engine MITSUBISHI OUTLANDER 2012 3.G Owners Handbook

98AUDIO SYSTEMTECHNOLOGY
NOTE: Please refer to your Owner’s Manual (Page 5-46) for more
detailed information on how to use your audio system.
NOTE: You can select desired tracks from the “Playlist”,
“Artists”, “Album” or “Songs” menus stored in your
iPod or desired folder in your USB memory device.
Turn the FOLDER button and press the FOLDER
button.
USB and iPod Input (if so equipped)
Multi-information Meter Switch (INFO Button) Keyless Entry System
Loading a CD







[F.A.S.T. Key] [Normal Key]
LOCK
Press: Once – Lock all doors
UNLOCK
Press: Once – Unlock driver door
Twice – Unlock all doors
PANIC
Press and hold. Press any button
to turn off panic.
While carrying the F.A.S.T.
key, press the driver’s or
front passenger’s door
lock/unlock switch A .
Change element by
pushing the INFO
button: Warnings,
Odometer/Tripmeter,
Service reminder,
Engine coolant
temperature, Average
and momentary fuel
consumption, Driving
range and average
speed, etc. Pulling
up the emergency
brake offers additional
choices.
ECO Driving
When the ECO indicator light
is on, your current driving
style supports good fuel
economy.
SE and GT Trims
Multi-information meter
Audio Remote
Control Switch (if equipped)VOLUME UP
DOWNSEEK
Change
station or
track
MODE
Change
the audio
source
1. Park your vehicle in a safe place and turn the ignition.
2. Connect the cable
 (cable is not included with the vehicle)
to the USB memory device
 or the Dock connector  to
the iPod
.
3. Open the cover
 in the floor console box. Connect the
cable  to the USB input terminal
.
4. Turn the ignition switch to the “ACC” position. Press A to
turn on the audio system.
5. Press B several times to switch to the USB mode. The input
mode changes as follows:
CD
 USB  Bluetooth® (if equipped)
6. Depending on your USB device, it may take longer for
playback to start.
7. Once the device is selected, playback starts.
A
F
BC
E
D
A
To enter
frequencies into
the memory
(AM/FM/SAT)
1. Press A to turn
on the audio
system.
2. Press B to select
CD.
3. Press C to select
the desired band
(AM/FM/SAT).
1. Press the LOAD button F briefly.
2. The autochanger will show “WAIT” on the display and start
making itself ready for disc loading.
3. When the autochanger is ready for disc loading, the LOAD
indicator will illuminate and the display will show “LOAD DISC
No. (1-6)”.
4. When a disc is inserted into the CD slot, the disc will begin to
play.
4.
Turn D to desired frequency you wish to keep in the memory.
5. Press one of the Memory select buttons E (1-6) until
it beeps.Tire Pressure Monitoring System (TPMS)
The Tire Pressure Monitoring System gives you information to
help maintain your tire pressure. Please note that changes in
the outside temperature may decrease tire pressure causing
the TPMS light to turn on. If the TPMS light remains illuminated,
check your tire pressure.
Warning light
illuminates when tire pressure is too low. Contact MITSUBISHI
dealer. (May be a
TPMS system issue or malfunction.)

