instrument panel NISSAN 350Z 2008 Z33 Quick Reference Guide

INSTRUMENT BRIGHTNESS CONTROLTRIP COMPUTER/MODE SETTING BUT-
TONSHEADLIGHT AND TURN SIGNAL CON-
TROLWINDSHIELD WIPER/WASHER SWITCH
STEERING WHEEL SWITCHES FOR AU-
DIO CONTROL/BLUETOOTH
CRUISE CONTROLSOFT TOP OPERATING SWITCH (ROAD-
STER MODELS ONLY)
TRACTION CONTROL SYSTEM (TCS)
OFF SWITCHFUEL FILLER DOOR RELEASESTEERING WHEEL TILT ADJUSTMENT*HOOD RELEASE*
CONTROL PANEL DISPLAYAUDIO SYSTEMCLIMATE CONTROLS
*See your Owner’s Manual for more information.

Mist(MIST)– Lift the lever up for one sweep of the front wipers.
Rear Wipers(REAR)– Twist the end section to operate the first(INT)or second
(ON)speed settings for the rear wipers.
The washer function activates the washer fluid and several sweeps of the wipers:
●For FRONT WASHER, pull lever toward you.
●For REAR WIPER, push lever away from you.
HEADLIGHT AND TURN SIGNAL CONTROL
HEADLIGHT CONTROL SWITCH
Turn the headlight control switchto the
position to turn on the front parking, tail, license plate
and instrument panel lights.
Turn the headlight control switch
to thepo-
sition to turn on the headlights. All other lights remain
on.
FOG LIGHT OPERATION
NOTE: The headlights must be on and the low beams selected for the fog lights to operate.
Turn the switch (inside collar)
to theposition to turn on the fog lights.
Turn the switch (inside collar)
to theOFFposition to turn off the fog lights.
TURN SIGNAL SWITCH
Move the headlight control switch up or downto
signal a turning direction. When the turn is completed,
the turn signals cancel automatically.
To signal a lane change, move the headlight control
switch up or down
to the point where the indica-
tor light begins to flash, but the headlight control switch
does not latch.
HIGH BEAM
Push the headlight control switch forwardto
select the high beam function. The blue
indicator
light illuminates. Pull the headlight switch back to the
original position to select the low beam. The blue
indicator light goes off.
Pull and release the headlight control switch
to flash the headlight high beams on
and off.
3

CRUISE CONTROL (if so equipped)
To activate the cruise control, push theON·OFF
switch. The indicator light in the instrument panel will
illuminate.
To set cruising speed, accelerate the vehicle to the
desired speed, push theCOAST/SETswitch and
release it. The SET indicator light in the instrument
panel will illuminate.
To reset at a faster cruising speed, push and hold the
ACCEL/RESswitch. When the vehicle attains the
speed you desire, release the switch.
To reset at a slower cruising speed, push and hold
theCOAST/SETswitch. Release the switch when
the vehicle slows to the desired speed.
To cancel cruise control, push theCANCELswitch or tap the brake pedal. The SET
indicator light in the instrument panel will go out.
To resume a preset speed, push and release theACCEL/RESswitch. The vehicle
returns to the last set cruising speed when the vehicle speed is over 25 MPH (40 km/h) .
To turn off cruise control, push theON·OFFswitch. Both the CRUISE indicator light and
the SET indicator light in the instrument panel will go out.
SCREW-IN RECOVERY HOOK
Your vehicle is supplied with a screw-in recovery hook
for pulling the vehicle forward. For example: Pulling the
vehicle onto a flat bed for towing.
The screw-in recovery hook tool is located in the right
rear luggage compartment area under the cover along
with the vehicle jack.
To install the recovery hook:
Remove the recovery hook cover from the front grill.
Install the recovery hook as shown in the photo. Turn it
clockwise until securely tightened.
5