hood release MITSUBISHI OUTLANDER 2013 3.G Owners Manual
[x] Cancel search | Manufacturer: MITSUBISHI, Model Year: 2013, Model line: OUTLANDER, Model: MITSUBISHI OUTLANDER 2013 3.GPages: 714, PDF Size: 21.47 MB
Page 4 of 714
Overview
Supplemental restraint system (SRS) - air
bag (for front passenger’s seat)
P.2-61, 2-72 Center vents P.5-2
Upper glove compartment
P.3-278
Selector lever P.3-95, 3-10512 V power outlet P.3-271Lower glove compartment
P. 3 - 2 7 8
Fuel tank filler door release lever
P. 1 - 4Rear window defogger switch P.3-237Side vents P.5-2
Drive mode-selector (if so equipped)
P. 3 - 1 1 5 Personal compartment
P.3-280
Fuses P.7-40
Engine hood release lever
P. 7 - 4Hazard warning flasher switch
P.3-226
Built-in cup holder P.3-284
Parking brake lever P.3-81 Mitsubishi Multi-Communication System (if so equipped)
Audio (if so equipped) P.5-46, 5-66
Clock (if so equipped) P.5-136
Air conditioning P.5-6, 5-16, 5-25, 5-35
BK0150600US.book 2 ページ 2012年3月30日 金曜日 午前10時43分
Page 603 of 714
7-4 Vehicle care and maintenance
7Engine hood
N00937500507
To openUse the engine hood release lever (located under the instrument
panel near the driver’s door) to unlock the engine hood.
Pull the lever toward you to release the engine hood latch.Release the lever and lift the engine hood.
NOTETo prevent damage to the engine hood and wipers, make
sure the wipers are at resting position when you open the
engine hood.
WA R N I N G
!Never use the release lever to unlatch the engine
hood while the vehicle is in motion.Do not drive your vehicle unless the engine hood is
locked.
BK0150600US.book 4 ページ 2012年3月30日 金曜日 午前10時43分
Page 637 of 714
7-38 Vehicle care and maintenance
7
Exhaust system
N00942200094
The best way to keep carbon monoxide gas from entering
inside your vehicle is to have the engine exhaust system prop-
erly serviced.
Have a competent mechanic inspect the complete exhaust sys-
tem and nearby body areas for broken, damaged, deteriorated,
or mispositioned parts if you notice any of the following:
A change in the sound of the exhaust system
The smell of exhaust fumes inside the vehicle
The underside or rear of the vehicle is damaged
Also check the exhaust system each time the vehicle is raised
for lubrication, oil changes, or required service. Any open
seams or loose connections could let dangerous exhaust fumes
seep into the luggage compartment and passenger compart-
ments.Check for any of the following conditions:Check for holes or exhaust gas leaks caused by corrosion
or damage.
Check the joints and connections for looseness or exhaust
gas leaks.
Check the rubber hangers and brackets for damage.
Timing belt
N00942300079
The timing belt should be replaced with a new one at the mile-
age listed in the “WARRANTY AND MAINTENANCE
MANUAL”.Hood lock release mechanism and safety catch
N00942500101
The hood lock release mechanism and hood safety catch should
be checked, cleaned, and oiled when needed for easy move-
ment and to stop rust and wear. Use Multipurpose Grease
NLGI Grade 2 sparingly for all sliding parts of the hood latch
and release lever. Work the grease into the hood lock mecha-
nism until all the movable surfaces are covered.
Also, put a light coat of the same grease on the safety catch
wherever moving parts touch.
WA R N I N G
!Carbon monoxide gas from your vehicle’s exhaust is
poisonous. Breathing these fumes can cause uncon-
sciousness or death.
BK0150600US.book 38 ページ 2012年3月30日 金曜日 午前10時43分
Page 702 of 714
Specifications
9-11
9 Capacity
N01148001045
Item
Capacity
Lubricants
Fuel
(approximate)
Front-wheel drive vehicles 16.6 gal (63 L)
Refer to “Fuel selection” on page 1-2All-wheel drive vehicles 15.8 gal (60 L)
Engine oil
2.4 liter
Oil pan 4.5 qt (4.3 L)
Engine oils displaying the ILSAC certification mark (“star-
burst” symbol) on the container.
If these oils are not available, and API classification SN can
be used.Oil filter .32 qt (0.3 L)
3.0 liter
Oil pan 4.2 qt (4.0 L)Oil filter .32 qt (0.3 L)
Power steering As required Mitsubishi Motors Genuine Power Steering FluidAutomatic transaxle 8.7 qt (8.2 L) Mitsubishi Motors Genuine ATF - J3Continuously variable transmission (CVT) 7.5 qt (7.1 L) Mitsubishi Motors Genuine CVTF - J4Transfer oil .50 qt (0.47 L)Mitsubishi Motors Genuine Super Hypoid Gear Oil API
classification GL-5 SAE 80Differential
Rear axle .42 qt (0.4 L)Mitsubishi Motors Genuine Super Hypoid Gear Oil API
classification GL-5 SAE 80
Brake As required Conforming to Brake fluid DOT3 or DOT4Hood lock release mechanism and safety catch As required Multipurpose type grease NLGI Grade 2Engine coolant
{Includes .69 qt
(0.65 L) in
reserve tank}
Automatic transaxle 10.0 qt (9.5 L)
Mitsubishi Motors Genuine Super Long Life Coolant
Premium or equivalent*CVT 7.9 qt (7.5 L)
Washer fluid 4.8 qt (4.5 L) —
BK0150600US.book 11 ページ 2012年3月30日 金曜日 午前10時43分
Page 707 of 714
Alphabetical index
4Fuel
Filling the fuel tank 1-4
Fuel economy 4-2
Fuel hoses 7-35
Fuel selection 1-2
Tank capacity 9-11
Fuses 7-40
Fusible links 7-39
G
General maintenance
Maintenance 7-37
General vehicle data 9-6
Genuine parts 1-8
Glove compartment 3-278
H
Hazard warning flasher switch 3-226
Hazard warning lights 3-211
Head restraints 2-26
Headlight leveling switch 3-224
Headlights
Bulb capacity 7-49
Dimmer 3-221
Headlight flasher 3-222
Replacement 7-52
,7-54
Switch 3-217
High beam indicator 3-211High mount stop light
Bulb capacity 7-49
Hill start assist 3-131
Hood lock release mechanism and safety catch 7-38
Horn switch 3-238
I
If the vehicle breaks down 6-2
Ignition switch 3-25
,3-89
Important facts to know in case of an accident 8-5
Indicators 3-211
Information screen display 3-166
,3-199
Inside rearview mirror 3-83
Inspection and maintenance following rough road operation 3-
127
Instrument cluster 3-163
Interior lights 3-273
J
Jack 6-7
Storage 6-7
Jump-starting the engine 6-2
K
Keyless entry system 3-9
,3-46
Keys 3-2
BK0150600US.book 4 ページ 2012年3月30日 金曜日 午前10時43分