4WD MITSUBISHI LANCER EVOLUTION VI 1999 Workshop Manual

GENERAL – Models00-14
MODELS

Model
codeClass
codeModel
yearGradeEngine modelTransmission
modelFuel supply
system
E-CN9ASNDF’97RS4G63 (2,000-DOHC –
16 valves-intercooler
W5M51
(4WD-5M/T)
Electronically
controlledfuel
SRGF’97GSR
16 valves-intercooler
turbo)
(4WD-5M/T)controlled fuel
injection (MPI)
Applicable serial numbers
E-CN9A: CN9A – 0000001


Model
codeClass
codeModel
yearGradeEngine modelTransmission
modelFuel supply
system
GF-CP9ASNDF’98EVOLUTION-V RS4G63 (2,000-DOHC –
16 valves intercooler
W5M51
(4WD 5M/T)
MPI
SNGF’98EVOLUTION-V
GSR
16 valves-intercooler
turbo)(4WD-5M/T)
Applicable serial numbers
GF-CP9A: CP9A – 0000001


Model
codeClass
codeModel
yearGradeEngine modelTransmission
modelFuel supply
system
GF-CP9ASNDF’99EVOLUTION-VI
RS4G63 (2,000-DOHC –
16 valves-intercooler
turbo)
W5M51
(4WD-5M/T)MPI
SNGF’99EVOLUTION-VI
GSRturbo)
Applicable serial numbers
GF-CP9A: CP9A – 0100001

GENERAL – Special Handling Instruments for Towing00-20
SPECIAL HANDLING INSTRUMENTS FOR TOWING
Towing methodsRemarks
If a tow truck is used
Lifting method for 4 wheels – GoodFor 4WD models, the basic principle is that all
four wheels are to be raised before towing.
The shift lever should be set to 1st gear and
the parking brake should be applied.
Front wheels lifted – No goodThe vehicle must not be towed by placing only
its front wheels or only the rear wheels on a
rolling dolly, because to do so will result in
deterioration of the viscous coupling and result
in the viscous coupling causing the vehicle to
jump forward suddenly.
Front wheels lifted – No goodIf only the front wheels or only the rear wheels
are lifted for towing, the bumper will be damaged.
In addition, lifting of the rear wheels causes
the oil to flow forward, and may result in heat
damage to the rear bushing of the transfer, and
so should never be done.
Rear wheels lifted – No good
Towing by rope or cable – GoodThe front and rear wheels must rotate normally.
Both running and driving systems must function
normally.
The shift lever must be set to the neutral position
and the ignition key must be set to “ACC”.