tailgate MITSUBISHI OUTLANDER 2010 2.G Owner's Guide

3-62 Features and controls
3
NOTE

Do not jump onto the lower gate or subject it to strong
impacts. Doing so could damage the lower gate.


The upper gate cannot be raised if it is not raised immedi-
ately after pulling the tailgate handle.
If this happens, raise the upper gate again while pulling
the tailgate handle.


It is not possible to open the tailgate while the battery is
disconnected. If necessary, use the inside tailgate release.


When the battery is reconnected, all doors and the tailgate
will be locked. Unlock them before trying to open the tail-
gate.
To close1. Raise the lower gate until it clicks and locks.NOTE

Before closing the upper gate, attempt to move the lower
gate back and forth to ensure that it is locked securely.
It will not be possible to close the upper gate unless the
lower gate is securely closed.
BK0115300US.book 62 ページ ２００９年７月１６日　木曜日　午前９時１３分

Features and controls
3-63
3
2. Pull the upper gate grip (B) downward as illustrated and
release it before the upper gate closes completely. Gently
slam the upper gate from the outside so that it is com-
pletely closed.
CAUTION
!

To avoid injuring your hand or arm, do not attempt
to close the upper gate without releasing the upper
gate grip (B).


Before starting the vehicle, be sure to confirm that
the tailgate is locked. If the tailgate opens while driv-
ing the vehicle, objects stored in the luggage com-
partment could fall out into the road.
CAUTION
!

When closing the lower gate, do not trap foreign
material in the area of the striker (C). Doing so
could damage the bar or make it impossible to close
the lower gate.
BK0115300US.book 63 ページ ２００９年７月１６日　木曜日　午前９時１３分

3-64 Features and controls
3
NOTE

Be sure to close the lower gate before closing the upper
gate. Closing them in reverse sequence could make the
gates hit each other, causing damage to the tailgate.


Gas struts (D) and wires (E) are installed in the locations
illustrated in order to support the tailgate. Please observe
the following in order to prevent damage or faulty opera-
tion:
 Do not touch, push or pull the gas struts or wires when
closing the tailgate.
 Do not attach any plastic material, tape, etc., to the gas
struts or wires.
 Do not tie string, etc., around the gas struts or wires.
 Do not hang objects on the gas struts or wires.
Inside tailgate release
N00523100061
The inside tailgate release is designed to provide a way to open
the tailgate if the battery is dead or disconnected.
The tailgate release lever (see illustration) is mounted on the
tailgate.
You and your family should familiarize yourselves with the
location and operation of the tailgate release lever.
BK0115300US.book 64 ページ ２００９年７月１６日　木曜日　午前９時１３分

Features and controls
3-65
3
To open1. Open the lid (A) inside of the tailgate.2. Move the lever (B) to open the tailgate.
3. Push out on the upper gate to open it.
4. Slowly lower the lower gate.
CAUTION
!

Always keep the release lever lid on tailgate closed
when driving so that your luggage cannot acciden-
tally bump the lever and open the tailgate.
BK0115300US.book 65 ページ ２００９年７月１６日　木曜日　午前９時１３分

3-66 Features and controls
3Theft-alarm system
N00510200156
The theft-alarm system is designed to provide protection from
unauthorized entry into the vehicle. This system is operated in
three stages: the first is the “armed” stage, the second is the
“alarm” stage, and third is the “disarmed” stage. If triggered,
the system provides both audible and visual alarm signals.
Armed stagePark the vehicle and stop the engine. Arm the system as
described below.
1. Turn the ignition switch to the “LOCK” position.
Also, if a key was used to start the engine, remove the key
from the ignition switch.
2. Make sure that the engine hood is locked.
3. Lock all doors and the tailgate by the remote control trans-
mitter, using either the F.A.S.T.-key.NOTE

If a door is open, after locking with the remote control
transmitter, close the door.
CAUTION
!

Do not modify or add parts to the theft-alarm sys-
tem. Doing so could cause the theft-alarm to mal-
function.
Arm the system and leave
BK0115300US.book 66 ページ ２００９年７月１６日　木曜日　午前９時１３分

Features and controls
3-67
3
At this time, the theft-alarm indicator (A) on the audio
panel flashes for confirmation. [The buzzer sounds inter-
mittently at the same time the theft-alarm indicator (A)
flashes. (if so equipped)]
4. The system has entered the armed stage after about 20
seconds, when the theft-alarm indicator (A) flashing
becomes slower. (The buzzer stops at this time.)
The theft-alarm indicator (A) continues to flash while the
system is in the armed stage.
NOTE

If the engine hood is open, the theft-alarm indicator (A)
illuminates and the system cannot enter the armed stage.
The system enters the armed stage about 20 seconds after
the engine hood is closed.


The system will be disarmed if, while the theft-alarm indi-
cator (A) is illuminated, all doors and the tailgate are
unlocked by remote control transmitter, the F.A.S.T.-key.


