air conditioning MITSUBISHI OUTLANDER HYBRID 2014 3.G Owners Handbook

Downloaded from www.Manualslib.com manuals search engine 3
5. Turn off the air conditioning when it’s not needed.
6. Use Economy Mode. This maximizes the vehicle’s fuel
economy. It’s activated by pressing the ‘ECO’ button.
The Economy Mode limits other aspects of the vehicle’s
performance, such as acceleration rate and air-
conditioning, to save fuel.
7. When accelerating keep the ‘Power’ needle in the green
range so that (depending on battery level) the petrol
engine does not start.
8. Avoid hard braking. Braking gently or moderately allows
the regenerative braking system to recover energy from
the vehicle’s forward motion and store it as electricity.
Hard braking causes the vehicle to use its conventional
friction brakes, which do not recover energy. When using
regenerative braking, the ‘negative’ (LH) paddle increases
the amount of regenerative braking and thus the braking
force. This action also reduces wear to the braking system
components.
9. Use 4WD Lock Mode only when additional traction or
stability is required.
10. Familiarise yourself with the car’s hybrid information
display so you can monitor how much energy is being
used.

Downloaded from www.Manualslib.com manuals search engine 8
6. If the battery temperature becomes too high, charging may stop.
7. Open the cap on the normal charge connector. Hold the handle of the connector and, without pressing the button, insert the connector until it clicks.
8. The charging indicator on the instrument cluster should illuminate. It goes out when charging is completed.
Normal charge connector
Cap
Button
MITSUBISHI Remote Control* enables timed charging and air conditioning on your OUTLANDER PLUG-IN HYBRID. For details, go to mmnz.co.nz/plug-in-hybrid
Charging indicator
* MITSUBISHI Remote Control enables you to remotely control your OUTLANDER PLUG-IN HYBRID using dedicated applications over a connection between your vehicle and a wireless LAN device. Available on VRX models only.
If the charge cable is connected to the charge port, it is not possible to start the vehicle. Operation of the radio, heater, and air conditioning is possible when connected to the charge port.
Once the battery is completely charged, the on board charging system will stop charging the vehicle. There is
no need to unplug the vehicle until use of the vehicle is required.

Downloaded from www.Manualslib.com manuals search engine 18
Pressing the switch again deactivates the demister. Alternatively, after about 15 to 20 minutes, the demister automatically turns off. Use the demister only when the READY
indicator is illuminated to prevent the auxiliary battery from going dead.
04 ECO Mode switch
The ECO mode supports fuel-efficient eco driving by automatically controlling the plug-in hybrid Electric Vehicle system and the air conditioner.
When the READY indicator is illuminated, pressing the ECO mode switch activates the ECO mode.
Pressing the switch again deactivates the ECO mode. While the ECO mode is active, the relevant indicator lamp on the instrument cluster stays illuminated.
02 Hazard warning flasher switch
Use the hazard warning flasher when you have to park your vehicle on the road
such as when a failure has occurred.
When the switch is pressed, all of the turn-signal lamps and the corresponding indicator lamps on the instrument cluster start blinking. When the switch is pressed again, the lamps and indicators stop blinking.
03 Rear window demister switch
When the power switch is set to ON,
pressing this switch activates the rear window demister and the indicator lamp on the switch illuminates.
Indicator lamp
Air conditioner ON/OFF
Press the air conditioning switch.
Air conditioning indicator
Press the AUTO switch.
AUTO mode
AUTO mode indicator