language NISSAN ALTIMA COUPE 2010 D32 / 4.G Navigation Manual

INFO:
●For voice recognition system operation re-
lated to the phone, audio or vehicle informa-
tion systems, refer to the Owner’s Manual of
your vehicle.
●When the system language is set to
“Francais” (French) or “Español” (Spanish) ,
the available commands and functions may
differ from those that are available when using
the system in English.
USING THE SYSTEM
Initialization
When the ignition switch is pushed to the ON
position, NISSAN Voice Recognition is
initialized, which takes a few seconds. When
completed, the system is ready to accept voice
commands. If
is pushed before the initial-
ization completes, the display will show the mes-
sage: “System not ready.”
BEFORE STARTING
To get the best recognition performance from
NISSAN Voice Recognition, observe the follow-
ing points:
●The interior of the vehicle should be as quiet
as possible. Close the windows to eliminate
the surrounding noises (traffic noise and vi-
bration sounds, etc.) , which may prevent the
system from correctly recognizing the voice
commands.
●Wait until the tone sounds before speaking a
command.
●Speak in a natural conversational voice with-
out pausing between words.
GIVING VOICE COMMANDS
The method of giving a voice command in Stan-
dard Mode is described in this section.1. Push
button located on the steering
wheel switch.
NGT0092
Getting started2-25

8 Other settings
Settings screen...................................8-2
Basic operation................................8-2
Display settings...................................8-3
Basic operation................................8-3
Display adjustment.............................8-3
Basic operation................................8-4
Setting color theme.............................8-7
Navigation setting.................................8-7
Basic operation................................8-7
Speed limit indication on map . ...................8-8Other navigation settings........................8-9
Delete stored items............................8-15
Reset all navigation settings to default...........8-16
Volume adjustment...............................8-17
Basic operation...............................8-17
Clock settings....................................8-18
Basic operation...............................8-18
Language and unit settings........................8-19
Language settings.............................8-19
Unit settings..................................8-20

The navigation system can be customized to
make it easier for you to use.
BASIC OPERATION
1. Press SETTING.
2. Select the preferred setting item.
Available setting items
●“Navigation”:
Adjust various settings of the navigation
system.
“Navigation setting” (page 8-7)
●“Audio”:
Refer to the vehicle Owner’s Manual.
●“Phone”:
Refer to the vehicle Owner’s Manual.
●“Bluetooth”:
Set BluetoothAudio and Phone. Refer to the
vehicle Owner’s Manual.●“Volume and Beeps”:
”Volume adjustment” (page 8-17)
●“Display”:
“Display settings” (page 8-3)
●“Clock”:
“Clock settings” (page 8-18)
●“Others”:
– “Comfort”:
This item is displayed when the ignition
switch is in the ON position.
Refer to the vehicle Owner’s Manual.
– “Language & Units”:
“Language & unit settings”
(page 8-19)
– “Voice Recognition”:
“System feedback announce-
ment modes” (page 9-27)
INFO:
The displayed items vary depending on the
equipped options.
NSE0001
SETTINGS SCREEN
8-2Other settings

This changes the language and measurement
unit used in the system.
LANGUAGE SETTINGS
1. Press SETTING.
2. Select “Others”.
3. Select “Language & Units”.4. Select “Select Language”.
LNV0601NSE0035
LANGUAGE AND UNIT SETTINGS
Other settings8-19

5. Select the preferred setting item. The indi-
cator light of the selected item illuminates.
Available languages:
– “English”:
– “Francais”:
– “Español”:
NOTE:
Do not change the ignition switch position
while changing the language. Doing so
may cause a system malfunction.
UNIT SETTINGS
1. Press SETTING.
2. Select “Others”.
3. Select “Language & Units”.4. Select “Select Units”.
NSE0036LNV0601NSE0037
8-20Other settings

