transmission NISSAN JUKE 2011 F15 / 1.G Warranty Booklet

Nissan makes available to you, and you are specifi-
cally required by Federal Law to use BBB AUTO
LINE [(800) 955-5100] before exercising rights or
seeking remedies under the Federal Magnuson-
Moss Warranty Act, 15 U.S.C. §2301, et. seq. You
are not required to first use BBB AUTO LINE if you
seek remedies not created by Title I of that Federal
law, except that you are required to first use BBB
AUTO LINE in good faith if you seek remedies cre-
ated by state law, including your state’s lemon law,
if applicable state law provides for using a 703
compliant or similar process before filing suit.
Please refer to pp. 2-3 of this booklet and the
Supplement to 2011 Nissan Warranty Information
Booklet & 2011 Nissan Owner’s Manualfor addi-
tional information.
THE WARRANTY BEGINS
The warranty period begins on the date the vehicle is
delivered to the first retail buyer or put into use, which-
ever is earlier.
FOR HOW LONG AND WHAT IS
COVERED
BASIC COVERAGE
The basic coverage period is 36 months or
36,000 miles, whichever comes first.
This warranty covers any repairs needed to
correct defects in materials or workmanship of
all parts and components of each new Nissan
vehicle supplied by Nissan except for the exclu-
sions or items listed under the caption “WHAT
IS NOT COVERED” or, if the part is covered by
one of the separate coverages described in the
following sections of this warranty, that specific
coverage applies instead of the basic cover-
age.
Bedliners will be repaired to commercially ac-
ceptable standards subject to the conditions
and limitations listed in WHAT IS NOT COV-
ERED.
POWERTRAIN COVERAGE
The Powertrain coverage period is 60 months
or 60,000 miles, whichever comes first.
This warranty covers any repairs needed to
correct defects in materials or workmanship.
Powertrain coverage applies to components
listed below, supplied by Nissan except for
those items listed under the caption “WHAT IS
NOT COVERED”.
ENGINE
Cylinder heads and block and all internal parts,
rocker covers and oil pan, valve train and front
cover, timing chain and tensioner, oil pump, water
pump and fuel pump, fuel injectors, intake and
exhaust manifolds and supercharger, flywheel,
seals, and gaskets. TRANSMISSION AND TRANSAXLE
Case and all internal parts, torque converter and
converter housing, automatic transmission control
module, transfer case and all internal parts, seals
and gaskets, clutch cover and housing, and elec-
tronic transmission controls.
DRIVETRAIN
Drive shafts, final drive housing and all internal
parts, propeller shafts, universal joints, bearings,
seals and gaskets.
RESTRAINT SYSTEM
Air bags and related electronic control systems.
CORROSION COVERAGE (PERFORATION
FROM CORROSION)
Any body sheet metal panel supplied by Nissan
found to have developed perforation (rust-
through) due to corrosion in normal use is covered
for 60 months, regardless of mileage, except for
those items listed under “WHAT IS NOT COV-
ERED”. No additional rust proofing applications
are required. Perforation is a condition in which
any body sheet metal panel has corroded from one
surface through to another.
TOWING COVERAGEIf your vehicle is inoperative due to the failure of a
warranted part, towing service to the nearest au-
thorized Nissan dealer is covered for 36 months or
36,000 miles, whichever comes first.
(Continued on next page)
6 2011 NEW VEHICLE LIMITED WARRANTY

LONG-TERM EMISSION SYSTEM
DEFECTS WARRANTY PARTS LIST
EGI Wiring
Harness
Throttle Body
Intake Manifold
Engine Control
Module
o
Fuel Tank
Exhaust Manifold
w/Catalytic Converter
o
Front Exhaust Tube
w/Catalytic Converter
o
Flywheel
Torque Converter
Drive Plate
Transmission
Control Module
Air Fuel Ratio
Sensor, Front
Front Exhaust Tube
Muffler Assy.
w/Catalytic Converter
o
Three-Way
Catalyst
o
Intake Manifold
Collector
Exhaust
Manifold, RH
Exhaust Manifold
Knock Sensor
Versa 1.6LXXXXX
Versa 1.8L X X X X
cube X X XXXX
Sentra 2.0L X X XXXXXX
Rogue XXXXXXX XX
Altima 2.5L X X XXXX XX
Sentra 2.5L X X X X X X X X
Frontier 2.5L XXXXXX X
Murano X X X X X X X X X X X
Murano Convertible X X X X X X X X X X X
Altima 3.5L X X X X X X X
Maxima X X X X X X X
370Z Coupe XXXXX XX XX X X
370Z Roadster XXXXX XX XX X XX
Frontier 4.0L X X X X X X X X
Xterra X X X X X X X X
Pathfinder 4.0L X X X X X X X
Pathfinder 5.6L X X X X X
Armada X X X X
Titan X X X X
(Continued on next page)o Long Term Federal Emission Parts covered for 96 months/or 80,000 miles.
14 CALIFORNIA VEHICLE EMISSION CONTROL WARRANTIES1, 2

