ignition NISSAN MAXIMA 2003 A33 / 5.G Navigation Manual

Previouskey:
This has two functions.

Go back to the previous display (cancel).
If you touch this key during setup, the setup
will be canceled and the display will return to
the previous screen.

Finish setup.
If you touch this key after the setup is com-
pleted, the setup will be renewed as directed,
and the display will return to the map.Decision on destination:
If you touch the map screen after moving the
joystick,
will be displayed at the point you
touch. It is possible to set that point as the des-
tination (waypoint) by touching the
Destination key .
HOW TO CHANGE THE DISC
INFO:
The ignition key must be in the ON or ACC po-
sition to insert or remove CDs.
This device is provided with the map CD-ROM.
NOTE:
The ignition key must be in the ON or
ACC position to insert or remove CDs.
INV0486
HOW DO I OPERATE THE NISSAN NAVIGATION SYSTEM?
4-10

CAUTION

Close the display while driving to
prevent injury in an accident or
sudden stop.

Do not put any object on the open
display screen.

Do not allow the system to get wet.
Excessive moisture such as
spilled liquids may cause the sys-
tem to malfunction.
SETTING UP THE START-UP
SCREEN
When you turn the ignition key to ACC, the fol-
lowing warning is displayed on the screen:
Read the warning and select the
ENTER key .
INFO:

If you do not touch the
ENTER key , this
system will not proceed to the next step dis-
play .

If you do not use the navigation system,
press the OFF button for the display .
When the engine is turned off during route
calculation and then turned on, the [CON-
FIRMA TION OF DEST ./WA YPOINT] screen
will be displayed after the [SYSTEM
ST ART -UP] screen. When continuing the
previous route guidance, select the
OK
key . T o edit or delete, select the
Change
key .
CLEARING THE MEMORY
All the stored data (Address Book, Avoid Area,
Previous Dest) can be cleared.
1. Change to the current vehicle location
screen.
2. Select the
Setting key .
INV0487
HOW DO I OPERATE THE NISSAN NAVIGATION SYSTEM?
4-12

— When the vehicle is on a loop bridge.
— When the vehicle is on a snow-covered or
unpaved road.
— When the vehicle has made several con-
secutive turns or traveled zigzag.
— When the vehicle is rotated on a parking lot
turntable while the ignition switch is OFF .
— Immediately after the vehicle is driven out
of a parking garage or underground parking
lot.
— When the vehicle has different sizes of tires
or tire chains.
— When the vehicle is moved immediately af-
ter the engine is started.
HOW DO I OPERATE THE NISSAN NAVIGATION SYSTEM?
4-16

CDscreen (when the ignition key is turned
to the ON or ACC position), press the
MAP button.
How to fast-forward/rewind
songs

T o start fast-forward, select thekey
on the screen.

T o start fast-rewind, select the
key
on the screen.

When the key selection is released, the sys-
tem will restart playback from the current
position.
INFO:

When the key is selected continuously , the
speed will increase.

During fast-forward and fast-rewind, the
system produces a small sound.
How to repeat a song
Select thekey to repeat a song to which
you are listening.
How to skip songs

Every time thekey is selected on the
screen, the system advances by one song,
then starts playback.

Every time the
key is selected on the
screen, the system goes back by one song,
then starts playback.

The system skips songs for the number of
the key selection count.
How to use the RANDOM func-
tion
Every time theREPEA T key is selected on
the screen, the screen shifts in the order of
DISC REPEA T , TRACK REPEA T and RANDOM.
DISC REPEA T : All songs are replayed in the
order of the songs.TRACK REPEA T : A song is replayed repeat-
edly .
RANDOM: Songs are replayed in random order
automatically .
How to turn off the power sup-
ply
Select theOFF key on the screen.
INFO:

When the MAP button is pressed, the
system will restart playback.

T o restart the navigation, replace the in-
serted music CDwith the map CD-ROM.
HOW DO I OPERATE THE AUDIO SYSTEM?
13-4

VEHICLE ICON
Symptom Possible cause Remedy
The location names differ, between Planview
and Birdview
TM.This is because the displayed information is
reduced so that the screen does not become
too crowded. There is also a chance that
names ofthe roads or locations will be repeat-
edly displayed. The name appearing on the
screen may be different because of the pro-
cessing procedure.It should not be regarded as abnormal.
The vehicle icon is not shown correctly. The vehicle might have moved with the ignition
off, for example on a ferry boat or car trans-
porter.Drive the vehicle with GPS on for some dis-
tance.
The screen does not switch to night screen
even after turning the headlights on.The last setting is the daytime screen, when
you turned on the lights the last time.Turn the headlights on again, go to [DISPLAY
SETTING] screen and set it to the night
screen.
The map does not scroll even when the vehicle
is traveling.The display is not switched to the map screen.
Press theMAPbutton.
The vehicle icon does not show up. The display is not switched to the map screen.
Press theMAPbutton.
GPS indicator on the screen remains gray. GPS signals are not received because the ve-
hicle is indoors or in the shade ofbuildings.Move the vehicle to outdoors with a clear view
ofthe sky.
GPS signals are not received because some
objects are placed on the instrumental panel.Remove the objects from the instrumental
panel.
GPS satellites are in poor locations. Please wait for the satellites to move to better
locations.
TROUBLESHOOTING GUIDE
15-4