NISSAN GT-R 2018 Owners Manual

in this section for 48 hours after tires
are installed on the wheels. The tire
may slip on the wheel if the vehicle is
driven in these conditions before 48
hours have passed. If the tire slips on
the wheel, the wheel/tire assembly
will be out of balance and will require
rebalancing.
BrakesThe information and specifications in
this section apply only when engaging
in performance driving.
.Check for the heat deterioration of the
brakes and parts around the brakes.
. It is recommended that you remove
air from the brake system after any of
the following:
— When engaging in high perfor-
mance driving for the first time
after purchasing a new vehicle.
— After replacing the brake fluid.
— When engaging in high perfor- mance driving for a sustained per-
iod of time. It is recommended that
bleeding the brake be performed
when the brake calipers are hot
(about 212°F (100°C)). Brake pad break-in procedure:
NISSAN recommends that a special brake
pad break-in procedure be performed
before engaging in performance driving.
It is recommended you contact a GT-R
certified NISSAN dealer for details.
INSPECTION AND ADJUSTMENTS
AFTER DRIVINGThe information and specifications in
this section apply only when engaging
in performance driving.
NOTICE
At the completion of performance
driving, all fluid and other adjust-
ments should be returned to the
normal fluid specifications as shown
in the “Maintenance and do-it-your-
self” section of this manual.FluidsThe information and specifications in
this section apply only when engaging
in performance driving.
.
Check the engine, transmission, differ-
ential and under the vehicle for oil and
coolant leaks. .
Check the fluid levels and adjust as
necessary using the specified fluid as
described under the conditions listed
in this section. (

If the temperature is lower than approxi-
mately 158°F (70°C), drive the vehicle until
it reaches normal operating temperature.
If the temperature is higher than 230°F
(110°C), perform cool-down driving proce-
dure. (

engine for more than 20 seconds
without depressing the brake pedal.
This allows the brake pads to move
away from the rotor so the pad does
not contact the rotor.
Additionally, the brakes must be dry
before parking the vehicle after driv-
ing on wet roads or after washing the
vehicle. If the roads are wet, lightly
apply the brakes for a short distance
before parking the vehicle to dry the
brakes. After washing the vehicle, dry
the brakes by driving on a dry road for
a few miles and apply the brakes
normally based on traffic and road
conditions.
The metallic brake pads and brake
disc rotor may rust together when the
brakes are not applied:
— If the vehicle is not idled for 20seconds without the brakes ap-
plied, or if the brakes are applied
when the vehicle is shut off, the
rotor and pads can rust together,
even when the brake pads are dry.
— If the brakes are wet when the vehicle is parked and the parking
brake is applied for a long time.
— The hill start assist system can apply the brakes even if the brake
pedal is not depressed. The brake
pads and rotors can rust together if the parking procedure previously
described is not followed.
It is recommended you contact a GT-R
certified NISSAN dealer if the brake
pads and brake rotor have rusted
together.
NOTICE