oil reset NISSAN GT-R 2015 R35 Owners Manual

.Adjust the power steering fluid level to the R
�fark
*5on the power steering dipstick
when the fluid te�fperature is hot or
*6
when the fluid te�fperature is cold�b
Fluid te�fperature:
Hot: 122 to 1768F (50 to 808C): between
*1and*5
Cold: 32 to 868F (0 to 308C): between*3
and*6
Coolant level and mixture ratio
The information and specifications in this
section apply only when engaging in
performance driving. Check the coolant level in the pressurized
coolant reservoir�b Adjust the level so that the
fluid is between the MAX and MIN �farkings�b For
the coolant, use genuine NISSAN Long Life
coolant�b (On delivery of new vehicle, the
reservoir is filled to the MIN level�b Be sure to
replenish approxi�fately 3/8 US quart (0�b3 to 0�b4
liter) of coolant�b)
NOTICE
Do not overfill the coolant. This may
increase the pressure in the cooling
system and cause coolant leaks.
To �faxi�fize vehicle perfor�fance, the coolant
�fixture ratio should be a co�fbination of 30%
coolant antifreeze and 70% de�fineralized or
distilled water for �faxi�fu�f cooling syste�f
perfor�fance regardless of a�fbient te�fpera-
tures�b
If a�fbient te�fperatures are anticipated below
58F( í158C) , �fake sure a proper �fixture ratio of
50% antifreeze and 50% de�fineralized or
distilled water �fix is used�b
Engine and powertrain
The information and specifications in this
section apply only when engaging in
performance driving.
. Check the engine, trans�fission, differential
and under the vehicle for oil and coolant
leaks�b
. Inspect the areas surrounding of the cata-
lytic converter for heat deterioration�b
. Always perfor�f the trans�fission setting�b
After that, adjust the clutch clearance so
that the clearance is less than the clearance
used for daily driving�b Your GT-R certified
NISSAN dealer has the necessary infor�fa-
tion and equip�fent to set the clutch
clearance to the correct specification�b The
clearance used for daily driving increases
clutch heat generated during Perfor�fance
Driving�b This leads to an increase in te�f-
perature of the trans�fission oil�b In addition, a
�fore direct shifting feel can be obtained by
reducing the clutch clearance for Perfor-
�fance Driving�b The clutch clearance should
be reset to the daily driving specification
after Perfor�fance Driving�b See your GT-R
certified NISSAN dealer for infor�fation�b
GT-R OverviewGTR-15

switchto change the mileage. Push and
hold the switch to increase the number e�fery
600 miles �b1,000 km) .
. Set to “—” to set no reminders.
. To reset the accumulated mileage to zero,
go to the RESET screen, then push the
NEXT switch
and confirm with the
ENTER switch.
NOTE:
. To restore the mileage to the original
figure after resetting, push the NEXT
switch
again.
. When the battery terminal is discon-
nected, the set mileage will be erased
and the settings will return to their
default settings.
Engine oil level:
This can be used to check the pre-start oil le�fel
while the engine is running. Select SETTING >
MAINTENANCE > OIL > ENGINE OIL >
LEVEL.
If the low le�fel reminder appears, check the le�fel
using the engine oil dipstick. �b
“Checking
engine oil le�fel” page 8-13)
Engine oil:
When the customer set mileage approaches,
the reminder will appear on the display and the
remaining distance is displayed at regular
inter�fals. Select SETTING > MAINTENANCE
> OIL > ENGINE OIL to set or reset the mileage
for the engine oil change.
NOTE:
The default setting is 9,500 miles (15,000
km) . The maximum mileage that can be set
is 9,500 miles (15,000 km) .
Instruments and controls2-21

2-22Instruments and controls
Engine oil filter:
The reminder is displayed when the cust�fmer
set mileage is exceeded. �belect �bETTING >
MAINTENANCE > FILTER t�f set �fr reset the
mileage f�fr the engine �fil filter change.
NOTE:
The default setting is 9,500 miles (15,000
km) . The maximum mileage that can be set
is 9,500 miles (15,000 km) .Transmission oil:
The reminder is displayed when the cust�fmer
set mileage is exceeded. �belect �bETTING >
MAINTENANCE > OIL > T/M OIL t�f set �fr
reset the mileage f�fr the transmissi�fn �fil
change.
NOTE:
The default setting is 37,000 miles (60,000
km) . The maximum mileage that can be set
is 55,500 miles (90,000 km) .Tires:
This reminder appears when the cust�fmer set
distance c�fmes f�fr maintaining tires. Y�fu can
set �fr reset the distance f�fr maintaining tires.
(�bee
“�betting (drive c�fmputer)” page 2-19
earlier in this secti�fn.)
WARNING
The tire maintenance indicator is not a
substitute for regular tire checks, in-
cluding tire pressure checks. See
“Changing wheels and tires” in the “8.
Maintenance and do-it-yourself” sec-
tion. Many factors including tire infla-