WHEEL ALIGNMENT AND BALANCING
Wheel alignment and balancing are important for safety
and maximum mileage from your tires. Check how your
tires are wearing at least once a month. If your tires are
wearing unevenly, such as the inside shoulder of the tire
wearing faster than the rest of the tread, or if you detect
excessive vibration, your vehicle may be out of align-
ment or balance. These conditions not only shorten the
life of your tires, but adversely affect the handling char-
acteristics of your vehicle which could be dangerous. If
you detect irregular wear or vibration, have your align-
ment and balance checked immediately. Tires which
have been run underinflated will show more wear on the
shoulders than in the center of the tread.
HARD BRAKING
You must inspect your tires after any hard braking cir-
cumstances or after tires have slid on the pavement.
This can cause a flat spot in a section of the tire tread.
TIRE SPINNING
Never spin your tires above a speedometer reading of
35 mph (55 km/h) if your vehicle becomes stuck. The
centrifugal force generated by the free spinning
tire/wheel assembly may cause a sudden tire explosion,
resulting in vehicle damage and/or serious personal
injury or death. Never allow anyone to stand near or
behind a tire spinning at high speed while attempting to
push a vehicle that is stuck. When in mud, sand, snow,
ice or other slippery conditions, do not indulge in exces-
sive wheel spin. In such conditions, with automatictransmission vehicles, by accelerating the engine ex-
cessively, it is possible to spin one of the drive tires
beyond its speed capability. This is also true when
balancing a drive tire/wheel assembly using the engine
of the vehicle to spin the wheel.
TIRE TREAD
Tires must be replaced when the depth of the tread
reaches 2/32 inch (1.6 mm) . Tires are manufactured
with tread wear indicators molded into the tire grooves
which indicate tread wearout. As tires approximate 2/32
inch (1.6 mm) wearout, the tread gauge becomes thin-
ner and more vulnerable to the effects of road hazards.
Also, worn tires are more subject to hydroplaning, which
can cause loss of control. Therefore, visual tire inspec-
tion becomes more crucial as the tires wear out.
WORN TIRES
Never drive on worn tires. Tires should be replaced by
trained personnel when 2/32nds of an inch tread depth
remains, as indicated by the tread wear indicators
molded into the tread grooves. In most states, it is illegal
to drive with less than 2/32nds of an inch of tread
remaining.
TIRE MIXING
For best performance select tires similar in size and load
rating to the original equipment tires. It is recommended
that the same size and type of tire be used on all four
wheel positions. In certain tires, casing ply material and
ply construction may vary as indicated on the sidewall of
the tire. When changing or replacing tires, it is preferredthat all four tires are the same construction type (i.e.,
High Performance, All Season, Mud & Snow) and con-
struction (Radial or Bias Ply) . Before mixing tires of
different types on a vehicle in any configuration, be sure
to check the vehicle owner’s manual for its recommen-
dations.
Tires which meet the Rubber Manufacturer’s Associa-
tion (RMA) definition of mud and snow tires are marked
M/S, M+S, M&S. On such tires, this designation is
molded into the sidewall. Tires without this notation are
not recommended for mud and/or snow driving.
If snow tires are needed, it is necessary to select tires
equivalent in size and load rating to the original equip-
ment tires. Always fit performance snow tires in sets of
four (4) for optimum mud & snow traction and mainte-
nance of vehicle handling characteristics. If you do not,
it may adversely affect the safety and handling of your
vehicle. It is also important to check the vehicle owner’s
manual before mixing or matching tires on 4-wheel drive
vehicles as this may require special precautions.
Please refer to your Owner’s Manual for more informa-
tion on tire replacement precautions.
TIRE ROTATION
Tires on your Nissan vehicle should be rotated every
7,500 miles or as irregular wear develops. If irregular
wear becomes apparent or if the wear rate on the tires is
perceptibly uneven, the tires should be rotated in such a
way to alleviate the problem. Check your vehicle for any
mechanical problems and correct if necessary. Any
rotation pattern or procedure may be followed including
those indicated in the Owner’s Manual. Some tires have
(Continued on next page)* Provided by and published at the request of the tire manufacturers/warrantors.
IMPORTANT TIRE SAFETY INFORMATION*43