maintenance MINI Clubman 2016 (Mini Connected) User Guide

MaintenanceVehicle features and op‐
tions
This chapter describes all standard, country-
specific and optional features offered with the
series. It also describes features that are not
necessarily available in your car, e. g., due to
the selected options or country versions. This
also applies to safety-related functions and sys‐
tems. The respectively applicable country provi‐
sions must be observed when using the respec‐
tive features and systems.
MINI maintenance system
The maintenance system indicates required
maintenance measures, and thereby provides
support in maintaining road safety and the op‐
erational reliability of the vehicle.
In some cases scopes and intervals may vary
according to the country-specific version. Re‐
placement work, spare parts, fuels and lubri‐
cants and wear materials are calculated sepa‐
rately. Further information is available from a
dealer’s service center or another qualified
service center or repair shop.
Condition Based Service
CBS
Sensors and special algorithms take into ac‐
count the driving conditions of your vehicle.
Based on this, Condition Based Service recog‐
nizes the maintenance requirements.
The system makes it possible to adapt the
amount of maintenance corresponding to your
user profile.
Detailed information on service requirements,
refer to page 85, can be displayed on the Con‐
trol Display.
Service data in the remote control
Information on the required maintenance is
continuously stored in the remote control. The
dealer’s service center can read this data out
and suggest an optimized maintenance scope
for your vehicle.
Therefore, hand the service advisor the remote
control with which the vehicle was driven most
recently.
Storage periods
Storage periods during which the vehicle bat‐
tery was disconnected are not taken into ac‐
count.
If this occurs, have a dealer's service center or
another qualified service center or repair shop
update the time-dependent maintenance pro‐
cedures, such as checking brake fluid and, if
necessary, changing the engine oil and the mi‐
crofilter/activated-charcoal filter.
Service and Warranty In‐
formation Booklet for
US models and Warranty
and Service Guide Book‐
let for Canadian models
Please consult your Service and Warranty Infor‐
mation Booklet for US models and Warranty
and Service Guide Booklet for Canadian models
for additional information on service require‐
ments.
The manufacturer of your vehicle recommends
that maintenance and repair be performed by a
dealer’s service center or another qualified
Seite 201MaintenanceMOBILITY201
Online Edition for Part no. 01 40 2 964 571 - X/15

service center or repair shop. Records of regu‐
lar maintenance and repair work should be re‐
tained.
Socket for OBD Onboard
Diagnosis
Information
CAUTION
The socket for Onboard Diagnosis is an
intricate component intended to be used in
conjunction with specialized equipment to
check the vehicle’s primary emissions system.
Improper use of the socket for Onboard Diag‐
nosis, or contact with the socket for Onboard
Diagnosis for other than its intended purpose,
can cause vehicle malfunctions and creates
risks of personal and property damage. Given
the foregoing, the manufacture of your vehicle
strongly recommends that access to the socket
for Onboard Diagnosis be limited to a dealer's
service center or another qualified service cen‐
ter or repair shop or other persons that have
the specialized training and equipment for pur‐
poses of properly utilizing the socket for On‐
board Diagnosis.◀
Position
There is an OBD socket on the driver's side for
checking the primary components in the vehi‐
cle's emissions.
Emissions▷The warning lamp lights up:
Emissions are deteriorating. Have
the vehicle checked as soon as pos‐
sible.
▷The warning lamp flashes under certain cir‐
cumstances:
This indicates that there is excessive misfir‐
ing in the engine.
Reduce the vehicle speed and have the sys‐
tem checked immediately; otherwise, seri‐
ous engine misfiring within a brief period
can seriously damage emission control
components, in particular the catalytic con‐
verter.
Seite 202MOBILITYMaintenance202
Online Edition for Part no. 01 40 2 964 571 - X/15

