roof MITSUBISHI CARISMA 2000 1.G User Guide

SEATS AND SEATBELTS
3–29
G28L087d
The front air bags ARE DESIGNED NOT TO DEPLOY when...
The front air bags are designed not to deploy
in conditions where they cannot typically pro-
vide protection to the occupant.
Such conditions are shown in the illustration:1-Rear end collisions
2-Side collisions
3-Vehicle rolls onto its side or roofBecause the front air bags do not protect the
occupant in al types of frontal collisions, be
sure to always properly wear your seat belts.

SEATS AND SEATBELTS
3–33
G28L089d
The side air bags MAY NOT DEPLOY when...
With certain types of side collisions, the ve-
hicle’s body structure is designed to absorb
the shock to help protect the occupants from
harm. (The vehicle body’s side area may de-
form significantly as it absorbs the impact.)
Under such circumstances, the side air bags
may not deploy irrespective of the deforma-
tion and damage to the vehicle body.
Examples of some typical conditions are
shown in the illustration:1-Side impacts in an area away from the
passenger compartment
2-Motorcycle or other similar small ve-
hicle collides with the side of the ve-
hicle
3-Collision with a utility pole, tree or
other narrow object
4-Oblique side impacts
5-Vehicle rolls onto its side or roofBecause the side air bags do not protect the
occupant in all types of side collisions, be
sure to always properly wear your seat belts.

INSTRUMENTS AND CONTROLS
4–22
E23A001a
Horn switchEE23A-Ac
When the ignition switch is in the “ON” or
“ACC” position, pressing the “” mark on
the steering wheel, causes the horn to
sound.
E19A134a
Room lampsEE19AAZ
Vehicles without sunroof
Room lamp1(OFF)
-The lamp goes out.
2()
-The lamp illuminates when a
door or the tailgate is opened
and goes out when it is closed.
3(ON)
-The lamp illuminates.
F19A037a
Spot lamps*4 - The lamp goes out.
5 - The lamp illuminates.

INSTRUMENTS AND CONTROLS
4–23
F19A038a
Vehicles with sunroof
Room lamp
1(OFF)
-The lamp goes out.
2()
-The lamp illuminates when a
door or the tailgate is opened
and goes out when it is closed.
3(ON)
-The lamp illuminates.
F19A039a
Spot lamps4 - The lamp goes out.
5 - The lamp illuminates.
NOTE
If you leave the lamps on without running the
engine, you will run down the battery. Before
you leave the vehicle, make sure that all the
lamps are switched off.

STARTING AND DRIVING
5–7
(3)City traffic
Frequent starting and stopping in-
creases the average fuel consumption.
Use roads with smooth traffic flow
whenever possible. When driving on
congested roads, avoid use of a low
gear at high engine speeds.
(4) Idling
The vehicle consumes fuel even during
idling. Avoid extended idling whenever
possible.
(5)Speed
The higher the vehicle speed, the more
fuel consumed. Avoid driving at full
speed. Even a slight release of the ac-
celerator pedal will save a significant
amount of fuel.
(6)Tyre inflation pressure
Check the tyre inflation pressures at
regular intervals. Low tyre inflation pres-
sure increases road resistance and fuel
consumption. In addition, low tyre pres-
sures adversely affect tyre wear and
driving stability.(7)Load
Do not drive with unnecessary articles in
the luggage compartment. Especially
during city driving where frequent start-
ing and stopping is necessary, the in-
creased weight of the vehicle will greatly
affect fuel consumption. Also avoid driv-
ing with unnecessary luggage, etc., on
the roof; the increased air resistance will
increase fuel consumption.
(8)Cold engine starting
Starting of a cold engine consumes
more fuel.
Unnecessary fuel consumption is also
caused by keeping a hot engine run-
ning. After the engine is started, com-
mence driving as soon as possible.
(9)Air conditioning*
The use of the air conditioning will in-
crease the fuel consumption.Trailer towingEC21AMFg
In order to tow a trailer with your vehicle, a
trailer towing device that meets all relevant
regulations in your area has to be mounted.
The regulations concerning the towing of a
trailer may differ from country to country. You
are advised to obey the regulations in each
area.
CAUTION
Danger of accident!
A towing bar should be fitted by an
authorized MITSUBISHI dealer.

