ABS MITSUBISHI LANCER EVOLUTION IV 1998 Service Manual

ABS – Wheel Speed Sensor35B-18
WHEEL SPEED SENSOR
REMOVAL AND INSTALLATION
Post-installation Operation

Wheel Speed Sensor Output Voltage Measurement
1
23
4
Unit: Nm {kgf
m}
25 {2.6}25 {2.6}
25 {2.6}
Front speed sensor removal steps

Splash shield
1. Front speed sensor
2. Front rotor (Refer to GROUP 26
DRIVE SHAFT.)
Rear speed sensor removal steps
3. Rear speed sensor
4. Rear rotor (Refer to GROUP 27
REAR AXLE HUB.)NOTE
The front rotor and rear rotor are integrated with the drive
shaft and thus nonmaintainable.
Caution
When removing and installing the speed sensor and
rotor, use care not to allow the surfaces of the ball
piece and rotor at the end of the speed sensor to
be hit against a metal or other object, damaging
it.

BODY –
Body Dimension
42-10
6911
indicates that the dimension and the measurement point are the same as those for EVOLUTION-IV.
Unit: mm
13
12
22122
20
65
1,199
103
812
842920
31211 6
275
1,068
No.Standard measurement pointHole _ Size
shape mmNo.Standard measurement pointHole _ Size
shape mm
11Center of strut insulator
– 11 065Trailing arm mounting position–
12Center of suspension crossmember mounting hole
– 1569Center of rear shock absorber mounting hole
– 68
13Center of suspension crossmember mounting hole
– 1670Control link mounting position–
20Differential mounting bolt end–71Center of upper link mounting hole
– 14
21Center of suspension crossmember mounting hole
– 1472Center of upper link mounting hole
– 14
22Center of suspension crossmember mounting holeLeft:
– 13.5
Right:– 12.2 × 14