tow bar MITSUBISHI MONTERO 1989 1.G Workshop Manual
[x] Cancel search | Manufacturer: MITSUBISHI, Model Year: 1989, Model line: MONTERO, Model: MITSUBISHI MONTERO 1989 1.GPages: 30, PDF Size: 1.61 MB
Page 17 of 30

INTRODUCTION AND MASTER TROUBLESHOOTING - Towing and Hoisting 17 
TOWING AND HOISTING 
This vehicle can only be towed from the front with convention- 
al sling-type equipment and tow chain with grab hooks. 
If a vehicle is towed from the rear, use a tow dolly. 
A lumber spacer (4” x 4” x 55” wood beam) should be placed 
forward of under guard and under towing hook/shipping tie 
down hook. 
Then, attach J-hook to the lower arm. 
A safety chain system must be used. This system must be 
completely independent. of the primary lifting and towing 
attachment. Care must be taken in the installation of safety 
chains to insure they do not cause damage to bumper, painted 
surfaces or lights. 
LIFTING-GROUND CLEARANCE 
Towed vehicle should be raised until wheels are a minimum of 
10 cm (4 in.) from the ground. Be sure there is adequate 
ground clearance at the opposite end of the vehicle, especially 
when towing over rough terrain or when crossing sharp rises 
such as curbs. If necessary, ground clearance can be in- 
creased by removing the wheels from the lifted end of the 
disabled vehicle and carrying the lifted end closer to the 
ground. A 20 cm (8 in.) ground clearance must be maintained 
between brake drums and ground. 
FRONT TOWING PICKUP 
The vehicle may be towed on its rear wheels for extended 
distances, provided the parking brake is released. 
Make cartain the transmission remains in “NEUTRAL”. 
SAFETY PRECAUTIONS 
The following precautions should be taken when towing the 
vehicle. 
1. Remove exhaust tips and any other optional equipment, 
that interface with the towing sling. Padding (heavy shop 
towel or carpeting) should be placed between the towing 
sling cross bar and any painted surfaces, and bumper 
surfaces. 
2. A safety chain system completely independent of the 
primary lifting and towing attachment must be used. 
3. Any loose or protruding parts of damaged vehicle such as 
hoods, doors, fenders, trim, etc., should be secured prior 
to moving the vehicle. 
4. Operator should refrain from going under a vehicle unless 
the vehicle is adequately supported by safety stands. 
5. 
Never allow passengers to ride in a towed vehicle. 
6. State and local rules and regulations must be followed 
when towing a vehicle. 
1 TSB Revision