length MITSUBISHI LANCER EVOLUTION VI 1999 Workshop Manual

MITSUBISHI LANCER EVOLUTION VI 1999 Workshop Manual LANCER EVOLUTION VI 1999 MITSUBISHI MITSUBISHI https://www.carmanualsonline.info/img/19/57324/w960_57324-0.png MITSUBISHI LANCER EVOLUTION VI 1999 Workshop Manual

Page 28 of 558

MITSUBISHI LANCER EVOLUTION VI 1999  Workshop Manual ENGINE – Specifications11-3
SPECIFICATIONS
SERVICE SPECIFICATIONS
ItemsStandard valueLimit
Timing belt
Auto-tensioner rod projection length mm12–
Auto-tensioner rod pushed-in amount [when pushed w

Page 29 of 558

MITSUBISHI LANCER EVOLUTION VI 1999  Workshop Manual ENGINE – Specifications11-4
ItemsLimit Standard value
Intake oversize rework dimensions of valve
guide hole mm
0.3 O.S.35.30 – 35.33–
guide hole mm0.6 O.S.35.60 – 35.63–
Exhaust oversize rew

Page 30 of 558

MITSUBISHI LANCER EVOLUTION VI 1999  Workshop Manual ENGINE – Specifications11-5
ItemsLimit Standard value
Alternator
Rotor coil resistance ΩApprox. 3 – 5–
Protrusion length of brush mm–2
Starter motor
Commutator runout mm0.050.1
Commutator ou

Page 71 of 558

MITSUBISHI LANCER EVOLUTION VI 1999  Workshop Manual ENGINE – Cylinder Head and Valves11-46
BVALVE SPRING INSTALLATION
Direct the valve spring end with identification color toward
the spring retainer.
CRETAINER LOCK INSTALLATION
The valve spring,

Page 73 of 558

MITSUBISHI LANCER EVOLUTION VI 1999  Workshop Manual ENGINE – Cylinder Head and Valves11-48
VA LV E
(1) Check the valve face for correct contact. If incorrect, reface
using a valve refacer. Valve seat contact should be
maintained  uniform at the cente

Page 75 of 558

MITSUBISHI LANCER EVOLUTION VI 1999  Workshop Manual ENGINE – Cylinder Head and Valves11-50
VALVE GUIDE REPLACEMENT PROCEDURE
(1) Force the valve guide out toward the cylinder block using
a press.
(2) Machine the valve guide hole in the cylinder head

Page 81 of 558

MITSUBISHI LANCER EVOLUTION VI 1999  Workshop Manual ENGINE – Front Case, Counterbalance Shaft and Oil Pan11-56
(2) Secure the oil pump driven gear onto the left
counterbalance  shaft by tightening the flange bolt to
specified torque.
KPLUG INSTALLA

Page 86 of 558

MITSUBISHI LANCER EVOLUTION VI 1999  Workshop Manual ENGINE – Piston and Connecting Rod11-61
INSTALLATION SERVICE POINTS
APISTON PIN INSTALLATION
(1) Measure the following dimensions of the piston, piston
pin and connecting rod.
A: Piston pin insert

Page 90 of 558

MITSUBISHI LANCER EVOLUTION VI 1999  Workshop Manual ENGINE – Piston and Connecting Rod11-65
GCONNECTING ROD CAP NUT INSTALLATION
Caution
If the cylinder head has been installed before installing
the connecting rod cap nut, be sure to remove the spa

Page 91 of 558

MITSUBISHI LANCER EVOLUTION VI 1999  Workshop Manual ENGINE – Piston and Connecting Rod11-66
(3) Install the piston ring into the cylinder bore. Force it down
with a piston, its crown being in contact with the ring,
to correctly position it at right a
Page:   1-10 11-20 next >