engine NISSAN GT-R 2018 Owner's Manual

Oil additivesNISSAN does not recommend the use of
oil additives. The use of an oil additive is
not necessary when the proper oil type is
used and maintenance intervals are fol-
lowed.
Oil which may contain foreign matter or
has been previously used should not be
used.Oil viscosityThe engine oil viscosity or thickness
changes with temperature. Because of
this, it is important that the engine oil
viscosity be selected based on the tem-
peratures at which the vehicle will be
operated before the next oil change.
Choosing an oil viscosity other than that
recommended could cause serious en-
gine damage.Selecting the correct oil filterYour new vehicle is equipped with a high-
quality genuine NISSAN oil filter. NISSAN
recommends to use the genuine NISSAN
oil filter for the reason described in
change intervals.
Change intervals

Engine coolant temperature gauge ........ 2-8
Coolant level and mixture ratio ................ GTR-15
Corrosion protection ................................................... 7-9
Cracks on brake pad ......................................... GTR-26
Cracks on the disc rotors .............................. GTR-26
Cruise control ................................................. 2-17, 5-34
Cruise control operations .................................... 5-36
Cruise control system warning ....................... 2-42
Cup holders ..................................................................... 2-59
Current fuel consumption ................................... 2-16
D

NOTICE
If the gauge indicates engine coolant
temperature near the hot (H) end of
the normal range, reduce vehicle
speed to decrease temperature. If
gauge is over the normal range, stop
the vehicle as soon as safely possi-
ble. If the engine is overheated,
continued operation of the vehicle
may seriously damage the engine.
(

other reproductive harm. To mini-
mize exposure, avoid breathing ex-
haust, do not idle the engine except
as necessary, service your vehicle in
a well-ventilated area and wear
gloves or wash your hands fre-
quently when servicing your vehicle.
For more information go to www.
P65Warnings.ca.gov.
CALIFORNIA PERCHLORATE ADVI-
SORYSome vehicle parts, such as lithium
batteries, may contain perchlorate ma-
terial. The following advisory is pro-
vided: “Perchlorate Material - special
handling may apply, See www.dtsc.ca.
gov/hazardouswaste/perchlorate.”

NOTICE
It is recommended that you only use
the following specified fluids and
parts in the GT-R to avoid possible
vehicle damage.ENGINE OILMobil 1 (0W-40) (100% synthetic oil)
Mobil 1 (0W-40) (100% synthetic) is the
factory fill oil. The VR38 engine with its
plasma-sprayed bores was developed
using this oil. NISSAN cannot ensure
proper engine operation and durability if
other synthetic oil is used. If Mobil 1 (0W-
40) is not available, Mobil 1 (10W-40) (100%
synthetic) may be used; however, some
performance loss may be noticed.
Furthermore, replacement of the engine
oil with MOTUL NISMO COMPETITION OIL
type 2193E(5W40) is recommended for
the frequent high performance driving
opportunities.
NISSAN cannot ensure proper engine
operation and durability if other synthetic
oil is used.
The use of additives, chemical materials
or abrasive compounds is prohibited.The use of additives, chemical materials,
abrasive compounds or other high per-
formance engine oils may cause internal
engine damage.
Engine oil maintenance

Cool downThe information and specifications in
this section apply only when engaging
in performance driving.
Cool down the vehicle to help extend the
life of the vehicle if coolant temperatures
are extremely high. Drive the vehicle at 37
to 50 MPH (60 to 80 km/h), in 5th or 6th
gear for 2 to 3 miles (3 to 5 km) and then
stop the engine.Refueling precautions

