boot MITSUBISHI MONTERO 1989 1.G Workshop Manual

,’ i 1;
h-J ” ^ .
14 Treatment Before I INTRODUCTION AND MASTER TROUBLESHOOTING - AftertheFotiingofastmsm
TREATMENT BEFORE/AFTER THE FORD-
ING OF A STREAM
INSPECTION AND SERVICE BEFORE FORDING
A STREAM NOW%-
Vehicles which are driven through water, or which may
possibly be driven through water, should be subjected to the
following inspections and maintenance procedures in ad-
vance.
e Seal the speedometer cable with a water-resistant grease ~_
or tape.
a Inspect the dust boots and breather hose for cracks or
damage, and replace them if cracks or damage are found.
,- . 1^. dometer cable 1
Steering joint assembly
/ 1 Drive shaft boot -\l(. ‘/ Torsion bar dust cover 1 Breath& hose==
OOW528
( TSB Revision -

16 Treatment Before I INTRODUCTION AND MASTERTROUBLESHOOTING - AftertheFordingofaStream
INSPECTION AND SERVICE AFTER FORDING A
STREAM
After fording a stream, check the following points. If abnormal
condition is evident, clean, replace or lubricate.
= Check for water. mud. sand. etc. in the rear brake drum.
clutch housing, &tarte; mot&, brake pipe and fuel pipe:
Check for water in the fluid or oil inside the front
differential. rear differential, transmission and transfer
case.
Apply grease to the lubricating points of the front suspen-
sion, steering linkage and propeller shaft.
Check all boots and breather hoses for cracks and
damage.
rTSB Revi