check engine NISSAN CUBE 2013 3.G Quick Reference Guide

NISSaN INTeLLIGeNT KeY® SYSTeM (if so equipped)
The NISSAN Intelligent key® System allows you to lock or
unlock the vehicle, open the back door and start the engine.
NOTE: It is important to make sure the Intelligent
key is
with you (that is, in your poc

ket or purse).
The operating range of the Intelligent key is within
31.5 in (80 cm) from eac
h request switch.
To lock the vehicle, push either door handle request
switch 01 , push the back door request switch
02 ,
or press the
button
03 on the keyfob.
To unlock the vehicle, perform one of the

following procedures:
• Push either door handle request switch 01 once
or
the back door request switch 02 once; the
corresponding door will unlock. Push the request



switch again within 1 minute; all other doors




will unlock, or
• Press the button
04 on the keyfob to unlock
th
e driver’s side door. Press the button again;
all other doors will unlock.
The Intelligent key can also be used to activate the
panic alarm by pressing and holding the button
05
for more than 1 second. Once activated, the panic
alarm and headlights will stay on for 25 seconds.
I

NTELLIGENT
kEY BATTE

RY DIS
cHARG

E
If the battery of the Intelligent key is discharged, or
environmental conditions interfere with the Intelligent




k
ey operation, start the engine according to the

following procedure:
1. Move the shift lever to the P (ParK) position.
2. Firmly apply the foot brake.
3. Touc

h the ignition switch with the Intelligent
key



and a chime will sound.
4. Within 1

0 seconds after the chime sounds, push the ignition switch while depressing the



brake pedal and the engine will start.
For more information, refer to the “Pre-driving checks and adjustments (section 3)” , the “Starting and driving (section
5)” and the “Maintenance and do-it yourself (section 8)” of your Owner’s Manual.
4
first drive features
01
02
03
04
05
To view detailed instructional videos regarding these and other features,
please go to www.nissanownersinfo.mobi.
1221378_13a_Cube_QRG_092112.indd 810/2/12 9:25 AM

OuTSIDe MIrrOr CONTrOL SwIT CH
The outside mirror control switch is located on the
left side of the instrument panel.
To select the left or right mirror, move the switch
01 .
Adjust each mirror to the desired position using

the switch
02 .
To prevent accidentally moving the mirror, move this
switch
01 to the center “neutral” position.
For more information, refer to the “Pre-driving checks and adjustments
(section 3)” of your Owner’s Manual.
6
first drive features
FOLDING DOWN THE REAR BENcH SEAT
To fold the seats flat, secure the seat belts on
the seat belt hooks on the side wall. Release the
connector tongue of the rear center seat belt from
the buckle, then store the connector and seat belt


tongues on the seat belt hook.
Before folding down the seatback, tuck the seat belt
buckles into the seat cushion poc

kets.
Fold the seatback down by pulling the adjusting strap 01 .
To raise the seatback, lift up each seatback and push it to the upright position until it is latched.
After raising the seatback, pull the seat belt buc
kles out of the seat cushion pockets until they
are fully extended before using the seat belts.
For more information, refer to the “Safety — Seats, seat belts and supplemental restraint system (se\
ction 1)” of your
Owner’s Manual.
01
02
01
STarTING/STOPPING THe eNGINe
CONTINuOuSLY VarIaB Le TraN SMISSION
(NISS
aN Intelligent K
ey® models only - if so equipped)
Depress the brake pedal.
Move the shift lever to the P (ParK) position.
Push the ignition switch to start the engine.
NOTE: It is important to make sure the Intelligent
key is
with you (that is, in your poc

ket or purse).

TURNING THE ENGINE OFF
Move the shift lever to the P (ParK) position, apply
the parking brake and push the ignition switch.
To view detailed instructional videos regarding these and other features,
please go to www.nissanownersinfo.mobi.
1221378_13a_Cube_QRG_092112.indd 1010/2/12 9:26 AM