– If the only route to reach the destination
or waypoints is extremely complicated.
– If the destination, current vehicle position
or waypoint is within the “Avoid Area”.
– If a part of the route is included in the
“Avoid Area”.
●The following may occur when the route is
displayed:
– If you calculate a route on a main road,
the starting point of the route may not ex-
actly match the current vehicle location.
– The endpoint of the route may not exactly
match the destination.
– If you calculate a route on a main road,
the system may display a route from an-
other main road. This may be because
the position of the vehicle icon is not
accurate. In this case, park the vehicle in
a safe location and reset the vehicle icon,
or continue driving to see if the position
of the vehicle icon is automatically ad-
justed before recalculating the route.
– There are cases in which the system
shows an indirect route to reach the des-
tination or waypoints, if you set them
from stored or facility information. In or-
der to correct this, you must be carefulabout the traffic direction, especially
when lanes with different travel direc-
tions are shown separately, such as in-
terchanges and service areas.
– This system makes no distinction be-
tween limited traffic control and total
control (blockage) . It may show an indi-
rect route even if the road is usable.
– Even if the freeway preference is set to
OFF, a route that uses the freeway may
be suggested.
– Even if the preference is set to OFF, a
route that uses a ferry line may be
suggested.
– Ferry lines, excluding those that are only
for pedestrians, bicycles and
motorcycles, are stored in this system.
Take into consideration the travel time re-
quired and operational condition before
deciding whether to use them or not.INFO:
The system will only announce street names
when the system language is set to English.
Street names are not announced when the sys-
tem is set to Francais (French) or Español
(Spanish) .
BASICS OF VOICE GUIDANCE
Voice guidance announces which direction to
turn when approaching an intersection in which
a turn is necessary.
NOTE:
●There may be some cases in which voice
guidance and actual road conditions do
not correspond. This may occur because
of discrepancies between the actual
road and the information on the map
data, or it is due to the vehicle’s speed.
●In case voice guidance does not corre-
spond to the actual road conditions, fol-
low the information obtained from traf-
fic signs or notices on the road.
●Route guidance provided by the naviga-
tion system does not take carpool lane
driving into consideration, especially
when carpool lanes are separated from
other road lanes.
ROUTE GUIDANCE
10-10General system information

Audiopage 8-2
Phonepage 8-2
Bluetoothpage 8-2
Volume & Beepspage 2-22
DisplayDisplay Adjustmentpage 8-3
Color Themepage 8-7
Clockpage 8-18
OthersComfortpage 8-2
Language & Unitspage 8-19
Voice Recognitionpage 9-27
Camerapage 8-2
Image Viewerpage 8-2
Troubleshooting guide11-17

12 Index
2Dmap ...................3-2,3-6
3Dmap................3-3,3-7,10-3
A
About route guidance..............5-8
Address book..................10-2
Adjusting voice guidance volume.......2-23
Automatic reroute................10-3
Available items after setting a destination . . .5-2
Available views.................3-11
Avoidarea....................10-2
B
Basic operations................11-3
Basicsofvoiceguidance...........10-10
Birdview™...............3-3,3-7,10-3
C
Character (letter and number) input screen . .2-9
Clocksettings..................8-18
Controlbuttonsandfunctions..........2-2
Current vehicle location............10-4
Customer assistance..............11-2
D
Deletingaroute.................2-20
Deletingastoreditem .............6-29
Deleting a stored item individually . . .6-29, 6-31
Deletingallstoreditems............6-33
Deleting an individual item on the map....6-32
Destination screen................4-2
Detailed Map Coverage Areas (MCA) for the
navigation system................10-8
Detour......................10-3
Directions provided and the distances to guide
points......................10-11
Display of current vehicle location.......10-4
Displaysettings..................8-3
E
Editing the address book............6-13
Editing the avoid area..............6-26
Editing the stored home and location.....6-15
F
Features of this navigation system.......10-2
For safe operation................1-2
Functions disabled while driving........2-4
H
Howtostoreyourhome............2-14
Howtousethismanual .............1-2
Howtoviewmapscreen............2-21
I
Incorrect display of vehicle position......10-6
Information screen................7-2
L
Language and unit settings..........8-19
Laserproduct...................1-3
List screen....................2-7
M
Map scale.....................3-9
Maptypes.....................3-2
Menuscreensandtheirpurposes........2-5
Minor adjustment of the stored home and
locations.....................6-15
Movingamap...................3-6