NISSAN FRONTIER 2007 D22 / 1.G Quick Reference Guide

seat Belt warning light and chiMe
 The light and chime remind you to fasten your seat belts. The
light illuminates whenever the ignition key is turned to the ON
or START position and remains illuminated until the driver’s
seat belt is fastened. At the same time, the chime sounds
for approximately 6 seconds unless the driver’s seat belt is
securely fastened.
 The seat belt warning light may also illuminate if the front passenger’s seat belt is
not fastened when the front passenger’s seat is occupied. For 7 seconds after the
ignition switch is in the ON position, the system does not activate the warning light
for the front passenger.
Refer to the Owner’s Manual for detailed information regarding seat belt usage.
tire Pressure Monitoring s Y ste M (tPM s)
This system monitors tire pressure. Please remember, this system
does not detect a sudden drop in tire pressure (for example, a
blowout while driving). It also does not monitor the air pressure in
the spare tire.
Tire pressure is affected by temperature. Low outside temperature
causes lower tire pressure. This may cause the low tire pressure
warning light to illuminate.
If the low tire pressure warning light illuminates, check the tire pressure in all four tires.
To turn the low tire pressure warning light off, adjust the low tire pressure to the
recommended COLD tire pressure shown on the Tire and Loading Information label
located in the driver’s door opening.
If TPMS is not functioning properly, the low tire pressure warning light will flash for
approximately 60 seconds when the key is turned on. After 60 seconds, the light will
remain on. Have the system checked by a NISSAN dealer.
child safet Y rear door loc K
( c rew cab Model only)
Child safety locks help prevent the rear doors from being opened
accidentally, especially when small children are in the vehicle. The
child safety lock levers are located on the edge of the rear doors.
When the lever is in the LOCK position, the door can be opened
only from the outside.

front seat adJust Ments
With Manual Seats (if so equipped):
 Pull up on the lever under the front of the seat and
slide backward or forward. Release the lever to lock
the seat in position.
 Lift the lever 01 on the side of the seat to adjust
your seatback forward or backward; release when
you have found a comfortable angle and the seat
belt fits properly.
 Turn either dial 02 to adjust the angle and height of
the seat cushion to the desired position.
With Power Seats (if so equipped):
 Move the control 03 forward or backward to adjust
the seat cushion forward or backward.
 Pull up 03 to raise the seat cushion; press down
to lower the cushion.
 Push the switch 04 forward to move the seatback
forward; push it back to move the seatback
backward.
LUMBAR SUPPORT (if so equipped)
Your driver’s seat has a lumbar support; adjust it by moving the lever 05 up or down.
01
02
0304
05
front -Passenger air Bag status light
This vehicle is equipped with the Nissan Advanced Air Bag system.
Under some conditions, depending on the type of occupant or
object detected in the front passenger seat by the occupant
classification sensor, the front-passenger air bag is designed to
automatically turn OFF. When the front-passenger air bag is OFF,
the front-passenger air bag status light will illuminate*. For example:
 When the system detects that the front-passenger’s seat is occupied by a small adult,
child or child restraint as outlined in the Owner’s Manual, the will illuminate to
indicate that the front-passenger air bag is OFF and will not inflate in a crash.
 When the front-passenger’s seat is occupied and the passenger meets the conditions
outlined in the Owner’s Manual, the will not illuminate to indicate that the front-
passenger air bag is operational.
*When the system detects that the front-passenger’s seat is unoccupied, the
passenger air bag status light will not illuminate even though the front-passenger
air bag is OFF.
Refer to the Owner’s Manual for detailed information regarding the Nissan Advanced Air
Bag System.

fold flat front P assenger seat
(if so equipped)
To fold the front passenger’s seatback flat for extra
storage length when transporting long items:
 Slide the seat to the rearmost position. Lift up on
the recline lever, located on the outside edge of
the seat, and fold the seatback forward as far as
it will go. 01 Then lift up on the latch located on the upper corner of the seatback to
release the back of the seat. 02
0201
folding the rear B ench seat
( c rew cab Model only)
FOLDING THE SEATBACK DOWN :
To fold the rear bench seatback down to access the
jacking tools, pull up on the straps 01 located on the
outer edge of the seatbacks and fold the seatback
forward.
FOLDING THE SEAT BASE UP:
To fold the rear bench seat base up to access the
under-seat storage bins:
 Lift up on the lever 02 located on the side of the
seat, while lifting up the front of the seat cushion.
 Fold the bottom of the seat cushion toward the
back of the vehicle until it locks into place.
 Repeat this process to raise and secure the seat
cushion on the other side of the vehicle.
01
02

This easy-to-use Quick Reference Guide is intended to help you more fully appreciate some of the unique features and functions of your new vehicle. However, it is not intended to replace your Owner’s Manual. The Owner’s Manual contains more detailed information to help you better understand the important safety warnings, features, operation, and
maintenance of your vehicle.
QR7E-0D40U1 Printing: January 2007 (08)
Nissan, the Nissan Brand Symbol, “SHIFT_ ” tagline, Z and Nissan model names are Nissan trademarks. ©2007 Nissan North America, Inc.
Sh ift_
reMote K eY less entrY sY ste M
(if so equipped)
LOCK DOORS
Press the LPD0150 button to lock all doors.
UNLOCK DOORS
Press the lpd0151 button once to unlock the driver’s
door only. Press the button again within 5
seconds to unlock all doors.
U SING THE PANIC ALARM
Press and hold the button for longer
than 0.5 seconds. The panic alarm will sound and the headlights will stay on for
25 seconds. The panic alarm stops when it has run for 25 seconds, or any button
is pressed on the keyfob.
S ILENCING THE HORN BEEP FEATURE
 To deactivate – Press and hold the LPD0150 and lpd0151 buttons for at least 2 seconds.
 To activate – Press and hold the LPD0150 and lpd0151 buttons for at least 2 seconds.