1312
Q: Is my phone compatible with the factory Mitsubishi Bluetooth® Hands Free System?
A: Check the phone approval list, www.mitsubishicars.com/owners to see if the phone is Bluetooth® approved.
Q. Why doesn’t my device (USB, iPhone, Bluetooth® Audio, etc.) work?
A: You need to press the Mode button to select the appropriate device you want to use.
Q: How do I use Bluetooth® Audio (if equipped)?
A: Turn the Audio System power on. Press the CD button several times until B (Bluetooth®) is shown. Connect your Bluetooth® device
via pairing mode. Playback will start automatically.
Q: How do I transfer calls from Bluetooth® back to my mobile phone’s handset?
A: While on the call, press the speech button on your steering wheel and, once prompted, say “Transfer Call.”
Q: Why does the FUSE Hands-free Link System™ take so long to upload my music from my audio music device?
A: The Mitsubishi system can read multiple device structures in order to catalog the music files for easy playing and listening.
Depending on the amount of music you have on your device, this may take a few minutes.
Q: What are the different ways of playing music from my portable music player through the stereo system in my vehicle, when
equipped with the FUSE Hands-free Link System™?
A: There are three ways of playing music through your vehicle’s sound system.
• USB port - The FUSE system will find the songs in your device and categorize them according to Artist, Album, and Genre. Then you can have the FUSE system find and play the song in your device that you prefer without physically searching your device.
This is done via voice commands.
• Bluetooth® Streaming - Once your device is paired to the FUSE system, you can stream music from your device through the FUSE system to your vehicles sound system. No wires or cords. Your music stops and restarts at the same song when you exit
and when you re-enter the vehicle. Voice commands are not available.
• RCA auxiliary ports - Music can be played through a vehicles stereo system via the head phone port of your music device (An RCA to mini headphone jack adapter cable will be needed) Voice command is not available.
Q: Why can’t I control the music track selection via voice commands while Bluetooth® streaming?
A: The Mitsubishi system uses AVRCP 1.3 (Audio video Programing system) which does support song information (title, artist, track,
etc.). However, you must have a device that also supports AVRCP 1.3 to supply that information to the Mitsubishi system.
Q: My Outlander is equipped with “Micron Air Filtration”. Where is the filter located and does it need servicing?
A: The micron air filter is a small filter element which is located in the HVAC box just behind the lower glove box. The filter should be
inspected frequently for debris. The filter works well at filtering incoming air however the filter will clog and lead to reduced outlet
air volume if not serviced on a regular basis.
FAQ ’ s FAQ ’ s
Q: My Outlander has two 12V accessory outlets. What devices can be plugged into these outlets?
A: Both of these outlets are protected with 15 amp fuses. Always check the current draw rating of any device prior to use in the
vehicle. If the device is rated above 12 amps, this could lead to circuit overload and the electrical fuse opening (no current flow).
Q: I only have one remote for the remote start system on my Outlander. Can I get a second one?
A: No. Only one remote can be programmed per vehicle for security reasons.
Q: How can I get the MPG stated on the window sticker?
A: Vehicle driving styles will greatly affect MPG. Avoid sudden abrupt starts from a stop and let the vehicle coast to the traffic light.
Both of these styles will increase mileage and reduce brake lining wear.
• Vehicles are designed to achieve the best fuel mileage when they are driven at the speed limits on the freeway. Avoid driving over 65 mph.
• Under inflated tires will increase rolling resistance and will reduce fuel mileage. Check tire pressure frequently to increase miles per gallon. Proper tire pressure also ensures optimum tire performance (including tire wear.)
Q: How does the Navigation System choose a certain route?
A: The system takes into account traffic conditions, road types, distance and road width to recommend the route.
Q: Why does my Anti-Lock Braking System (ABS) make a noise?
A: Each time your vehicle is started and driven a short distance, you will hear the sound of the ABS motor operating from the right
front engine compartment. This is the normal sound the Anti-Lock Braking System makes when performing a self check.
Q: Why do my Rain Sensing Windshield Wipers operate on their own when it’s not raining?
A: • When the lever is in the AUTO position, the rain sensor detects rain or snow and automatically turns on the wipers.
• The wipers may automatically operate when things such as insects or foreign objects are affixed to the windshield on top of the rain sensor or when the windshield is frosted over.
• To stop the wipers, place the lever in the OFF position.
Q: Why does my check engine light come on after I put gas in my car?
A: There are many reasons why your check engine light may illuminate. Before calling your dealership, make sure the
fuel cap is fully engaged and you have heard three clicks when tightening it. After checking and hearing three clicks and
the light is still on, contact your dealership.
Q: How do I use the emergency key when the F.A.S.T. key battery or vehicle battery is run down?
A: Remove the emergency key from the F.A.S.T key fob and manually unlock the door. Once inside the vehicle remove the
ignition switch cover by pressing the release buttons on the top and bottom of the ignition switch cover. Once the
ignition switch cover is removed insert the emergency key into the ignition switch then re-insert (backwards) the
F.A.S.T. key fob onto the emergency key. Once the F.A.S.T. key fob is re-inserted (backwards) turn the emergency
key to start the engine.