ESP NISSAN MURANO 2007 1.G Quick Reference Guide

REMOTE KEYLESS ENTRY SYSTEM
LOCK DOORS Press the LPD0150 button to lock all doors.
UNLOCK DOORS Press the
lpd0151
button once to unlock the driver’s door only. Press the button again within 5 seconds to unlock all doors.
USING THE PANIC ALARM Press and hold the button for longer than 0.5 seconds. The panic alarm will sound and headlights will stay on for 25 seconds. The panic alarm stops when it has run for 25 seconds or when any button is pressed on the keyfob.
HORN BEEP FEATURE The horn beep feature can be deactivated. Refer to the “Display screen, heater, air conditioner and audio systems” section in your Owner’s Manual for the procedure.
INTELLIGENT K EY SYSTEM
The Intelligent Key System allows you to lock or unlock your vehicle and start the engine.
NOTE: It is important to make sure the Intelligent Key is with you (that is, in your pocket or purse).
 The operating range of the door and trunk lock/unlock function is approximately 31 in (0.8 m).
 Locking the vehicle - Push any door handle Request Switch 01 once.
 Unlocking the vehicle - Push any door handle Request Switch 01 once. The corresponding door will unlock. Push the door handle Request Switch 01 again within 1 minute; all other doors will unlock.
STARTING THE ENGINE
 Push the ignition knob in.
 Confirm the Intelligent Key warning light is illuminated green.
 Turn the ignition knob to start the engine.
TURNING THE ENGINE OFF
 Shift transmission into P (Park).
 Turn ignition knob to LOCK position.
 An audible warning chime will sound when exiting the vehicle if the ignition knob is not completely turned to the OFF position.
01
XTRONIC CONTINUOUSL Y VARIABLE
T RANSMISSION
(CVT) ™
 The Xtronic CVT™ does not produce a gear change
sensation like traditional automatic transmissions.
 The transmission in your Murano requires a special fluid available only at your NISSAN dealer. No other fluid will
meet the exact requirements of the new Xtronic CVT™.

LOAD BUTTON
LOAD A SINGLE DISC - Press the LOAD button for less than 1.5 seconds. Select
the loading slot by pressing the CD insert select button (1-6), then insert the CD.
LOAD UP TO 6 DISCS - Press and hold the LOAD button for more than 1.5
seconds. The slot numbers (1-6) will illuminate on the display when CDs are
loaded into the changer.
SEEK /TRACK BUTTON
For radio, press to seek stations. For CD, press to select previous/next tracks.
STATION AND CD SELECT BUTTON

To store a radio station in a preset first select A, B, or C memory bank by press-
ing the PRESET A•B•C button and tuning to the desired FM, AM, or SAT* station.
Then press the desired station select button for at least 2 seconds. When the pre-
set indicator illuminates, a beep will sound, indicating memorization is complete.
To retrieve a previously set station, select the memory bank where the preset was
set, then press the corresponding station select button.
SCAN BUTTON
Press the SCAN button to tune from low to high frequencies and stop at each
broadcasting station for 5 seconds. If listening to a CD, each track will play for
about 10 seconds.
CAT FOLDER BUTTON CATEGORY (CAT)
When the CAT FOLDER button is pressed for more than 1.5 seconds during FM
(SAT*) mode, the PTY (PROGRAM TYPE) (if so equipped) name of the current
tuned station is displayed. Certain program types may include ROCK, COUNTRY,
JAZZ, CLASSICAL, etc.
MP3 PLAYBACK (if so equipped)
In addition to playing audio CDs, the audio system can play MP3 files recorded on
CD-ROM, CD-R, and CD-RW discs. Each disc can have a maximum of 8 folder
levels and 255 folders. A total of 512 MP3 files can be played back. During MP3
playback, some recorded ID3 tag information can be displayed by pressing the
DISP button. Use the CAT FOLDER button to navigate the MP3 files.
01
05
04
03
02
01
060708
11
12
0910
02
03
04
05
FM/AM/SAT* RADIO WITH CASSETTE PLAYER AND CD CHANGER
(if so equipped)