fold seats NISSAN MURANO 2013 2.G Quick Reference Guide

9
POWER SEATS (if so equipped)

To slide the seat forward or backward, push the
control switch

01 forward or backward.

To recline the seatback, push the switch 02
forward or backward.
SEAT LIFTER (if so equipped for driver’s seat)

To adjust the angle of the front seat cushion or height
of the seat, push the front or rear end of the switch
01 up or down.
LUMBAR SUPPORT (if so equipped for driver’s seat)

To adjust the seat lumbar support, push the front or back end of the switch 03 .
For more information, refer to the “Safety –– Seats, seat belts and supplemental restraint system (section 1)” of your
Owner’s Manual.
010203
REAR SEAT ADJUSTMENTS (Hardtop models)
FOLDING DOWN THE REAR SEAT

To fold the seats fl at, release the connector tongue
of the rear center seat belt from the buckle, then
store the connector and seat belt tongues in the
retractor base on the ceiling
01 .

Fold the seatback forward using either the pull
strap
02 located on the outside edge of the rear
seat or the release lever 03 in the cargo area.

To raise the seatback manually, lift up each seatback
and push it to the upright position until it is latched.

To raise the seatback automatically (if so equipped),
push and hold the power seatback switch located
in the cargo area
04 or the corresponding seat
switch on the lower side of the instrument panel 05 .
– A beep sounds once and the seatback begins to
move automatically.
– A beep sounds twice when the seatback is fully
returned to the upright seating position.
04
02
01
03
05
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.

R EAR S EAT E NTRY/EXIT (CrossCabriolet models)
DRIVER’S SIDE

To enter the rear seat, push and hold the front end of
the slide switch
01 to slide the driver’s seat forward.

Then push and hold the front end of the reclining
switch
02 until the desired angle is obtained.

To exit the rear seat from the driver’s side, pull the
strap
03 behind the driver’s seat to release the
driver’s seatback. The driver’s seatback will tilt
forward so that you can exit the vehicle.
PASSENGER’S SIDE

To fold down the front passenger’s seatback and
unlock the seat position, push the front passenger’s
seatback switch
04 .

Manually slide the seat forward to the
foremost position.

Enter or exit the back seat.
01
02
03
04
first drive features
10
RECLINING THE REAR SEATS
NOTE: Brace the back of the seat with your arm while
pulling on the strap. The seatback will release quickly.

Pull the reclining strap 01 and move the seatback
to the desired angle.

Release the reclining strap after positioning the seat
at the desired angle.
For more information, refer to the “Safety – Seats, seat belts and
supplemental restraint system (section 1)” of your Owner’s Manual.
01
O






F





F
s
A














F
To view detailed instructional videos regarding these and other features,
please go to www.nissanownersinfo.mobi.