light NISSAN ARMADA 2014 1.G 08IT Navigation Manual

Black plate (27,1)
[ Edit: 2012/ 4/ 11 Model: 08NJ-N ]
NGT00323. A confirmation message is displayed. Con-firm the contents of the message, highlight
[Yes] and push .
NGT00334.Highlight [Street Address] and push
. A character input screen is
displayed.
NGT00345. Enter the address of the home location,
highlight [OK] and push .
“Finding address” (page 4-4)
The map screen is displayed.
NGT00356. Adjust the location of your home using the muti-function controller, if necessary.
7. After adjusting the location, push
.
NGT00368.A message is displayed and the home
location is stored.
NGT00669. Highlight [OK] and push .
10. Push

Black plate (28,1)
[ Edit: 2012/ 4/ 11 Model: 08NJ-N ]
2-20Getting started
GUID-7A83FB78-9705-4073-94D4-BBF4B9200B12
SEARCHING FOR DESTINATIONGUID-66346E6C-FF12-4C98-824C-FD5B49256E6EAs an example, the method for setting a
restaurant as the destination using [Places] is
described here.
NGT00371. Push.
2. Highlight [Places] and push .
NGT00383. Highlight [Nearby RESTAURANT] and push
.
INFO:
The search can also be narrowed down by
selecting [All Categories or Name] or
[ZAGAT] on this screen. By selecting [All
Categories or Name], the area, name of
facility, etc. can be specified. By selecting
[ZAGAT], restaurants registered in the ZA-
GAT database can be searched and sorted
by its rating regarding food, decor, cost,
service, etc.
NGT00394. Highlight the preferred restaurant from the list and push .
INFO:
.The position of the selected location is
displayed in the preview on the right side
of the screen.
.If there is a route already in progress, onlyplaces along the current route will be
listed. Turn off [Show Along Route] at the top of list to display all nearby places.
NGT00405. The entire route is shown on the map.
Highlight [Start] after confirming the location
of the displayed destination, and push
.
The system sets the destination to the
selected location and starts calculating a
route.
INFO:
Even after setting a destination, the location
of the destination can be adjusted, the route
can be stored, etc. if necessary.
“Procedures after setting destination”
(page 5-2)
SETTING DESTINATION

Black plate (29,1)
[ Edit: 2012/ 4/ 11 Model: 08NJ-N ]
STARTING ROUTE GUIDANCEGUID-DA651AA9-020C-41C5-BA6D-66A6FB6C5D71After setting the destination and performing
route calculation, the suggested route is dis-
played.
NGT00401. Highlight [Start] and push.
NGT00422. Once route guidance is started, the system
navigates through the guide points using
visual and voice guidance.
NGT00433.When approaching a guide point, the
system automatically changes to the split
screen and shows an enlarged view of the
intersection in the left screen.
Push

Black plate (30,1)
[ Edit: 2012/ 4/ 11 Model: 08NJ-N ]
2-22Getting started
INFO:
. If a route is canceled, [Cancel Route]
changes to [Resume Route].
Highlight [Resume Route] and push
to reactivate the canceled route.
This is available only until a new route is set
or a currently set destination is deleted.
. The above step does not delete the
destination that has been set. To delete a
destination, push and highlight
[Delete Destination], then push .
“Delete destination” (page 4-20)
GUID-EC233EBE-1592-4D8E-972F-E2F3F43A1E61
HOW TO VIEW MAP SCREENGUID-447D71E9-7977-4E36-AC1E-877BED82B344The navigation system displays various informa-
tion on the map screen.
Screen informationGUID-4CA74274-5369-4F36-861A-EFA2308666F6
NGT0047
*1Vehicle icon:
Indicates the current vehicle location and
the direction of travel.
*2Starting point:
Displays the vehicle location, with which the
route is set, as the starting point.
*3Guide point:
Indicates a guide point on the route.
*4Waypoint:
Displays locations between the starting
point and the destination. A maximum of 5
waypoints can be set.
OPERATING MAPS

Black plate (31,1)
[ Edit: 2012/ 4/ 11 Model: 08NJ-N ]
*5Destination:
Indicates the destination location of the
route guidance.
When you reach your destination, the
address will be displayed on the map
screen.
*6Suggested route:
Appears in bold yellow during route gui-
dance.
*7Map Menu icon:
Touch the icon to display the Map Menu
screen.
“Map menu screen” (page 2-17)
*8/Direction indicator:
Indicates the directional setting of the map.
Touch the icon to change the setting.
: North always pointing up.
: Traveling direction always pointing up.
“Setting map orientation” (page 3-14)
*9Scale indicator:
Indicates the scale of the map.
Touch the icon to display the scale bar. This
allows the map scale to be adjusted.
“Operating with touch operation”
(page 3-10)
*10Street name:
Displays the name of the street that the
vehicle is currently driving on.GUID-849BE8ED-BA6E-471C-B6E1-B7B5915174E9
TURNING VOICE GUIDANCE ON/OFFGUID-53A18E54-2779-4E1A-A115-2A38B7F39999Voice guidance can be activated or deactivated.
NRG00811. Push .
2. Highlight [Guidance Settings] and push
.
NGT00493.Highlight [Guidance Voice] and push
. The indicator illuminates if voice
guidance is activated.
Getting started2-23
SETTING VOICE GUIDANCE