The system will be disarmed if, while the theft-alarm indi-
cator is illuminated, the ignition switch is turned to the
“ON” or “ACC”.


The system will not be armed if a door is not completely
closed. If this happens, rearm the system as described
above.


The security alarm system can be activated when people
are riding inside the vehicle or when the windows are
open. To prevent accidental activation of the alarm, do not
set the system to the system armed mode while people are
riding in the vehicle.
BK0115300US.book 67 ページ ２００９年７月１６日　木曜日　午前９時１３分

3-68 Features and controls
3
Alarm stageThe alarm will be activated if any of the following occur while
the vehicle is parked and the system is armed.
1. One of the doors and the tailgate is opened without the
remote control transmitter, the F.A.S.T.-key.
2. The engine hood is opened.
Also, for vehicles equipped with the interior alarm sensor, the
alarm will be activated if any of the following occur.

Attempt an unauthorized moving of the vehicle. (the
impact detection function)


Detect a motion in the vehicle. (the interior intrusion
detection function)


Disconnect the battery terminal.
Type of alarmWhen the alarm is activated:
1. The headlights blink on and off for 3 minutes.
After 3 minutes the headlights automatically shut off.
2. The horn (the siren for vehicles equipped with the interior
alarm sensor) will sound intermittently for 3 minutes.NOTE

The alarm will continue to operate for 3 minutes. At the
end of that period, the alarm will automatically shut off to
save battery power. The system will then be rearmed until
the proper disarming step is taken.


The alarm will resume if unauthorized actions are taken
again, even if the alarm has stopped.
Horn or siren sounds!
Headlights blink on and off!
BK0115300US.book 68 ページ ２００９年７月１６日　木曜日　午前９時１３分

Features and controls
3-69
3


While the alarm is operating, it is displayed on the infor-
mation screen in the multi-information display.
Ty p e 1
Ty p e 2
Alarm deactivationThe alarm can be deactivated in the following ways.

By using the remote control transmitter or the F.A.S.T.-
key to lock or unlock the door or tailgate.


Turn the ignition switch to the “ON” or the “ACC” posi-
tion.
To activate and deactivate the impact detection function
and the interior intrusion detection function
(if so
equipped)
The impact detection function and the interior intrusion detec-
tion function can be deactivated when parking in automated car
parks or leaving pets in the vehicle.
To deactivate the function
1. Turn the ignition switch to the “LOCK” position.
Also, if a key was used to start the engine, remove the key
from the ignition switch.
2. Raise and hold the wiper and washer switch to the
“MIST” position for about 3 seconds. The buzzer will
sound once and the function will be deactivated.
BK0115300US.book 69 ページ ２００９年７月１６日　木曜日　午前９時１３分

3-70 Features and controls
3
To activate the function
After deactivating the function, it will be activated again using
one of the following methods.

Unlock the doors and the tailgate using the keyless entry
system or the F.A.S.T.-key.


Turn the ignition switch to the “ON” or “ACC” position.
To activate the function again before locking the doors and the
tailgate, raise and hold the wiper and washer switch to the
“MIST” position for about 3 seconds.
The buzzer will sound twice and the function will be activated.
NOTE

The sensitivity of the impact detection function and the
interior intrusion detection function can be adjusted. For
further details, please contact an authorized Mitsubishi
Motors dealer.
Disarmed stageThe system will be disarmed when either of the following steps
are taken:
1. All doors and the tailgate are unlocked by the remote con-
trol transmitter or the F.A.S.T.-key.
2. The ignition switch is turned to the “ACC” or “ON” posi-
tion.
3. If the UNLOCK button is pressed when all doors and the
tailgate are closed and no door is opened within approxi-
mately 30 seconds, re-arming will automatically occur.NOTE

Once the system has been disarmed, it cannot be rearmed
except by repeating the arming procedure.
Disarm...by remote control transmitter or F.A.S.T.-key
BK0115300US.book 70 ページ ２００９年７月１６日　木曜日　午前９時１３分

Features and controls
3-71
3
Testing the theft-alarm systemUse the following procedure to test the system:
1. Lower the driver’s window.
2. Arm the system as explained in “Armed stage”.
3. Make sure that the theft-alarm indicator comes on and
flash in approximately 20 seconds.
4. Wait a few seconds and then unlock the driver’s side door
by using the inside door lock knob and opening the door.
5. Make sure that the horn (the siren for vehicles equipped
with the interior alarm sensor) sounds intermittently and
the headlights blink when a door is opened.
6. Disarm the system by unlocking all doors and the tailgate
by the remote control trasmitter, the F.A.S.T.-key.
Power window control
N00510800354
NOTE

Never try to operate the main switch and sub-switch in
different directions at the same time. This will freeze the
window in position.


Operating the power windows repeatedly with the engine
stopped will run down the battery. Use the window
switches only while the engine is running.
1- Open (down)
2- Close (up)
1
2
BK0115300US.book 71 ページ ２００９年７月１６日　木曜日　午前９時１３分