Coolant level and mixture ratioThe information and specifications in
this section apply only when engaging
in performance driving.
Check the coolant level in the pressurized
coolant reservoir. Adjust the level so that
the fluid is between the MAX and MIN
markings. For the coolant, use genuine
NISSAN Long Life coolant. (On delivery of
new vehicle, the reservoir is filled to the
MIN level. Be sure to replenish approxi-
mately 3/8 US quart (0.3 to 0.4 liter) of
coolant.)
NOTICE
Do not overfill the coolant. This may
increase the pressure in the cooling
system and cause coolant leaks.
To maximize vehicle performance, the
coolant mixture ratio should be a combi-
nation of 30% coolant antifreeze and 70%
demineralized or distilled water for max-
imum cooling system performance re-
gardless of ambient temperatures.
If ambient temperatures are anticipated
below 5°F (−15°C), make sure a proper
mixture ratio of 50% antifreeze and 50%
demineralized or distilled water mix is used.
Engine and powertrainThe information and specifications in
this section apply only when engaging
in performance driving.
.
Check the engine, transmission, differ-
ential and under the vehicle for oil and
coolant leaks.
. Inspect the areas surrounding of the
catalytic converter for heat deteriora-
tion.
. Always perform the transmission
setting. After that, adjust the clutch
clearance so that the clearance is less
than the clearance used for daily
driving. Your GT-R certified NISSAN
dealer has the necessary information
and equipment to set the clutch
clearance to the correct specification.
The clearance used for daily driving
increases clutch heat generated dur-
ing Performance Driving. This leads to
an increase in temperature of the
transmission oil. In addition, a more
direct shifting feel can be obtained by
reducing the clutch clearance for
Performance Driving. The clutch clear-
ance should be reset to the daily
driving specification after Perfor-
mance Driving. It is recommended you see a GT-R certified NISSAN dealer
for information.
NOTICE
Failure to have the clutch properly
adjusted before performance driving
may cause the transmission oil tem-
perature to increase which may
cause transmission damage.
. Inspect and confirm the clearance
between the exhaust finisher and rear
bumper is more than 0.24 in (6 mm)
(up/down) and more than 0.20 in (5
mm) (left/right).
. Inspect the dust boot of the drive
shaft universal joint for cracks or
damage.Suspension and wheel alignmentThe information and specifications in
this section apply only when engaging
in performance driving.
.Check the steering and suspension
system and other links for loose and/
or damaged parts.
. Measure and adjust the wheel align-
ment. (

in this section for 48 hours after tires
are installed on the wheels. The tire
may slip on the wheel if the vehicle is
driven in these conditions before 48
hours have passed. If the tire slips on
the wheel, the wheel/tire assembly
will be out of balance and will require
rebalancing.
BrakesThe information and specifications in
this section apply only when engaging
in performance driving.
.Check for the heat deterioration of the
brakes and parts around the brakes.
. It is recommended that you remove
air from the brake system after any of
the following:
— When engaging in high perfor-
mance driving for the first time
after purchasing a new vehicle.
— After replacing the brake fluid.
— When engaging in high perfor- mance driving for a sustained per-
iod of time. It is recommended that
bleeding the brake be performed
when the brake calipers are hot
(about 212°F (100°C)). Brake pad break-in procedure:
NISSAN recommends that a special brake
pad break-in procedure be performed
before engaging in performance driving.
It is recommended you contact a GT-R
certified NISSAN dealer for details.
INSPECTION AND ADJUSTMENTS
AFTER DRIVINGThe information and specifications in
this section apply only when engaging
in performance driving.
NOTICE
At the completion of performance
driving, all fluid and other adjust-
ments should be returned to the
normal fluid specifications as shown
in the “Maintenance and do-it-your-
self” section of this manual.FluidsThe information and specifications in
this section apply only when engaging
in performance driving.
.
Check the engine, transmission, differ-
ential and under the vehicle for oil and
coolant leaks. .
Check the fluid levels and adjust as
necessary using the specified fluid as
described under the conditions listed
in this section. (

engine for more than 20 seconds
without depressing the brake pedal.
This allows the brake pads to move
away from the rotor so the pad does
not contact the rotor.
Additionally, the brakes must be dry
before parking the vehicle after driv-
ing on wet roads or after washing the
vehicle. If the roads are wet, lightly
apply the brakes for a short distance
before parking the vehicle to dry the
brakes. After washing the vehicle, dry
the brakes by driving on a dry road for
a few miles and apply the brakes
normally based on traffic and road
conditions.
The metallic brake pads and brake
disc rotor may rust together when the
brakes are not applied:
— If the vehicle is not idled for 20seconds without the brakes ap-
plied, or if the brakes are applied
when the vehicle is shut off, the
rotor and pads can rust together,
even when the brake pads are dry.
— If the brakes are wet when the vehicle is parked and the parking
brake is applied for a long time.
— The hill start assist system can apply the brakes even if the brake
pedal is not depressed. The brake
pads and rotors can rust together if the parking procedure previously
described is not followed.
It is recommended you contact a GT-R
certified NISSAN dealer if the brake
pads and brake rotor have rusted
together.
NOTICE

0 Illustrated table of contentsSeats, seat belts and Supplemental Restraint
System (SRS).................................................................................... 0-2
Front ................................................................................................ 0-2
Rear .................................................................................................. 0-3
Exterior front ................................................................................... 0-4
Exterior rear ..................................................................................... 0-5 Passenger compartment ...................................................... 0-6
Cockpit ................................................................................................ 0-7
Instrument panel ........................................................................ 0-8
Meters and gauges ................................................................... 0-9
Engine compartment ........................................................... 0-10
Warning and indicator lights .......................................... 0-11