manual radio set MITSUBISHI 3000GT 1996 2.G Workshop Manual
[x] Cancel search | Manufacturer: MITSUBISHI, Model Year: 1996, Model line: 3000GT, Model: MITSUBISHI 3000GT 1996 2.GPages: 738, PDF Size: 35.06 MB
Page 652 of 738
Downloaded from www.Manualslib.com manuals search engine 54-156
CHASSIS ELECTRICAL - Radio and Tape Player
RADIO AND TAPE PLAYER WITH ANTI-THEFT SYSTEM
lWhen power supply is reconnected after set has been removed from vehicle (after BATT line of sethas been disconnected for more than one hour), what can be effectively performed is only supply
of power made by POWER button operation. (If power supply is connected within an hour, operating
state before disconnection of power supply is resumed.)
IGN key of vehicle is in ACC position and set is in no displaystate.
No displayAbnormal segment op-
*[Faulty
tIs it possible to set identifiNom-Faulty
Yes
Is a beep heard and then does radio operate when PROG button
is placed to ON position after setting four-digit identification numberIs a beep heard and “1 Err” displayed for two seconds before
No
displaying “code”?cFaulty set
No
tCheck if identification number on card is input and set correctly.
Is a beep heard and then does radio operate when PROG button
is placed to ON position after setting four-digit identification numberon card aaain?
Yes-----+ NomxJ (Error made in input during first setting)
I
NoIs a beep heard and “2 Err” displayed for two seconds before
displaying “code”?Faulty set
YesPress POWER button to erase “code” (to change to no display
state).
I
YesContinued to next page.
TSB Revision
Page 653 of 738
Downloaded from www.Manualslib.com manuals search engine CHASSIS ELECTRICAL - Radio-and Tape Player54-I 57
Continued from previous Page
I
Is changeoverto normal operation made by placing POWER buttonto ON position while pressing EJECT button?
YesFaulty set
tIs power supply cut off automatically to return to no display state
after three-minute operation?Faulty set
Does manufacturing numberof set agree with identification number
on card?
YesError in attaching card (For set manufacturing number identificationlocation, refer to
F!54-183)
Yes
Is a beep heard and does radio operate when identification number - Normal (Error in first and second setting)indicated on card is reset and PROG button is placed to ON
position?
No
Is “OFF” displayed after three-minute beeping togetherwith displayof “3 Err”?Faulty set
Yes
t
0In this state, only POWER button operation is accepted (“OFF’is displayed) and no other button opera-
tion can be made effectively.l
In the “OFF” state, continuation of the BAlT, ACC line ON state for more than one hour will allow identi-
fication number checking operation again and placing the POWER button to ON position will display
“code” and wait for input.
1 TSB Revision
Page 664 of 738
Downloaded from www.Manualslib.com manuals search engine 54-168CHASSIS ELECTRICAL - Radio and Tape Player
IA-9Ever-present noise.I
Noise is often created by the following factors, and
often the radio is OK when it is checked individually.l Traveling conditions of the vehicle
l Terrain of area traveled through
l Surrounding buildings
l Signal conditions
l Time periodFor this reason, if there are still problems with noiseeven after the measures described in steps A-l
to A-8 have been taken, get information on the fac-
tors listed above as well as determining whetherthe problem occurs with AM or FM, the station
names, frequencies, etc., and contact a service cen-
ter.B. RADIO
IB-lNo power is supplied when the switch is set to ON.IIIIs multi-purpose fuse No. 4 blown or is the circuit open?Replace fuse or repair harness.
NoIs the connector at the back of the radio connected properly?
Yes
Connect connector securely.1t
NoDisconnect and check the connector at the rear of the radio. Is the ACC / Repair harness.
power (12 V) being supplied to the radio?J
I
Yes
1 Reoair or reolace radio.
1 B-2No sound from one speaker.ICheck to see if there is any sound when attached
to another radio.
I-=----[Repair or replace radio unit.
No
checkthespeakerharnessfor conductance.
out.*Speakarj
NoRepair speaker harness and ensure
proper connection of relay connectors.
tRepair or replace speaker.
1 TSB Revision
Page 668 of 738
Downloaded from www.Manualslib.com manuals search engine 54-172CHASSIS ELECTRICAL - Radio and Tape Player
B-7Too few automatic select stations.
tIs the antenna completely extended?
YesNo1Check theantennaitself.Is the antenna plug properly connected to the equipment?
Yes
Ensure proper connection.Does the equipment work properly if the radio is changed?
Repair or replace radio.
B-8lnsuff icient memory (preset stations are erased).Is multi-purpose fuse No. 19 blown or is the circuit open?
NoReplace fuse or repair harness.
Disconnect and check the connector at the rear of the radio. Is the memory
backup (battery) power beina supplied?Repair harness..-IYes
tRepair or replace radio.
TSB Revision
Page 669 of 738
Downloaded from www.Manualslib.com manuals search engine CHASSIS ELECTRICAL - Radio and Tape Player54-173C. CASSETTE PLAYER
C-lCassette tape will not be inserted.Are there any foreign objects in the cassette player?/NoRemove the object(s)”
“1Attempting to force a foreign object (e g.. a coin or clip, etc.) out
of the cassette player may damage the mechanism. The player
should be taken to a service dealer for repair.
