mirror MITSUBISHI ENDEAVOR 2004 Service Repair Manual

2004 BODY & ACCESSORIES
Door Mirror - Endeavor
GENERAL DESCRIPTION REMOTE CONTROLLED MIRROR OPERATION
The mirror glass on the remote controlled mirror moves up/down and left/right
by operating the remote controlled door mirror switch when the ignition switch
is in the "ON" or "ACC" position.
DOOR MIRROR HEATER OPERATION
The defogger relay switch is activated (ON) by turning on the A/C-ECU built-
in defogger switch when the ignition switch is in the "ON" position. When the
defogger relay is turned ON, power is supplied to the defogger and remote
controlled mirror, and the heater of the remote controlled mirror (heated door
mirror) starts operations. The defogger comes with a timer function and will
automatically turn OFF the switch approximately 11 minutes after the defogger
switch is turned ON. The door mirror heater operations are also terminated
along with the defogger, at this time.
HEATED DOOR MIRROR DIAGNOSIS TROUBLESHOOTING STRATEGY Diagnosis should be carried out by the following procedures.
1. Gather the information from the customer.
2. Verify that the condition described by the customer exists.
3. Find the malfunction by the following Symptom Chart.
4. Verify the malfunction is eliminated. TROUBLE SYMPTOM CHART TROUBLE SYMPTOM REFERENCE SYMPTOMS
INSPECTION
PROCEDURE
REFERENCE PAGE

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door Mirror - Endeavor


2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door Mirror - Endeavor

SYMPTOM PROCEDURES INSPECTION PROCEDURE 1: All Heated Door Mirrors do not Operate Heated door mirror circuit All heated door mirrors
do not operate
1
INSPECTION PROCEDURE 1: All Heated Door Mirrors do not
Operate
The right or left heated
door mirror does not
operate
2
INSPECTION PROCEDURE 2:
Right or Left Heated Door Mirror does not Operate

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door Mirror - Endeavor

Fig. 1: Heated Door Mirror Circuit Diagram & Connector Identification

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
CIRCUIT OPERATION
2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door Mirror - Endeavor

If both of the door mirror heaters do not operate normally it may be due to a
malfunction in the defogger system. TROUBLESHOOTING HINTS
Malfunction of the defogger system The wiring harness or connectors may have loose, corroded, or damaged
terminals, or terminals pushed back in the connector.
DIAGNOSIS Required Special Tools:
MB991223: Test Harness Set
STEP 1. Check the rear window defogger.
Check that the rear window defogger works normally as follows.
1. Turn the ignition switch to the "ON" position.
2. Push the rear window defogger switch to operate the rear window
defogger.
Q: Does the defogger work normally?
YES: Go to Step 2.
NO: Because malfunction of the rear window defogger, carry out the
troubleshooting (Refer to MANUAL A/C DIAGNOSIS
).
STEP 2. Check joint connector (2) C-104 and junction block connector C-
211 for loose, corroded or dama
ged terminals, or terminals
pushed back in
the connector
.

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door Mirror - Endeavor

Fig. 2: Identifying Connector C
- 104

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door Mirror - Endeavor

Fig. 3: Identifying Connector C
- 211

Courtes
y of MITSUBISHI MOTOR SALES OF AMERICA
.

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door Mirror - Endeavor

Q: Are joint connector (2) C-104 and junction block connector C-211 in
good condition?
YES: Go to Step 3.
NO: Repair or replace the damaged connector(s).
P.00E-2. Check if the all heated door mirrors works normally.
STEP 3. Check the wiring harness between joint connector (2) C-104
(terminal 25) and junction block connector C-211 (terminal 3).
Fig. 4: Identifying Connector C
- 104

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door Mirror - Endeavor

Fig. 5: Identifying Connector C
- 211

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Q: Is the wirin
g harness between
joint connector
(2) C-104
(terminal 25
)

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door Mirror - Endeavor

and junction block connector C-211 (terminal 3) in good condition?
YES: Go to Step 4.
NO: Repair the wiring harness as necessary. Check if the all heated door
mirrors works normally.
STEP 4. Check remote controlled mirror (LH) connector E-14.
Fig. 6: Identifying Connector E
- 14

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Q: Is remote controlled mirror (LH) connector E-14 in good condition?

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door Mirror - Endeavor

YES: Go to Step 5.
NO: Repair or replace the damaged connector. Check if the all heated
door mirrors works normally.
STEP 5. Check the wiring harness between joint connector (2) C-104
(terminal 23) and remote controlled mirror (LH) E-14 (terminal 1).
Fig. 7: Identifying Connector C
- 104

Courtes
y of MITSUBISHI MOTOR SALES OF AMERICA
.

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door Mirror - Endeavor