instrument cluster MITSUBISHI OUTLANDER 2012 3.G Owners Handbook

5
A - CANCEL: To deactivate the cruise control
B - ACC RES: To increase the set speed
C - COAST SET: To set the desired speed and to reduce
the set speed.
D - ON / OFF: To ON/OFF cruise control
To set a cruising speed
1. Press D and the “CRUISE”
indicator light in the meter
cluster will be turned on.
2. Accelerate or decelerate to your desired speed (above
25 mph). Press C and remove your foot from the
accelerator pedal.
To accelerate or decelerate speed
Press B to increase set cruising speed.
Press C to decrease set cruising speed.
To cancel the cruising speed
Press A or press brake pedal, or press D .
4CONTROLS OWN THE ROAD
Regular Headlights Windshield Wipers
The wipers will operate once.
INT: Intermittent intervals can be
adjusted by turning the knob A
AUTO: The wipers will be operated
automatically by rain sensor (if so
equipped).
Slow
Fast
Rear Window Wiper and Washer
Turn the knob B to operate the rear
window wiper.
The wiper operates continuously
for several seconds then operates
intermittently at intervals of about 8
seconds.
Washer fluid is sprayed, the wiper
will automatically operate 2 or 3
times.
A - Turn for Temperature control
B - Push to select outside air (Indicator light off) or recirculated air
(Indicator light on)
C - Turn to select the blower speed
D - Push for air conditioning ON/OFF
E - Turn to select the air flow and direction mode (AUTO position is only
auto type air conditioning)
F - Push to defog the rear windows.
To defog front windshield
1. Set the Temperature A to desired setting.
2. Set the blower speed C to highest position.
3. Set the Mode E to defrost position .
Automatic Headlights
Headlights and other lights on.
Parking, tail, front and rear sidemarker lights,
license plate and instrument panel lights on.
Headlights and other lights turn on and off
automatically in accordance with outside light level.
All lights off
AUTO
OFF
Air Conditioning (Automatic shown)
– :SHIFT DO WN+ :SHIFTUP
Paddle Shifters (if so equipped)
Seat Heater Switch
Position - Action
1 (HI) - For quick heating
2 - Heater off
3 (LO) - To keep the seat warm
Drive Mode Selector (if equipped)
The drive mode can be switched
by turning the dial while the
ignition switch is in the ON
position. The following drive
modes are available:
2WD: This mode is for economical
driving on normal dry roads and
freeways.
4WD AUTO: This mode is for
all driving conditions on various
roads.
4WD LOCK: This mode is for driving in slippery conditions such as on
snow-covered roads or sand.
Cruise Control Clock To set the time
1. Press and hold A and the clock
display flashes.
2. Press C to set the “Hours”.
3. Press D to set the “Minutes”.
4. Press B to stop the clock display
from flashing.
AB
C
D
Simply upshift or
downshift with a
tap of your fingers
– without moving
your hands from the
steering wheel.
You can return to
the “D” operation by
pulling the + (SHIFT
UP) side paddle shifter
rearwards (toward the
driver) and holding for
over 2 seconds.