warning MITSUBISHI ENDEAVOR 2011 1.G MMCS Manual

WARNING
If this MMCS is used for a long time in a location
with poor ventilation, such as indoors or in a
garage, the area could fi ll with exhaust gas and
have a negative effect on health.
CAUTION
• Drive according to the actual traffi c conditions.
This MMCS gives guidance to arrive at the
destination, but it cannot warn the driver of
sudden dangers or potential damage.
• The route guidance of this MMCS may
sometimes differ from the actual road
conditions. Drive safely in accordance with the
new road conditions or regulations.
• Performing complicated operations while driving
can cause an accident by distracting the driver
from conditions in front of the vehicle. Be sure to
park in a safe location before operating.
• Do not look at the screen for a long time while
driving, as it can cause an accident.NOTE • Do not disassemble or modify this MMCS, as it
can cause a malfunction.
• Do not use for a long time while the engine is off.
Introduction
Thank you for buying a Mitsubishi Motors
product.
This Owner’s Manual will add to your
understanding and full enjoyment of the
many fine features of the Mitsubishi Multi
Communication System (MMCS).
Throughout this manual the words WARNING
and CAUTION appear.
These are reminders to be especially careful.
Failure to follow the instructions could result in
personal injury or damage to your vehicle.
WARNING
Indicates a strong possibility of severe personal
injury or death if instructions are not followed.
CAUTION
Points out hazards or unsafe practices that
could cause minor personal injury or damage to
your vehicle.
You will see another important symbol:NOTE
:Gives helpful information.
© 2007 Mitsubishi Motors Corporation Printed in U.S.A.

NOTE  If an abnormality (e.g., water or foreign matter
enters the MMCS or the MMCS emits smoke
or an abnormal smell) occurs, do not use the
MMCS. Have it inspected at an authorized
Mitsubishi dealer. Do not continue to use the
MMCS or try to repair it yourself.
 The following are characteristics of the LCD and
are not malfunctions:
- Small black spots or bright spots (red, blue, or
green) on the screen.
- When it is cold, screen becomes darker or
reddish or operations become slower.
- Color and brightness vary according to the
viewing angle.
 Use a clean soft cloth to wipe off any dirt from
the screen. Do not use any cleaners (such as
benzene, thinners, antistatic agents or chemical
cloths), as they may damage the screen.
 Do not use the MMCS for an extended time
while the engine is off.
Usage PrecautionsWARNING
 Do not operate the Mitsubishi Multi
Communication System (MMCS) while driving.
 Always concentrate on your driving rst. Keep
your eyes and mind on the road. If distracted
while driving, you could cause an accident.
 When operating the MMCS, do not park with the
engine running in a closed or poorly ventilated
area. Carbon monoxide gas, which is odorless
and extremely poisonous, can build up and
cause serious injury or death.
CAUTION
 Drive according to the actual traf c conditions.
This MMCS gives guidance to arrive at the
destination, but it cannot warn the driver of
sudden dangers or potential damage.
 The route guidance of this MMCS may
sometimes differ from the actual road
conditions. Drive safely in accordance with the
new road conditions or regulations.
 Do not disassemble or modify, as it could cause
malfunctions, smoke emissions or re.

Setup 2-18Windshield WipersSettings related to the windshield wipers can be
performed.
eng_331
Speed-sensitive Operation
[On]
The speed of the windshield wipers
changes according to the vehicle
speed.
[Off]
The speed of the windshield wipers
does not change according to the
vehicle speed.
Rear Wiper
Intermittent
Interval[2sec]: The interval is 2 seconds.
[4sec]: The interval is 4 seconds.
[8sec]: The interval is 8 seconds.
[16sec]: The interval is 16 seconds.
Continuous
Operation[On]: The windshield wipers
operate continuously.
[Off]: The windshield wipers do not
operate continuously.
Exterior Lights / Interior LightsSettings related to the exterior lights/interior lights
can be performed.
eng_329
Headlight Auto-cutout Function
[On] Turns off the headlights automatically.
[Off]
Does not turn off the headlights automatically.
Headlight On Condition
[Before
Ignition Off]Goes off when the ignition switch is
turned OFF.
[Anytime]Stays on even when the ignition
switch is turned OFF.Interior Light Auto-cutout Time
[3 min] Goes off after 3 minutes.
[30 min] Goes off after 30 minutes.
[60 min] Goes off after 60 minutes.
[Not-
operated]Does not go off automatically.Duration Dome Light Remains On after Door is Closed[180 sec] Goes off after 180 seconds.
[120 sec] Goes off after 120 seconds.
[60 sec] Goes off after 60 seconds.
[30 sec] Goes off after 30 seconds.
[15 sec] Goes off after 15 seconds.
[0 sec] Goes off when the door is closed.
Door-ajar Warning / Turn SignalSettings related to the door-ajar warning/turn signal
can be performed.
eng_327
Door - ajar Warning Chime
[On] Warning chimes when the door is ajar.
[Off] Warning does not chime when the door
is ajar.Turn Signal Audible
[On] The turn signal sound is on.
[Off] The turn signal sound is off.

Displaying the Navi Screen 3-1
Basic Operation
Basic Operation
Displaying the Navi Screen
This section explains how to start and exit
the navi from the Main Menu.
WARNING
 Do not operate the Mitsubishi Multi Communication
System (MMCS) while driving. Always concentrate on your driving rst. Keep your

eyes and mind on the road. If distracted while
driving, you could cause an accident.
 When operating the MMCS, do not park with the
engine running in a closed or poorly ventilated
area. Carbon monoxide gas, which is odorless
and extremely poisonous, can build up and cause
serious injury or death.
Starting the Navi
1 Turn “ON” the ignition switch
NOTE
 If the navi function was being used when the
engine was previously turned off, go to step 4. 2 Display the Main Menu
3 Touch [Navi]
eng_507
4 Touch the desired language
eng_172a
Read the display carefully. If you agree with the
statement, touch [OK]. 5 Touch [OK]
The current location screen is displayed.
Returning to the Main Menu
This section explains how to return to
the Main Menu.
1 Display the current location
screen.
2 Touch [Main]
eng_001

eng_507
The main menu is displayed.