ground clearance MITSUBISHI ASX 2014 Owner's Manual (in English)

CAUTIONlUpon installation of the
T155/90D16 or
T125/90D16 size spare wheel, the ground
clearance is reduced as the tyre is smaller in
diameter than the standard tyre.
When passing over the projections on the
road, take care not to damage the vehicle’s
undercarriage.
l Do not install more than one temporary
spare wheel at the same time.To remove the spare wheel
E00803301130
1. Lift up the luggage floor board.
2. To remove the spare wheel, remove the
installation clamp (A) by turning it anti-
clockwise.NOTEl Put the spare wheel under the vehicle body
near the jack. This makes it safer if the jack slips out of position.To change a tyre
E00803200653
1. If a wheel cover is installed, first remove
the cover. (Refer to “Wheel covers”.)
Then loosen the wheel nuts a quarter
turn with the wheel nut wrench. Do not remove the wheel nuts yet.
2. Place the jack under one of the jacking
points (A) shown in the illustration. Use
the jacking point closest to the tyre you wish to change.
How to change a tyre
8-15
OGAE14E1For emergencies8

Vehicle dimensionsE011002040381Front track1,525 mm2Overall width1,770 mm3Front overhang870 mm4Wheel base2,670 mm5Rear overhang755 mm6Overall length4,295 mm7Ground clearance (unladen)Petrol-powered vehicles180 mm, 195 mm*1Diesel-powered vehicles180 mm*1
: Vehicles for Russia, Kazakhstan and Ukraine
Vehicle dimensions
11-05
OGAE14E1Specifications11