INTRODUCTION AND MASTER TROUBLESHOOTING - Precautions Before Servicre 11
5. Connect connectors which have catches by inserting the
connectors until they snap.
I
I cwE331
I
10A 15A
ELECTRICAL COMPONENTS
1. When installing any of the vehicle parts, be careful not to
pinch or damage any of the wiring harnesses.
2. Sensors, relays, etc., are sensitive to strong impacts.
Handle them with care so that they are not dropped or
mishandled.
3. The electronic parts used for relays, etc., are sensitive to
heat. If any service which causes a temperature of 80°C
(176°F) or more is performed, remove the part or parts in
question before carrying out the service.
FUSES AND FUSIBLE LINKS
1. If a blown-out fuse is to be replaced, be sure to use only a
fuse of the specified capacity. If a fuse of a capacity larger
than that specified is used, parts may be damaged and the
circuit may not be protected adequately.
Caution
1. If a fuse is blown-out, be sure to eliminate the cause
of the problem before installing a new fuse.
2. Check the condition of fuse holders. If rust or dirt is
found, clean metal parts with a fine-grained sandpa-
per until proper metal-to-metal contact is made.
Poor contact of any fuse holder will often lead to
voltage drop or heating
in the circuit and could
result in improper circuit operation. 1 cnlY589
(SB Revision
1