For pleasant driving
UKW/MW/LW electronic tuning radio with
tape player* 6–2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
UKW/MW/LW electronic tuning radio with
CD player* 6–15. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Audio system anti-theft feature 6–26. . . . . . . . . . . .
Roof antenna 6–29. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Ventilators 6–29. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Heater/Manual air conditioning* 6–30. . . . . . . . . . . .
Automatic air conditioning* 6–36. . . . . . . . . . . . . . .
Sun visors 6–44. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Vanity mirror 6–45. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Cigarette lighter 6–45. . . . . . . . . . . . . . . . . . . . . . . . . .
Ashtray 6–46. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Accessory boxes 6–47. . . . . . . . . . . . . . . . . . . . . . . .
Sunglasses pocket 6–48. . . . . . . . . . . . . . . . . . . . . . .
Rear shelf panel (Hatchback) 6–49. . . . . . . . . . . . . .
Installation position for first–aid kit 6–50. . . . . . . . .
Cargo net* 6–51. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

FOR PLEASANT DRIVING
6–29
H11D094a
Roof antennaEH11DAJa
To remove the roof antenna, turn it counter-
clockwise.
CAUTION
Be sure to remove the roof antenna
before entering an automatic car
wash or other low-roofed area.
NOTE
Be sure to remove the antenna in the follow-
ing cases:

When entering a place with low clear-
ance.

When going into an automatic car wash.

When placing a car cover over the ve-
hicle.
H16A357a
VentilatorsEH16AASc
1-Centre ventilators
2-Side ventilators
Centre
H16A180a
Air flow and direction
adjustments
3-Ventilator dial
4-Knob
– Open
– Close

VEHICLE CARE
7–4
WashingEK22ACCb
Chemicals contained in the dirt and dust
picked up from the road surface can damage
the paint coat and body of your vehicle if left
in prolonged contact.
Frequent washing and waxing is the best
way to protect your vehicle from this dam-
age. This will also be effective in protecting
it from environmental elements such as rain,
snow, salt air, etc.
Do not wash the vehicle in direct sunlight.
Park the vehicle in the shade and spray it
with water to remove dust. Next, using an
ample amount of clean water and a car
washing brush or sponge, wash the vehicle
from top to bottom.
Use a mild car washing soap if necessary.
Rinse thoroughly and wipe dry with a soft
cloth. After washing the vehicle, carfully
clean the joints and flanges of the doors,
bonnet, etc., where dirt is likely to remain.
CAUTION
(1) When washing the under side of
your vehicle or wheel, wear a pair
of rubber gloves.
CAUTION
(2) Refrain from using a car wash as
its brushes may scratch the paint
surface, causing it to lose its
gloss.
Scratches will be especially vis-
ible on darker coloured vehicles.
(3) Never spray or splash water on
the electrical components in the
engine compartment, as this may
adversely affect engine starting.
Exercise caution also when
washing the underbody; be care-
ful not to spray water into the en-
gine compartment.
(4) Some types of hot water washing
equipment apply high pressure
and heat to the vehicle. They may
cause heat distortion and damage
to the vehicle resin parts and may
result in flooding of the vehicle in-
terior. Therefore; observe the fol-
lowing.

Maintain a good distance of ap-
prox. 40 cm or more between
the vehicle body and the wash-
ing nozzle.
CAUTION

When washing around the door
glass, hold the nozzle at a dis-
tance of more than 50 cm and
at right angles to the glass sur-
face.
(5) Using an automatic car wash, pay
attention to the following items, re-
fering to the operation manual or
consulting a car wash operator. If
the followings are not followed, it
could result in damage to your ve-
hicle.

The outside mirrors are re-
tracted.

The roof antenna is removed.

If your vehicle is equipped
with the rear wiper, tape or re-
move it.

