Ac low pressure switch MITSUBISHI MONTERO 2003 Service Repair Manual

ACX01846
A-16 Y A-17 A-18A-19
Denotes connector No.
The same connector No. is used throughout the circuit diagrams to facilitate connector location searches.
The first alphabetical symbol indicates the location site of the connector and a number that follows is the unique number.
Numbers are assigned to parts in clockwise order on the diagram.
Example: A-19
Number specific to connector (serial number)
Connector location site symbol
A: ENGINE COMPARTMENT F: FRONT FLOOR AND ROOF
B: ENGINE G: REAR FLOOR AND UNDER FLOOR
C: TRANSMISSION H: DOOR
D: DASH PANEL I: BACK DOOR
E: FLOOR CONSOLE
Denotes ground point.
Same ground number is used throughout circuit
diagrams to facilitate search of ground point.
Refer to GROUP 70 SINGLE PART INSTALLATION
POSITION - GROUND MOUNTING LOCATIONS
for details of ground points.
Denotes a section covered by a
corrugated tube.
Denotes the color of the corrugated
tube (If not specified, it is black.)
R: Red
Y: Yellow
The number of connector pins and the connector color
(except milk white)* are shown for ease of retrieval.
Example: (2-B)
Connector color
(milk white if no color is indicated)
Number of connector pins
*: Typical connector colors
B: Black BR: Brown
Y: Yellow V: Violet
L: Blue O: Orange
G: Green GR: Gray
R: Red NONE: Milk white
A-16 (1) HORN (LOW)
A-17 (3-GR) HEADLIGHT (LOW:RH)
A-18 (2-B) HEADLIGHT (HIGH:RH)
A-19 (2) DUAL PRESSURE SWITCH
Indicates the device to which the
connector is connected.
The mark shows the
standard mounting position
of wiring harness.
AF
Denotes harness name.FRONT
WIRING
HARNESS

ACX00822
ON
OFF
196 ± 20
(284 ± 2.9)
223 ± 27
(32.4 ± 3.9)2,550 ± 200
(369.9 ± 29)
3,140 ± 200
(455.5 ± 29)
kPa
(psi)
DUAL PRESSURE
SWITCH
AF
AC001370
OFF
ON
BLOWER
SWITCH
ASSEMBLY
AB