Black plate (32,1)
[ Edit: 2012/ 4/ 11 Model: 08NJ-N ]
2-24Getting started
Other settingsGUID-2B911867-C483-4661-AFB0-53B4A2B9F40FVoice guidance can also be activated or
deactivated using the following procedure.
NGT00501. Push.
2. Highlight [Volume & Beeps] and push
.
3. Highlight [Guidance Voice] and push
.
ADJUSTING VOICE GUIDANCE VO-
LUME
GUID-82DCD0CE-A113-4FA5-B49F-E36EC0E9D794The voice guidance volume can be adjusted.
NRG0081
1. Push .
2. Highlight [Guidance Settings] and push
.
NGT00513.Highlight [Guidance Volume] and push
.
NGT00524. Adjust the volume of voice guidance by
using the multi-function controller.
Other settingsGUID-9B02ECDC-6640-4828-BA30-A00F6055F314Voice guidance volume can also be adjusted
using the following procedure.
NGT00531. Push .
2. Highlight [Volume & Beeps] and push
.
3. Highlight [Guidance Volume] and push
.
4. Adjust the volume of voice guidance by using the multi-function controller.
INFO:
The volume can also be adjusted by turning the
audio system volume control knob or pushing
+/− on the steering wheel switch while voice
guidance is being announced.
“Steering wheel switch” (page 2-5)

Black plate (51,1)
[ Edit: 2012/ 4/ 11 Model: 08NJ-N ]
NMA0020Example: The widest level (2D map)
NMA0052Example: The most detailed level (BirdviewTMmap)
NMA0021Example: The widest level (BirdviewTMmap)
INFO:
The traffic information icons are not displayed on
the map screen when the map scale is set to 32
miles (64 km) or higher.
“Traffic information display and scale le-
vels” (page 7-7)
GUID-6C1CB013-9699-497C-9B99-0E3C35B4B19BThe map view can be changed between the 2D
and BirdviewTMmaps. The map can also be
displayed in the split screen mode.
NMA00221. Push while the current location
map screen is displayed.
NMA00232. Highlight [Map View] and push .
Map settings3-11
CHANGING MAP VIEW

Black plate (52,1)
[ Edit: 2012/ 4/ 11 Model: 08NJ-N ]
3-12Map settings
NMA00243. Highlight [Change View] and push the rightbutton of the directional buttons.
4. Highlight the preferred map view and push . The indicator of the selected
map view illuminates.
5. The display automatically returns to the map screen.
AVAILABLE VIEWSGUID-3846B375-BC2C-4941-B1CA-70825D89A947.[2D map]:
Switches to the 2D map.
. [Birdview (3D)]:
Switches to the Birdview
TMmap.
. [Split: 2D Map]:
Changes to the split screen mode and both
halves display maps in 2D.
. [Split: Birdview
TMMap]:
Changes to the split screen mode and the
left half displays the map in 2D and the right half displays the map in Birdview
TM.
INFO:
. When the split screen mode is selected, the
map settings for the left screen can be
changed independently.
“Setting left screen display”
(page 3-17)
. If the split screen mode is selected, the
normal map scrolling and scale adjustment
are set in the right screen. However, if an
icon is touched before adjusting the map
direction or scale, then each screen can be
adjusted independently.
NMA0025Split: 2D Map
NMA0026Split: BirdviewTMMap
OTHER SETTINGSGUID-80415649-C47F-4665-B7AB-B3843E261AB5The map view can also be set using the
following procedure.
NMA00271. Push .
2. Highlight [Navigation] and push .
3. Highlight [Map View] and push .
4. Highlight [Change View] and push
.
5. Highlight the preferred item and push
.

Black plate (53,1)
[ Edit: 2012/ 4/ 11 Model: 08NJ-N ]
Voice command
1. Push >located on the steering
wheel switch.
2. After the tone sounds, speak a command.
.To display the 2D map: “Plan View map” (Alternate command
mode)
.To display the BirdviewTMmap:
“Birdview map” (Alternate command
mode)
GUID-5D0C353F-6EAA-4917-B80D-BC1735C32503Other settings are also available for the map
screen, such as changing the map direction,
map color, Birdview
TMangle, etc.
BASIC OPERATIONGUID-A06644B4-1731-4EE3-985A-6B23CAD63C5C
NMA00221. Push while the current location
map screen is displayed.
NMA00232. Highlight [Map View] and push .
NMA00283.Highlight [Map Settings] and push
.
NMA00294.Highlight the preferred item and push
.
Available setting itemsGUID-39500D60-8341-4077-857D-1E1246FC5EF6.[Map Orientation]:
Set the map direction to North up or
Heading Up.
“Setting map orientation” (page 3-14)
. [Long Range]:
Set the long range map view display ON/
Map settings3-13
SETTING THE MAP VIEW

Black plate (54,1)
[ Edit: 2012/ 4/ 11 Model: 08NJ-N ]
3-14Map settings
OFF.
“Settings long range map view”
(page 3-15)
. [Map Color]:
Change the map color.
“Setting map color ” (page 3-15)
. [Birdview Angle]:
Change the Birdview
TMangle.
“Changing BirdviewTMangle”
(page 3-16)
. [Left Split Map Settings]:
Set the map settings for the left screen of
the split map.
“Setting left screen display”
(page 3-17)
. [Show all Freeway Exits on Route]/[Auto.
Show Turn List on Freeway]:
Set the display of the freeway exit informa-
tion ON/OFF.
“Show exit information on freeways”
(page 5-10)
Other settingsGUID-A468C1A1-02E5-4654-885A-EB02E6FE218FThe orientation of the map can also be set using
the following procedure.
NMA00271. Push .
2. Highlight [Navigation] and push .
3. Highlight [Map View] and push .
SETTING MAP ORIENTATIONGUID-0F839399-3855-4BDC-92AC-A14A6FD1246AThe map direction (orientation) can also be
changed in the 2D map. These settings are
available only in the 2D map or 2D/2D split map.
NMA0029
1.Highlight [Map Orientation] and push
.
2. Highlight the preferred map orientation and push . The indicator of the
selected map orientation illuminates.
3. Push