weight MITSUBISHI MONTERO 1989 1.G Workshop Manual

6 INTRODUCTION AND MASTER TROUBLESHOOTING - Vehicle Identification
~3.0 L Engine>
CHASSIS NUMBER
STAMPING LOCATION
NOOCE-
The chassis number is stamped on the side of the frame near ._
the right rear wheel.
CHASSIS NUMBER CODE CHART
L141 v KJOOOOOI
I I I I
VEHICLE SAFETY CERTIFICATION LABEL NWCF
The vehicle safety certification label is attached to face of left
door pillar.
This label indicates the month and year of manufacture, Gross
Vehicle Weight Rating (G.V.W.R.), front and rear Gross Axle
Weight Rating (G.A.W.R.), and Vehicle Identification Number
(V.I.N.).
ENGINE MODEL STAMPING
Nwce-
The engine model is stamped on the right front side on the
top edge of the cylinder block (for M-liter engines). For 3.0-
liter engines, it is stamped at the right rear of the top of the
cylinder block.
These engine model numbers are as shown in the following.
Engine model
Engine displacement 1
G54B 2.555 liters (155.9 cu.iiTI
6G72 2.972 liters (181.4 cu.in.)
The engine serial number is stamped near the engine model
number, and the serial number cycles, as shown below.
_ ~-
Engine serial number Number cycling
AA0201 to YY9999 AA0201 ----3 A.49989
/ Lo ABOOOl ---+ AY9999
I
1 LmBAOOOl ---+ YY9999
__.
-..:-:-- I 1-

20 INTRODUCTION AND MASTER TROUBLESHOOTING - General Data and Specifications
GENERAL DATA AND SPECIFICATIONS NW-
<2-door vehicles>
Models L047.G
ascription
chicle dimensions mm (in.)
Overall length
Without spare tire 0
With spare tire 8
Overall width @
Overall height
@
Wheelbase c3
Tread Front @
Rear 6
Overhang
Front @
Rear (9,
Height at curb weight (wt.)
Front bumper to ground @
Rear bumperto ground 0
Minimum running ground 0
clearance
Angle of approach 8
Angle of departure 8
Ramp breakover angle -33
hicle weights kg (Ibs.)
Curb weight
Gross vehicle weight rating
Gross axle Front
weight rating
Rear
Seating capacity TNSL F/H
3,900 (153.5)
3,935 (154.9)
1,680 (66.1)
1,840 (72.4)
2,350 (92.5)
1,400 (55.1)
1,375 (54.1)
685 (27.0)
900 (35.4)
480(18.9)
440(17.3)
210(8.3)
38”
28”
21”
1,455 (3.207)
1,910(4.210)
1 ,I 00 (2.425)
1,450 (3.197)
2 T
TNJL F/H
3,905 (153.7)
3,940(155.1)
1,680 (661)
1,850 (72.8)
2,350 (92.5)
1,400 (551)
1,415 (55.7)
685 (27.0)
905 (35.6)
490 (19.3)
450 (17.7)
215 (8.5)
38”
28”
21°
1,585 (3,494)
2,200 (4,850)
1,100 (2,425)
1,600 (3,527)
2 L141G
TRJL F/W
3,905 (153.7)
3,940(155.1)
1,880 (66.1)
1,850 (72.8)
2,350 (92.5)
1,400(55.1)
1,415 (55.7)
685 (27.0)
905 (35.6)
490(19.3)
450(17.7)
215(8.5)
38”
28”
21”
1,600 (3.527)
2,200 (4,850)
1,100 (2,425)
1,600 (3,527)
2 TRUL F/H
3,905 (153.7)
3,940(155.1)
1,680 (66.1)
1,850 (72.8)
2,350 (92.5)
1,400 (55.1)
1,415 (55.7)
685 (27.0)
905 (35.6)
490 (19.3)
450 (17.7)
215 (8.5)
38”
28”
21”
1,605 (3,538)
2,200 (4,850)
1,100 (2,425)
1,600 (3,527)
2
;--- -. . I I TSB Revision

-_-
22 INTRODUCTION AND MASTER TROUBLESHOOTING - General Data and Specifications
<&door vehicles>
L-
chicle dimensions mm (in.)
Overall length
Withoutspare tire a
With spare tire @
Overall width 0
Overall height @
Wheelbase Q
Tread Front @
Rear 8
Overhang Front @
Rear @
Height at curb weight
Wt.)
Front bumperto ground @
Rear bumper to ground 0
Minimum running ground @
clearance
Angle of approach 8
Angle of departure
8
Ramp breakover angle
63
,hicle weights kg (Ibs.)
Curb weight
Gross vehicle weight rating
Gross axle Front
weight rating
Rear
Seating capacity
gine
Model No.
Type
Number of cylinders
Bore
Stroke
Piston displacement
Compression ratio
Firing order
Basic ignition timing VMNJL F/H VMRJL F/H
4,570 (179.9)
4,605 (181.3)
1,680 (66.1)
1,890 (74.4)
2,695 (106.1)
1,400 (55.1)
I,41 5 (55.7)
745 (29.3)
1 ,I 65 (45.9) 4,570 ( 179.9)
4,605(181.3)
1,680 (66.1)
1,890 (74.4)
2,695(106.1)
1.400(55.1)
1,415 (55.7)
745 (29.3)
1,165(45.9)
490 (19.3)
450(17.7)
215 (8.5) 490 (19.3)
450(17.7)
215 (8.5)
38”
28”
18” 38”
28
18”
-i
1,780 (3,924)
2,400 (5,291)
1,100(2,425)
1,600 (3,527)
5 1,795 (3,957)
2,400 (5,291)
1,100(2.425)
1,600 (3,527)
5
6672
V-type, OHC
6
91 .I mm (3.59 in.)
76.0 mm (2.99 in.)
2,972 cm3 (181.4 cu.in.)
8.9
l-2-3-4-5-6
5”BTDC i2” 6672
V-type, OHC
6
91 .l mm (3.59 in.)
76.0 mm (2.99 in.)
2,972 cm3 (181.4 cuin.)
8.9
1-2-3-4-5-6
5”BTDC 22” : L146G
L
_-. 1 TSB Revision I
.- WMRUL F/H
4.570 (179.9)
4,605 (181.3)
1,680 (66.1)
1,890 (74.4)
2,695(106.1)
1,400(55.1)
1,415 (55.7)
745 (29.3)
1,165 (45.9)
490 (19.3)
450 (17.7)
215 (8.5)
38”
28”
18
1,805 (3,979)
2,400 (5,291)
1 ,100 (2,425)
1,600 (3,527)
5
3072
V-type, OHC
3
31 .l mm (3.59 in.)
76.0 mm (2.99 in.)
2,972 cm3 (181.4 cu.in.)
3.9
l-2-3-4-5-6
5”BTDC 22”