tow NISSAN ALTIMA 2008 L32A / 4.G Quick Reference Guide

HEADLIGHT AND TURN SIGNAL CONTROL
to AC tIVA te t H e AU toLIGH t SYS teM
(if so equipped):
Turn the headlight control switch 01 to the AUTO position to activate the autolight system. The autolight system can:
 Turn the headlights on automatically when it is dark.
 Turn the headlights off automatically when it is light.
 Keep the headlights on for 45 seconds after you turn the ignition switch to OFF and all doors are closed.
to DeAC tIVA te t H e AU toLIGH t SYS teM :
 Turn the headlight control switch 01 to the OFF, or position.
H eADLIGH t CoNtR o L SWI tCH
 Turn the headlight control switch 01 to the position to turn on the front parking, tail, license plate and instrument panel lights.
 Turn the headlight control switch 01 to the position to turn on the headlights. All other lights remain on.
F o G LIGH t oPe RA tIo N (if so equipped)
N OTE:
The headlights must be on and the low beams selected for the fog lights to
operate.
 Turn the fog light switch (inside collar) 02 to the position to turn on the fog lights.
 Turn the fog light switch (inside collar) 02 to the OFF position to turn off the fog lights.
t URN SIGNAL SWI tCH
 Move the headlight control switch up or down A to signal a turning direction. When the turn is completed, the turn signals cancel automatically.
 To signal a lane change, move the headlight control switch up or down b to the point where the indicator light begins to flash, but the headlight control switch does not latch.
HIGH B eAM
 Push the headlight control switch forward C to select the high beam function. The blue indicator light illuminates. Pull the headlight switch back to the original position to select the low beam. The blue indicator light goes off.
 Pull and release the headlight control switch D to flash the headlight high beams on and off.
3
be adjusted by turning the time control. Also, the intermittent operation speed varies
in accordance with the vehicle speed. (For example, when the vehicle speed is high,
the intermittent operation speed will be faster.)
LO Low speed – Wipers operate at a continuous low speed.
HI High speed – Wipers operate at a continuous high speed.
MIST Mist – Lift the lever up for one sweep operation of the wiper.

LCN0042
Wash – Pull the lever toward you. Wipers automatically wipe several times.
A b
b A
C
D
0102

FUEL-FILLER DOOR RELEASE
The fuel-filler door release is located on the floor to the left of the driver’s seat.
 To open the fuel-filler door, pull the release up.
 To lock, close the fuel-filler door securely.
SUNROOF CONTROLS (if so equipped)
The ignition switch must be in the ON position to operate the sunroof.
tIL tING tH e SUNR ooF

To tilt the sunroof up, push the tilt switch toward the 01 position.

To tilt the sunroof down, push the tilt switch toward the 02 position.
SLIDING tH e SUNR ooF

To fully open the sunroof, push the switch toward the 02 position.

To fully close the sunroof, push the switch toward the 01 position.

To open or close the sunroof part way, push the switch in either direction (01 or 02) while the sunroof is sliding to stop it in the desired position.
02
01
TRUNK LID CANCEL SWITCH
 When the cancel switch (located inside the glove
box) is oFF, the trunk lid cannot be opened with the
trunk lid opener, located on the instrument panel,
the trunk request switch button or the Intelligent Key
button.
 It can be opened by using the Emergency Inside
Trunk Release.
11
FRONT SEAT ADJUSTMENTS With manual seats (if so equipped):
Fo RWARD AND BACKWARD
 Pull up on the lever 01 under the front of the seat and slide backward or forward. Release the lever to lock the seat in position.
S eAt LIF teR
(driver’s seat , if so equipped)
 Pull up or push down the adjusting lever 02 repeatedly to adjust the seat height.
Re CLINING
 Lift the lever 03 on the side of the seat to adjust your seatback forward or backward; release the lever when you have found a comfortable angle and the seat belt fits properly.
01
0203