glove box MITSUBISHI LANCER EVOLUTION VI 1999 Workshop Manual

[x] Cancel search | Manufacturer: MITSUBISHI, Model Year: 1999, Model line: LANCER EVOLUTION VI, Model: MITSUBISHI LANCER EVOLUTION VI 1999
Pages: 558, PDF Size: 9.73 MB

Page 18 of 558

MITSUBISHI LANCER EVOLUTION VI 1999 Workshop Manual GENERAL – Precautions Before Service00-15
PRECAUTIONS BEFORE SERVICE
SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
1. Items to follow when servicing SRS
(1) Be sure to read GROUP 52B – Supplemental Restrain

GENERAL – Precautions Before Service00-15
PRECAUTIONS BEFORE SERVICE
SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
1. Items to follow when servicing SRS
(1) Be sure to read GROUP 52B – Supplemental Restraint System (SRS).
For safe operations, please follow the directions and heed all warnings.
(2) Always use the designated special tools and test equipment.
(3) Wait at least 60 seconds after disconnecting the battery cable before doing any further work.
The SRS system is designed to retain enough voltage to deploy the air bag even after the battery
has been disconnected. Serious injury may result from unintended air bag deployment if work
is done on the SRS system immediately after the battery cable is disconnected.
(4) Never attempt to disassemble or repair the SRS components. (SRS air bag control unit, air bag
module and clock spring.) If faulty, replace it.
(5) Warnings labels must be needed when servicing and handling SRS components. Warning labels
are located in the following locations.
Sun visor
Glove box
SRS air bag control unit
Steering wheel
Steering gear and linkage
Air bag module
Clock spring
(6) Store components removed from the SRS in a clean and dry place.
The air bag module should be stored on a flat surface and placed so that the pad surface is
facing upwards.
(7) Be sure to deploy the air bag before disposing of air bag module or disposing of a vehicle equipped
with an air bag. (Refer to GROUP 52B – Air Bag Module Disposal Procedures.)
(8) Whenever you finish servicing the SRS, check the SRS warning lamp operation to make sure
that the system functions properly.
2. Observe the following when carrying out operations on place where SRS components are installed,
including operations not directly related to the SRS air bag.
(1) When removing or installing parts do not allow any impact or shock to the SRS components.
(2) SRS components should not be subjected to heat over 93C, so remove the SRS components
before drying or baking the vehicle after painting.
After re-installing them, check the SRS warning lamp operation to make sure that the system
functions properly.