turn signal NISSAN 350Z 2007 Z33 Quick Reference Guide

0502
07
06
03
11
04
12
1009
01
08
headlight and turn
signal COntrOl
03
instru Ment Brightness

CO ntr Ol*
01
steering Wheel

s W itCh FO r audi O
CO ntr Ol
04
W indshield WiP er /

W asher s W itCh

C
ruise COntr Ol
05
tri P COMP uter MOde/

setting Butt Ons
02
06
Fuel -Filler

d OO r release
t C s /V dC

OFF sW itCh
s
OF t t OP
OP erating s W itCh
( r oadster Models)
0708
09
h OO d release *
10
steering Wheel

tilt ad Just Ment *
11
COntr Ol P anel

dis Pla Y
12
1314
audi O sY ste M
13
Cli M ate COntr Ols
14
*See your Owner’s Manual fpr more information.

headlight and turn signal CO ntrOl
HEADLIGHT SWITCH
 Turn the headlight switch to theposition to turn on the front parking, side marker, tail, license plate and instrument panel lights.
 Turn the headlight switch to theposition to turn on
the headlights. All other lights remain on.
HIGH BEAM
 Push the headlight switch forward to select the high beam function. The blue indicator light illuminates. Pull the headlight switch back to the original position to select the low beam. The blueindicator light goes off.
 Pull and release the headlight switch to flash the headlight high beams on and off.
TURN SIGNAL SWITCH
 Move the headlight control switch up or down to signal the turning direction. When the turn is completed, the turn signals cancel automatically.
 To signal a lane change, move the headlight control switch up or down to the point where the indicator light begins to flash, but the headlight control switch does not latch.
W indshield W iP er /W asher sW itCh
 The ignition switch must be in the ON position
to activate the windshield wipers.
 Move the lever to the following positions to
operate the windshield wipers:
1a Intermittent (INT) – Front wipers operate
intermittently and can be further adjusted
by twisting the time control ring 1B.
02 Low Speed (LO) – Continuous low-speed
operation of front wipers.
03 High Speed (HI) – Continuous high-speed
operation of front wipers.
04 Mist (MIST) – Lift the lever up for one sweep of the front wipers.
05 Rear Wipers (REAR) – Twist the end section to operate the first (INT)
or second (ON) speed settings for the rear wipers.
 The washer function activates the washer fluid and several sweeps of the wipers:
• For F
RONT WASHER, pull lever toward you.
• For REAR WASHER, push lever away from you. (Coupe only)

1a
02
03
04
1B05