light MITSUBISHI GALANT 2005 Service Repair Manual

ON
ACC
LOCK (OFF)
Key removed
ON (Any door is open)
OFF (All doors are closed)
LOCK
OFF
UNLOCK
100
65
0
t1: 30 seconds
t2: 15 secondst1 t1 t2 Ignition switch
Door switch
Keyless entry system
door lock or unlock signal
Interior light intensity
<

T1 T2 T2 ON
ON (Any door is open)
IlluminatedACC
OFF
Extinguished Ignition switch
Door switch
Interior lightON
DOOR Dome light switch
T1: 30 minutes
T2: Within 30 minutesT1 T2 OFF (All doors are closed)
T1

ON
OFF
ON (UNFASTENED)
OFF (FASTENED)
ON (ILLUMINATED)
OFF (NOT ILLUMINATED) IGNITION SWITCH (IG1)
SEAT BELT
SWITCH
(DRIVER'S SIDE)
SEAT BELT
WARNING
LIGHT
ON
OFF
ON (UNFASTENED)
OFF (FASTENED)
ON (ILLUMINATED)
OFF (NOT ILLUMINATED) IGNITION SWITCH (IG1)
SEAT BELT
SWITCH
(DRIVER'S SIDE)
SEAT BELT
WA R N I N G
LIGHT8 km/h (5 mph)
0 km/h (0 mph) VEHICLE SPEED
e 3 km/h (2 mph)
ON
OFF
a: 0.48 SECOND
b: 0.52 SECONDc: 1 SECOND
d: 3 SECONDSe: 60 SECONDS OR MORE
f: 10 SECONDS
agggf
b
cc ccc d12 CYCLES
1 CYCLE12 CYCLES 12 CYCLES 12 CYCLES
SEAT BELT
WA R N I N G
LIGHT
g: 0.5 SECOND

CONTROL WIRING
HARNESSINJECTOR WIRING
HARNESS
<3.8L ENGINE>INSTRUMENT PANEL
WIRING HARNESSREAR DOME LIGHT
WIRING HARNESSROOF WIRING
HARNESS
FRONT WIRING
HARNESSFLOOR WIRING
HARNESSREAR DOOR
WIRING HARNESS
*
FRONT DOOR
WIRING HARNESS*

Denotes connector No.
The same connector No. is used throughout the circuit diagrams to facilitate connector location searches.
The first alphabetical symbol indicates the location site of the connector and a number that follows is the unique number.
Numbers are usually assigned to parts in clockwise order on the diagram.
Example: A-19
Number specific to connector (serial number)
Connector location site symbol
A: ENGINE COMPARTMENT D: FLOOR AND ROOF
B: ENGINE AND TRANSAXLE E: DOOR
C: DASH PANEL F: LUGGAGE COMPARTMENT
Denotes ground point.
Same ground number is used throughout circuit
diagrams to facilitate search of ground point.
Refer to GROUP 70 COMPONENT LOCATIONS
-GROUND MOUNTING LOCATIONS for details
of ground points.
Denotes the color of the tube
(If not specified, it is black).
R: Red
Y: Yellow
The number of connector pins and the connector color
(except milk white)* are shown for ease of retrieval.
Example: (2-B)
Connector color
(milk white if no color is indicated)
Number of connector pins
*: Typical connector colors
B: Black BR: Brown
Y: Yellow V: Violet
L: Blue O: Orange
G: Green GR: Gray
R: Red NONE: Milk white
A-15 (2) FOG LIGHT (RH)
A-16 (2-GR) HORN (LOW)
A-17 (2-B) HEADLIGHT (RH)
A-18 (2-B) WINDSHIELD WASHER MOTOR
A-19 (2-GR) DUAL PRESSURE SWITCH
Indicates the device to which the
connector is connected.
The mark shows the
standard mounting position
of wiring harness.
A-17
A-16
A-15 A-18 A-19
Y
Denotes a section covered by a
corrugated tube.
FRONT
WIRING
HARNESS
(RH) Denotes harness name.

CONNECTOR COLOR
CODE
B: BLACK
BR: BROWN
G: GREEN
GR: GRAY
L: BLUE
NONE: MILK WHITE
O: ORANGE
R: RED
V: VIOLET
Y: YELLOW
Connector
symbol
FLOOR
WIRING
HARNESSREAR DOME
LIGHT WIRING
HARNESS
Y
D-01D-02
D-03D-04 D-05 D-06
D-24 D-25 D-26 D-27 D-28 D-29 D-30 D-31 D-32 D-33 D-34 D-35 D-36 D-37
ROOF
WIRING
HARNESS

BatteryBuzzerCapacitorElectrolytic
capacitorVa r i a b l e
capacitorCoil
DiodeLight emitting
diodePhoto diodeZener diodeDual filament bulbSingle filament
bulb
Fus eFusible linkHornMotorPulse generatorPiezoelectric
device
ResistorVariable resistorSpeakerThermistorTransistorPhoto transistor
1.25 G B
1234
Example: