clock MITSUBISHI LANCER EVOLUTION 2010 10.G Owner's Guide

Vehicle care and maintenance
7-57
7
2. When replacing the bulb on the passenger’s side, lift up
the coolant reserve tank (B).3. Turn the socket (C) counterclockwise to remove it.*- Front of the vehicle
*- Front of the vehicle
BK0105501US.book 57 ページ ２００９年８月１０日　月曜日　午前１０時３２分

Vehicle care and maintenance
7-59
7
3. Turn the socket (E) counterclockwise to remove it. 4. Pull the bulb out of the socket.
5. To install the bulb, perform the removal steps in reverse.
BK0105501US.book 59 ページ ２００９年８月１０日　月曜日　午前１０時３２分

7-60 Vehicle care and maintenance
7
Front turn signal lights
N00943400253
1. Remove the clips (A) and clips (B), then remove the duct
(C) and the upper cover (D).2. Remove the entire socket and bulb assembly (E) by turn-
ing it counterclockwise.
*- Front of the vehicle
BK0105501US.book 60 ページ ２００９年８月１０日　月曜日　午前１０時３２分

7-62 Vehicle care and maintenance
7
2. While pressing the tab (D), pull out the socket (E).
3. Turn the bulb (F) counterclockwise to remove it.4. To install the bulb, perform the removal steps in reverse.
CAUTION
!

Handle halogen light bulbs with care. The gas inside
a halogen light bulb is highly pressurized, so drop-
ping, knocking, or scratching a halogen light bulb
can cause it to shatter.


Never hold the halogen lights bulb with a bare hand,
dirty glove, etc. The oil from your hand could cause
the bulb to break the next time the fog lights are
used.
If the glass surface is dirty, clean it with alcohol and
let it dry completely before installing the bulb.
BK0105501US.book 62 ページ ２００９年８月１０日　月曜日　午前１０時３２分

7-64 Vehicle care and maintenance
7
3. Remove the socket and bulb assemblies by turning them
counterclockwise.4. Remove the bulb by pulling it out.B- Tail and stop light
C- Rear turn signal light
D- Rear side-marker light
Tail and stop light and
Rear turn signal lightRear side-marker light
BK0105501US.book 64 ページ ２００９年８月１０日　月曜日　午前１０時３２分

7-66 Vehicle care and maintenance
7
2. Remove the socket and bulb assemblies by turning them
counterclockwise.3. Remove the bulb by pulling it out.
4. To install the bulb, perform the removal steps in reverse.C- Tail light
D- Back-up light
Back-up lightTail light
BK0105501US.book 66 ページ ２００９年８月１０日　月曜日　午前１０時３２分

Vehicle care and maintenance
7-67
7
License plate light
N00944000344
1. Remove the screws (A) from the license plate lamp lens
(B). Then, remove the lens and gasket (C), and withdraw
the bulb.2. Remove the socket and bulb assembly together by turning
it counterclockwise.
BK0105501US.book 67 ページ ２００９年８月１０日　月曜日　午前１０時３２分

Alphabetical index
2Pedal free play 7-29
Power brakes 3-132
Service brake 3-131
Braking
Warning lights 3-195
Break-in period 3-2
Bulb capacity 7-47
C
California Perchlorate Materials Requirements 1-9
Capacities 9-9
Card holder 3-253
Cargo loads 4-12
Catalytic converter 7-3
Certification label 9-5
Charging system warning light 3-197
Chassis number 9-3
Child restraints 2-21
Child safety locks for rear door 3-58
Cigarette lighter 3-256
Cleaning
Inside of your vehicle 7-72
Outside of your vehicle 7-74
Clutch
Clutch pedal operation 3-90
Fluid 7-16
,9-9
Pedal free play 7-28
Coat hooks 3-269
Combination headlights and dimmer switch 3-200Headlight reminder buzzer 3-204
Light auto-cutout function 3-203
Consumer information 8-2
Coolant (engine) 7-10
,9-9
Cruise control 3-133
Cup holder 3-266
D
Daytime running lights
Bulb capacity 7-47
Replacement 7-55
Defogger (rear window) 3-219
Defrosting or defogging (windshield, door windows) 5-20
,5-
30
Digital clock 5-96
Dimensions 9-5
Dimmer (high/low beam change) 3-204
Disc brake pads 7-34
Dome light (Rear)
Bulb capacity 7-49
Replacement 7-70
Switch 3-260
Dome light/Reading lights
Bulb capacity 7-49
Replacement 7-68
Switch 3-259
Doors
Lock 3-53
Power door locks 3-56
BK0105501US.book 2 ページ ２００９年８月１０日　月曜日　午前１０時３２分