VEHICLE CARE
7–5
During cold weatherThe salt and other chemicals spread on the
roads in some areas in winter can have a
harmful effect on the vehicle body. You
should therefore wash the vehicle as often
as possible in accordance with our care–in-
structions. It is recommended to have a pre-
servative applied and the underfloor protec-
tion checked at an authorized MITSUBISHI
dealer before and after the cold weather sea-
son.
After washing your vehicle, wipe off all water-
drops from the rubber parts around the doors
to prevent the doors from freezing.
NOTE
To prevent freezing of the weatherstripping
on the doors, bonnet, etc., they should be
treated with silicone spray.
WaxingEK33A-N
Waxing the vehicle will help prevent the ad-
herence of dust and road chemicals to the
paintwork. Apply a wax solution after wash-
ing the vehicle, or at least once every three
months to assist displacing of water. Do not
wax your vehicle in direct sunlight. You
should wax after the surfaces have cooled.
CAUTION
(1) Waxes containing high abrasive
compounds should not be used.
Such waxes remove rust and
stain effectively from the paint-
work but they are harmful to the
lustre of the painted surface.
Further, they are harmful to
glossy surfaces such as grille,
garnish, mouldings, etc.
(2) Do not use petrol or paint
thinners to remove road tar or
other contamination to the
painted surface.
(3) Do not apply wax on the areas
having black mat coating as it can
cause uneven discolouration,
patches, blurs, etc. If stained with
wax, immediately wipe off with a
piece of soft cloth and warm
water.
(4) On vehicles with the sunroof, be
careful when waxing the area
around the sunroof opening, not
to put any wax on the weather-
strip (black rubber). If stained
with wax, the weatherstrip cannot
maintain a weatherproof seal with
the sunroof.
PolishingEK04A-Ac
The vehicle should only be polished if the
paintwork has become stained or lost its
lustre. Matt - finish parts and plastic bumpers
must not be polished, polishing these parts
will stain them or damage their finish.
Damaged paintEK08A-Ac
Small cracks and scratches in the paint coat
should be touched up as soon as possible
with MITSUBISHI touch - up paint to prevent
corrosion.
Check body areas facing the road or the
tyres carefully for damage to the paint coat
caused by flying stones, etc. The paint code
number for your vehicle can be found on the
vehicle information code plate in the engine
compartment.
Chrome partsEK06A-Aa
In order to prevent spots and corrosion of
chrome parts, wash with water, dry thor-
oughly, and apply a special protective coat-
ing. This should be done more frequently in
winter.

VEHICLE CARE
7–7
Cleaning the sunroof*EK30A-Ab
Clean the inside of the sunroof with a soft
cloth. Hard deposits should be wiped away
with a cloth dipped in warm, neutral deter-
gent solution. Wipe away the solution with a
sponge dipped in fresh water.
NOTEThe surface treatment on the inside of the
glass may be removed if hard cloth or or-
ganic solvent (benzine, thinner, etc.) is used.
Chassis and underbody protec-
tion
EK12A-Jc
Your vehicle’s underbody has been treated
at the factory in order to protect it from rust
and corrosion. Some areas have been in-
jected with anti-corrosion agents and wax.
The effectiveness of these measures, how-
ever, will be reduced by flying stones, road
chemicals, etc., as the vehicle is driven. You
should take your vehicle to your authorized
MITSUBISHI dealer every 12 months to
have body sheet metal inspected for condi-
tion, and it is recommended to have the un-
derbody checked regularly (autumn and
spring) and have additional protection treat-
ment carried out as required.
As not all of the commercially available ma-
terials are suitable for use on your vehicle, it
is recommended that you have this work
carried out by an authorized MITSUBISHI
dealer.
When washing the vehicle, especially in
winter, spray the underbody with water to re-
move dirt and dust which might contain salts,
road chemicals, etc.
Engine compartmentEK13A-Aa
Clean the engine compartment at the begin-
ning and end of winter. Pay particular atten-
tion to flanges, crevices and peripheral parts
where dust containing road chemicals and
other corrosive materials might collect.
If salt and other chemicals are used on the
roads in your area, clean the engine com-
partment at least once every three months.