Does the cassette player work if another tape is inserted?
NoReplace tape
**
*2Ensure that the tape label is not that the tape itself tape of C-120
or greater length often get caught in the mechanism and should
not be used.
Repair or replace cassette player.
C-2No sound (even after a tape has been inserted).Is multi-purpose fuse No. 4 blown or is the circuit open?
NoYes
- Replace fuse or repair harness.
+Is connector at rear of radio connected tightly?
YesNo
- Connect connector firmly.
Disconnect connector at rear of radio. Is ACC power being supplied to the
yesPW Repair or replace caSSette player.
radio?
1 TSB Revision
Page 670 of 738
Downloaded from www.Manualslib.com manuals search engine 54-174
CHASSIS ELECTRICAL - Radio and Tape Player
C-3No sound from one speaker.t
YesReplace the cassette player and check again.
NoRepair or replace cassette player.
thespeaker harness for conductance.___c It conducts electricity but isshorted out.
+Check the speaker for conductance.
NoRepair speaker harness and ensureproper connection of relay connectors.
tRepair or replace speaker.
TSB Revision
Page 671 of 738
Downloaded from www.Manualslib.com manuals search engine CHASSIS ELECTRICAL - Radio and Tape Player54-175c-4
Sound quality is poor, or sound is weak.
Yes
,/lEnsure that the tape label is not loose, that the tape itself is not
deformed and that the tape is tightly wound.
l
Tapes of C-i 20 or greater length often get caught in the mechanismand should not be used.
Yes
No
ccl
tIs proper operation obtained when thecaYes/No
1 Repair or replace speaker.1c-5
Cassette tape will not be ejected.
The problems covered here are all the result of the use of a bad tape (deformed or not properly tightened)
or of a malfunction of the cassette player itself. Malfunctions involving the tape becoming caught in themechanism and ruining the case are also possible, and attempting to force the tape out of the player
can cause damage to the mechanism. The player should be taken to a service dealer for repair.
1 TSB Revision1
Page 672 of 738
Downloaded from www.Manualslib.com manuals search engine 54-176CHASSIS ELECTRICAL - Radio and Tape Player
C-6Uneven revolution. Tape speed is fast or slow.
NoYesAre there any foreign objects inside the cassette player?
Remove foreign object(s).
No
Is the head or capstan roller dirty?
I-
Z16AO668
No
j Reoair or replace cassette olaver.
Yes
C-7Automatic search does not work.IDoes the MSS (automatic search) button” depress properly?
YesButton improperly operated.
1Yesc Tape used is bad.
Nol l
lWhen the time between songs on a tape is less than three seconds,or when there is a three second period in the middle of a song in
which the volume level is extremely low, the automatic search function
*2may not work properly.
lEnsure that the tape label is not loose, that the tape itself is not deformedand that the tape is tightly wound. Also, tapes of C-120 or greater
length often get caught in the mechanism and should not be used.
t1 Repair or replace the cassette player.
1 TSB Revision
Page 673 of 738
Downloaded from www.Manualslib.com manuals search engine CHASSIS ELECTRICAL - Radio and Tape Player54-177
C-8Faulty auto reverse.
-1 Yes
Does the player play OK if the tape is changed?I*mNo
lEnsure that the tape label is not loose, that the tape itself is not deformedand that the tape is tightly wound.
l Tapes of C-120 or greater length often get caught in the mechanism
and should not be used.
1No
,1
Yes
+vreplaceIs the cassette player properly installed to the vehicle?,
No
Yes*/I
1Repair or replace cassette player.
C-9Tape gets caught in mechanism*‘.I
l lWhen the tape is caught in the mechanism, the case may not eject. When this occurs,
do not try to force the tape out as this may damage the tape player mechanism. Take
the cassette to a service dealer for repair.
Does the player play OK if the tape’2 is changed?
No
l 2Tape used is bad.
Ensure that the tape label is not loose, that the tape itself is not deformedand that the tape is tightly wound. Also, tapes of C-120 or greater length
often get caught in the mechanism and should not be used.
Repair or replace cassette player.
i
1 TSB Revision
Page 675 of 738
Downloaded from www.Manualslib.com manuals search engine CHASSIS ELECTRICAL - Radio and Tape Player54-179/
L
D-2No sound.1I
Does it play if an existing proper CD is inserted? )Yes-Replace defective CD.
No
No
FYes
ture, and recheck operation.*IDoes it operate properly?
II NoAre the radio set and CD player connected
C;_TRepair or replace CD player.
-(The combined radio cassette must operate
properly.)
D-3CD sound skips.
1.Sound sometimes skips during parking.
iIs CD face scratched or dirty?CD is defective, or clean CD.
NoDoes it play properly if CD is replaced with an existing proper CD?
Yes
Repair or replace CD player..
1 Replace CD.
2.Sound sometimes skips during driving.(Stop vehicle, and check it.)
(Check it by using a proper CD which is free of scratch, dirt or other abnormality.)
Does sound skip when the side of
YesNo
tSecurely mount the CD player.
ITSB Revision