AUX NISSAN FRONTIER 2007 D22 / 1.G Quick Reference Guide

steering wheel switches for audio control
instru Ment Brightness
control /tri P change Button
tire
Pressure
M onitoring s Y ste M (tPM s)
0203
05
hood release* front -Passenger
air Bag status light
cruise control
06
0809
four wheel dri Ve
(4 wd ) shift switch
cli
Mate controls
1112
02
06
04
03
01
11
05
1410
08
13
07
windshield wi Per /
washer switch
headlight and turn signal control
01
04
steering wheel tilt
ad Just Ment *
07
e-loc K switch
audio
s Y ste M
10
13
09
*See your Owner’s Manual for more information.
12
15
auXiliar Y audio
in Put Jac K *
hill
descent
control switch
1415

steering wheel switches for audio control
(if so equipped)
 Press the POWER button to turn the audio system on or
off.
 To choose preset radio stations A, B, C, CD and AUX
press MODE repeatedly.
 The tuning up or down switch can be used to perform
the following:
• Push the
switch for less than 1.5 seconds to change to a preset station.
• Push and hold the
switch for more than 1.5 seconds to seek the next or previous

broadcasting radio station.
• Push the
switch while playing a CD (if so equipped) for less than 1.5 seconds to

change tracks on the CD.
• If the vehicle is equipped with a CD changer, push and hold the
switch for more

than 1.5 seconds to change between CDs.
utilit Y Bed with sPra Y-on B ed liner
and utili -trac K ™ sY ste M (if so equipped)
The Utili-track™ channel system allows you to move
tie-down clamps in the bed to the best location to
secure a load.
 The tie-down cleats must be installed so the
clamp is properly seated in the notches in the
rail. If the tie-down cleat is not seated in the
notches, it will not be flush with the rail and
cannot be properly tightened. The bolt in the center of the cleat must be tightened
hand-tight (20 – 40 inch pounds).
 Check the tightness of the tie-down cleat periodically during a trip to make sure the
center bolt has not become loose.
 The channel end stoppers can be used to help prevent cargo from sliding or shifting
off the end of the truck bed. They must be installed so they are properly seated in the
detents in the channel.
Refer to your Owner’s Manual for loading limits and tie-down recommendations.
instru Ment B rightness control/tri P
change B utton
The instrument brightness control operates when the
headlight control switch is in the or position.
Turn the control to adjust the brightness of the
instrument panel lights.
Press the change button to select trip computer
features. See “Trip Computer” in the next column of this
Quick Reference Guide for more information.

PRESET A.B.C BUTTON
Press the PRESET A · B · C button until you reach the desired setting. The radio is
equipped with three separate banks, each with six station presets. You may store
any combination of FM, AM or SAT* radio presets on each bank.
SEEK /TRACK BUTTON
To scan quickly through each broadcasting station, press and hold the SEEK/
TRACK button. To skip from one track to another on a CD, press the SEEK/
TRACK button. Each time the button is pressed, the CD will advance or skip back
one track.
AUX BUTTON
Press the AUX button to play a compatible device such as an MP3 player when it
is plugged into the auxiliary jack located above the power outlet.
SCAN RPT BUTTON
Press the SCAN RPT button to stop at each broadcasting station (FM, AM or
SAT*) for 5 seconds. Pressing the button again during this 5-second period will
stop scan tuning and the radio will remain tuned to that station. If the SCAN RPT
button is not pressed within 5 seconds, scan tuning moves to the next station.
CAT FOLDER BUTTON
 To manually tune the radio, press the CAT FOLDER button.
 When the CAT FOLDER button is pressed while a CD is playing it will fast
forward or rewind. When the button is released, the CD will play at normal
speed.
f
M/ aM/ sat * radio with cd changer
(if so equipped)
05
04
03
02
01
02
01
0403
0706
08
05
09
07AIR R ECIRCULATION BUTTON (if so equipped)
 Press the air recirculation button to recirculate air inside the vehicle.
 Press the air recirculation button again to turn air recirculation off.
 The air recirculation mode cannot be selected if the air flow control dial is in
the defrost position .