driver seat adjustment NISSAN ARMADA 2013 1.G Quick Reference Guide

4
first drive features
Po WE r front s Eat aDJustmEnts (if so equipped)
To slide the seat forward or backward, push the
control switch

01 forward or backward.

To adjust the angle of the seatback, push the switch


02 forward or backward.
SeAT LifTe R (driver’s seat only)

To adjust the angle and height of the seat cushion,
push the front or rear end of the switch

01 up
or down.
MAnu AL LuMBAR S uPPORT (driver’s seat only)

To adjust the lumbar area, move the lever
03 up or down.
f
or more information, refer to the “safety –– seats, seat belts and supplemental restraint system (section 1)” of your
Owner’s Manual.
0102
03
2n D ro W sEat aDJ ustmEnts (if so equipped)
To recline the seatback, pull up on the lever
01 and
lean back.
Ti P u P fOR eASY enTRY/ eX iT O f TH e 3R d ROW
1. Raise the armrest (captain’s chairs – if so equipped) so it is parallel to the seatback and in
the stowed position.
2. Then lift up on the seatback latch

02 located on the

upper corner of the seatback and fold the seatback
forward onto the seatbase.
3. finally, lift up on the lower corner of the seat base
and fold the seat forward.
for more information, refer to the “safety –– seats, seat belts and
supplemental restraint system (section 1)” of your Owner’s Manual.
To view detailed in\fstructional videos\f regarding these a\fnd other features\f \fplease go to www.nissanownersin\Sfo.mobi
01
02

5
3rD ro W PoWE r folD inG s Eats (if so equipped)
nOTe: Before operating the 3rd row seats:
• Make sure the 2nd row seatback is not reclined.
• Lower the 3rd row headrest to the full down position.
• Disconnect and secure the center seat belt and tongues into the retractor base. Always
reconnect the center seat belt when the seat is returned to the upright \
position.
• Make sure that there are no objects on the seatback cushion.

The 3rd row power folding seat controls are located
behind the 2nd row seat (passenger’s side) on the
3rd row cup holder console

01 and on the rear
quarter trim panel behind the 3rd row seats
(passenger’s side)

02 .

To fold down the 3rd row seats, push and hold the
bottom portion of the switch.

To raise the 3rd row seats, push and hold the top
portion of the switch.

if the ignition switch is in the off position, the
power folding seats are always operational.

if the ignition switch is in the on position, the power
folding seats are only operational when the shift
lever is in the P (P ark) or n (nEutral) position.
for more information, refer to the “safety –– seats, seat belts and
supplemental restraint system (section 1)” of your Owner’s Manual.
automati C DrivE P osition Er (if so equipped)
Two positions for the driver’s seat, accelerator and
brake pedals and outside mirrors can be stored in
the automatic drive positioner memory.

follow these procedures to set the memory positions:
• Confirm the shift lever is in the P (P ark) position.
• Place the ignition switch in the on position.
• Adjust the driver’s seat, accelerator and brake pedals and outside mirrors to the desired
positions using the adjusting switches for each feature.
• Push the s Et switch and within 5 seconds, push the memory switch (1 or 2) for at least
1 second.
• The indicator light on the memory switch you select will illuminate for approximately 5 seconds.
• The driver’s seat, accelerator and brake pedals and outside mirror positions are now set to
your preference.

These memorized positions can also be linked to your ni SSAn intelligent key®.
for more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
To view detailed in\fstructional videos\f regarding these a\fnd other features\f \fplease go to www.nissanownersin\Sfo.mobi
01
02