site side. For this, place the wheel chock
behind the front wheel diagonally across.
3.Loosen the wheel lug bolts a half turn.
Jacking up the vehicle
1.Place the vehicle jack at the jacking point
closest to the wheel such that the vehicle
jack foot is vertically beneath the vehicle
jacking point with the entire surface on the
ground.
2.Insert the vehicle jack head in the rectan‐
gular recess of the jacking point for crank‐
ing it up.
3.Crank it up until the wheel in question lifts
off of the ground.
Wheel mounting
Mount one emergency wheel only.
1.Unscrew the wheel lug bolts and remove
the wheel.
2.Put the new wheel or emergency wheel on
and screw in at least two bolts.
If non-original MINI light-alloy wheels are
mounted, the accompanying lug bolts may
have to be used as well.
3.Screw in the remaining the lug bolts and
tighten all bolts well in a crosswise pattern.
4.Lower the vehicle and remove the vehicle
jack.
After the wheel change1.Tighten the lug bolts crosswise. The tight‐
ening torque is 101 lb ft/140 Nm.
2.Stow the nonworking wheel in the cargo
area.
The nonworking wheel cannot be stored in
the emergency wheel bracket because of
its size.
3.Check tire inflation pressure at the next op‐
portunity and correct as needed.
4.Reinitialize the Flat Tire Monitor, refer to
page 108.
Reinitialize the Tire Pressure Monitor, refer
to page 105.
5.Check to make sure the lug bolts are tight
with a calibrated torque wrench.
6.Replace the damaged tires as soon as pos‐
sible.
Driving with emergency wheel
WARNING
The emergency wheel has particular di‐
mensions. When driving with an emergency
wheel, changed driving properties may occur at
higher speeds, for example reduced lane stabil‐
ity when braking, longer braking distance and
changed self-steering properties in the limit
area. There is risk of an accident. Drive moder‐
ately and do not exceed a speed of
50 mph/80 km/h.◀
Vehicle battery
Maintenance
The battery is maintenance-free.
The added amount of acid is sufficient for the
service life of the battery.
More information about the battery can be re‐
quested from a dealer’s service center or an‐
other qualified service center or repair shop.
Seite 213Replacing componentsMOBILITY213
Online Edition for Part no. 01 40 2 964 571 - X/15

Interior motion sensor 45
Interior rearview mirror, com‐
pass 148
Internet site 6
Interval display, service re‐
quirements 85
Interval mode 72
J
Jacking points for the vehicle
jack 212
Joystick, Steptronic transmis‐
sion 75
Jump-starting 216
K
Key/remote control 34
Keyless Go, see Comfort Ac‐
cess 41
Key Memory, see Personal
Profile 36
Kickdown, Steptronic trans‐
mission 75
Knee airbag 102
L
Label on recommended
tires 187
Lamp replacement 204
Lamp replacement, front 205
Lamp replacement, rear 207
Lamp replacement, side 211
Language on Control Dis‐
play 92
Lashing eyes, securing
cargo 166
LATCH child restraint sys‐
tem 62
Launch Control 77
Leather, care 222
LED bug light 205
LED headlights 205
LED ring, central instrument
cluster 92
LEDs, light-emitting di‐
odes 204
Letters and numbers, enter‐
ing 25
Light 96
Light-alloy wheels, care 223
Light-emitting diodes,
LEDs 204
Lighter 150
Lighting 96
Lights and bulbs 204
Light switch 96
Load 166
Loading 165
Lock, door 39
Locking/unlocking via door
lock 39
Locking/unlocking with re‐
mote control 37
Locking, automatic 44
Locking, settings 43
Lock, power window 47
Locks, doors, and windows 63
Low beams 96
Low beams, automatic, see
High-beam Assistant 98
Lower back support 52
Lower back support, mechani‐
cal 51
Luggage rack, refer to Roof-
mounted luggage rack 166
Lumbar support 52
Lumbar support, mechani‐
cal 51
M
Maintenance 201
Maintenance require‐
ments 201
Maintenance, service require‐
ments 85
Maintenance system,
MINI 201
Make-up mirror 150
Malfunction displays, see
Check Control 80
Manual air distribu‐
tion 140, 143
Manual air flow 140, 143
Manual brake, see Parking
brake 68
Manual mode, transmis‐
sion 76
Manual operation, door
lock 39
Manual operation, exterior
mirrors 58
Manual operation, fuel filler
flap 178
Manual operation, Park Dis‐
tance Control PDC 130
Manual operation, rearview
camera 132
Manual transmission 74
Manufacturer of the MINI 7
Marking, run-flat tires 188
Master key, see Remote con‐
trol 34
Maximum cooling 142
Maximum speed, display 86
Maximum speed, winter
tires 188
Measurement, units of 92
Medical kit 216
Memory, seat, mirror 56
Menu in instrument cluster 88
Menus, refer to onboard mon‐
itor operating concept 20
Messages, see Check Con‐
trol 80
Microfilter 141, 144
MID - program, driving dy‐
namics 119
MINI Connected, refer to
Integrated Owner's Manual
MINI maintenance sys‐
tem 201
MINIMALISM Analyser 173
MINIMALISM info 172
Seite 240REFERENCEEverything from A to Z240
Online Edition for Part no. 01 40 2 964 571 - X/15