power door lock button or the key.
NOTE: The lock lever will be on the right side of the lock
cylinder if your vehicle is equipped with the standard
liftgate glass. The lock lever will be on the left side
of the lock cylinder if your vehicle is equipped with the
optional flip-up liftgate window.
Windows
Power Windows (If equipped)
Each of the front doors has a power control that opens and closes
the window on that door. The driver door has master controls
that operate both front door windows. You must place the ignition
in the ON position to use your power window controls. The
driver's power window controls include a lockout button which
prevents the operation of the passenger side window from
either the passenger or driver side controls.
To open the window, press down on the switch; to close the
window, lift up on the switch.
WARNING
Do not let children play with the power windows.
106

Mirrors
WARNING
Make sure you can see clearly through the rearview mirror
at all times. Do not block your vision. If you cannot see
through the mirror, it could result in a collision, injuring
yourself and others.
Side View Mirrors
Close your door and adjust the driver seat to the most
comfortable position before you adjust the side view mirrors.
If you have manually adjusting side view mirrors, you can adjust
them in any direction by moving the mirror. The mirror heads
can be folded rearward to prevent damage when using an
automatic car wash.
NOTE: Be careful. The convex side view mirror on the right
makes objects appear smaller and farther away than
they actually are. Use the inside rearview mirror (or look
behind you) to determine the actual size and distance
of objects that appear in the convex mirror.
Power quarter window switch
Controls and Features
109