Symbols MITSUBISHI 3000GT 1994 2.G Workshop Manual

Downloaded from www.Manualslib.com manuals search engine 62CIRCUIT DIAGRAMS - How to Read Circuit Diagrams
HOW TO READ CIRCUIT DIAGRAMS
The circuit of each system from the fuse (or fusible link) to ground is shown. The power supply is shown3at the top and the ground at the bottom to facilitate understanding of how the current flows.~
Indicates connector No. The same No. asin the wiring harness diagram is used. Con-
nector numbers enclosed by frame are indi-cated with the connector symbols at the
lower part of the page. Connector numbers
not enclosed by frame are indicated without
connector symbol.connected. The arrow indi-cates the current flow direction.cates the current flow direction.1 [ connected. r arrow indi- [Indicates the circuit name to be
Indicates harness junction point
No. for another system. It corre-Indicates the circuit name to be
Indicates the powersupply in theB
control unit. If no voltage is dis-played, this indicates battery
positive voltage.
An
“X” at the end of a connector
No. indicates that the connectoris connected to a centralized
junction that is shown in the sec-tion “Centralized Junction”.t
Indicates the operating condi-GC
Indicates the connector symbol.
are indicated in numerical order.1
TSB Revision

Downloaded from www.Manualslib.com manuals search engine CIRCUIT DIAGRAMS - How to Read Circuit Diagrams65
Item
No.Connector / GroundingSymbol
ContentsConnector
1Male terminalFor the terminal symbols, the con-and termi-netted terminal is indicated as the
nal markingmale terminal, and the receptacle ter-
minal is indicated as the female termi-
nal as shown in the illustration.
Male connectorThe connector in which the male ter-
minal is assembles is indicated as the
A16R0001male connector and the connector in
which the female is assembled is indi-
- cated as the female connector. TheFemale connector
Female terminalconnector symbols shown the male
T
connector with a double outer contour
line and the female connector with a
Femalesingle outer contour line.
terminal
Female connector
AWR0002
IConnector 2
Device
symbol
marking
:6A~c333
-Connector 3
Direct connection type
connection
marking4
Hams
16A0334
II
The symbol indicates the connector
as viewed from the illustrated
direc-
tion. At the connection with a device,
the connector symbol on the device
side is shown, and for an intermediate
m/ bolisshownconnector, the male connector sym-
For the connectors which are not con-
netted to any appliance (spare termi-
nal, terminal for inspection), the con-nectors at the harness side are
shown.
A connection between a device andconnector on the harness
side is ei-ther by direct insertion in the device
(direct connection type) or by connec-tion with a harness connector fur-
nished on the device side (harness
/ , t ~connection type). The two types are
indicated as illustrated.
5Intermediate connector-
I SA0339
TSB Revision