rear wiper MITSUBISHI ENDEAVOR 2004 Service Repair Manual

MOTORS MOTORS LOCATION SENDING UNITS & SENSORS SENDING UNITS & SENSORS LOCATION
4 .
Power Window Main Switch CPU
Integral to power window main switch.
See Fig. 15
.
SRS ECU
Under front of center console.Fig. 14
.
Sunroof ECU
At front of sunroof opening.Fig. 13
.
Component
Location
Door Lock Actuator (Left Front) (E-
20)
Rear of left front door.Fig. 77
.
Door Lock Actuator (Left Rear) (E-13)
Rear of left rear door.Fig. 77
.
Door Lock Actuator (Right Front) (E-
03)
Rear of right front door.Fig. 77
.
Door Lock Actuator (Right Rear) (E-
07)
Rear of right rear door.Fig. 77
.
Fuel Pump Module
In top of fuel tank.Fig. 64
.
Liftgate Actuator (F-11)
Lower center of liftgate. See Fig. 88
.
Power Steering Oil Pump
Lower right side of engine
compartment. See Fig. 36
.
Rear Blower Motor (C-20)
Rear of center console.Fig. 76
.
Rear Washer Motor (A-26)
In washer tank assembly.Fig. 79
.
Sunroof Motor Assembly
Right front of roof. See Fig. 62
.
Windshield Washer Motor (A-27)
In washer tank assembly.Fig. 79
.
Windshield Wiper Motor (A-03)
On left side of firewall.Fig. 79
.
Component
Location
ABS G Sensor Or G & Yaw Rate
Sensor
Under center console. See Fig. 67
.
Acceleration Pedal Position
Above accelerator pedal.Fig. 59
.

2004 Mitsubishi Endeavor LS
2004 MITSUBISHI Endeavor

Summary: this bulletin contains repair procedures for possible conditions which may
cause water leakage into the vehicle's spare tire well, resulting in a musty smell. *tt

2004 Mitsubishi ENDEAVOR 04 - Air conditioner > EQUIPMENT : ELECTRICAL :
AIR CONDITIONER [Part 353600 ]
TSB No: 0355010 NHTSA ID: , October 01, 2003 : Replacement:
Summary: air conditioner expansion valve whooping noise coming from the passenger
side of the instrument panel which occurs during normal air conditioning operation. *tt

2004 Mitsubishi ENDEAVOR 04 - Side Rear Glass > VISIBILITY : GLASS,
SIDE/REAR [Part 132000 ]
TSB No: 0342A003 NHTSA ID: , September 01, 2003 : Replacement:
Summary: front door glass coming loose from regulator. *tt

2004 Mitsubishi ENDEAVOR 04 - Power Window > VISIBILITY : POWER
WINDOW DEVICES AND CONTROLS [Part 133000 ]
TSB No: 0342A001 NHTSA ID: , August 13, 2003 : Replacement:
Summary: front door glass coming loose from regulator. *tt

2004 Mitsubishi ENDEAVOR 04 - Differential Unit > POWER TRAIN : DRIVELINE
: DIFFERENTIAL UNIT [Part 105500 ]
TSB No: 94 NHTSA ID: , June 01, 2003 : Replacement:
Summary: rear differential noise. *tt

2004 Mitsubishi ENDEAVOR 04 - Bumper > STRUCTURE : BODY : BUMPERS
[Part 162200 ]
TSB No: 94 NHTSA ID: , June 01, 2003 : Replacement:
Summary: rear bumper poor fit. *tt

2004 Mitsubishi ENDEAVOR 04 - Windshield Wiper Washer > VISIBILITY :
WINDSHIELD WIPER/WASHER [Part 136000 ]
TSB No: 94 NHTSA ID: , June 01, 2003 : Replacement:
Summary: windshield washer spray. *tt

2004 BODY & ACCESSORIES
Rear Wiper And Washer - Endeavor
GENERAL DESCRIPTION REAR WIPER OPERATION
If the rear wiper and washer switch is turned to the "INT" position with the
ignition switch at "ACC" or "ON" position, the ETACS-ECU turns ON the rear
wiper drive signal for three seconds (approximately two cycles), then 7.4
seconds later the intermittent motion operates every eight seconds. If the
selector lever is moved to the "R" position when the rear wiper and washer
switch is turned to the "INT" position and the ignition switch is at the "ACC"
or "ON" position, the park/neutral position switch "R" turns ON. One second
later, the ETACS-ECU turns ON the rear wiper drive signal for three seconds
(approximately two cycles). Then, 7.4 seconds later, the intermittent operation
(eight second cycles) is restored.
REAR WASHER OPERATION
If the rear wiper and washer switch is turned to the ON (washer) position with
the ignition switch at the "ACC" or "ON" position, the rear washer ON signal
is sent to the ETACS-ECU, causing the rear wiper signal to turn on after 0.3
seconds. After the rear washer switch signal turns off, the rear wiper signal
turns off in three seconds. If the rear washer switch is turned to the ON
position while the rear wiper is in intermittent mode, the rear washer works for
that period when the washer switch remains on. Then the rear wiper returns to
the intermittent mode.
REAR WIPER AND WASHER DIAGNOSIS The rear wiper and washer are controlled by the Simplified Wiring System (SWS).
For troubleshooting, refer to SWS DIAGNOSIS
.
ON-VEHICLE SERVICE CHECK OF REAR WIPER OPERATION WHEN SELECTOR LEVER IS AT THE "R" POSITION
2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Rear Wiper And Washer - Endeavor


2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Rear Wiper And Washer - Endeavor

1. When the selector lever is moved to the "R" position with the rear wiper switch
at the "INT" position, the wiper should operate twice or three times at low
speed after approximately one second.
2. If not, troubleshoot (Refer to SWS DIAGNOSIS
).
REAR WIPER MOTOR CHECK Inspect the rear wiper motor by removing the harness connector with the motor still
installed in the vehicle. WIPER MOTOR OPERATION 1. Remove the motor cover (Refer to REAR WIPER AND WASHER
).
2. Connect the rear wiper motor connector terminal num
ber 1 to the ground.

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Rear Wiper And Washer - Endeavor

Fig. 1: Connecting Rear Wiper Motor Connector Terminal Number 1 To Ground

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
3. Check to see that the rear wiper motor run, when connecting the positive

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Rear Wiper And Washer - Endeavor

battery terminal to rear wiper motor connector terminal number 3.
Fig. 2: Checking For Rear Wiper Motor Run

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Rear Wiper And Washer - Endeavor

4. Disconnect the positive battery terminal to rear wiper motor connector terminal
number 3, when the rear wiper motor running.
5. Check to see that the rear wiper motor stops.
2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Rear Wiper And Washer - Endeavor

Fig. 3: Checking Rear Wiper Motor Stop
s
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
WIPER MOTOR AT STOP POSITION OPERATION 1. Remove the motor cover (Refer to REAR WIPER AND WASHER
).
2. Connect the rear wi
per motor connector terminal num
ber 1 to the
ground.

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Rear Wiper And Washer - Endeavor

Fig. 4: Connecting Rear Wiper Motor Connector Terminal Number 1 To Ground

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
3. Connect the rear wiper motor connector terminal num
ber 3 to 4.

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Rear Wiper And Washer - Endeavor

Fig. 5: Connecting Rear Wiper Motor Connector Terminal Number 3 To 4
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
4. Connect the
positive batter
y terminal to rear wi
per motor connector terminal

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Rear Wiper And Washer - Endeavor