spare tire location NISSAN PATHFINDER 2005 R51 / 3.G Owners Manual

NISSAN PATHFINDER 2005 R51 / 3.G Owners Manual PATHFINDER 2005 R51 / 3.G NISSAN NISSAN https://www.carmanualsonline.info/img/5/692/w960_692-0.png NISSAN PATHFINDER 2005 R51 / 3.G Owners Manual

Page 92 of 336

NISSAN PATHFINDER 2005 R51 / 3.G Owners Manual Low tire pressure warning:
If the vehicle is being driven with very low tire
pressure (lower than 28 psi, 193 kPa) , the light
will illuminate and the chime will sound for about
10 seconds. If you sel

Page 206 of 336

NISSAN PATHFINDER 2005 R51 / 3.G Owners Manual WARNING
cIf the low tire pressure warning light
flashes while driving, avoid sudden
steering maneuvers or abrupt braking,
reduce vehicle speed, pull off the road
to a safe location and stop the vehicl

Page 231 of 336

NISSAN PATHFINDER 2005 R51 / 3.G Owners Manual cWhen installing a spare tire, make sure
it is the proper size and type as speci-
fied on the tire placard. For tire placard
location information, refer to “Tire plac-
ard” in the “Technical and

Page 234 of 336

NISSAN PATHFINDER 2005 R51 / 3.G Owners Manual FREEING A FROZEN DOOR LOCK
To prevent a door lock from freezing, apply de-
icer through the key hole. If the lock becomes
frozen, heat the key before inserting it into the key
hole.
ANTI-FREEZE
In the

Page 239 of 336

NISSAN PATHFINDER 2005 R51 / 3.G Owners Manual WARNING
cIf the low tire pressure warning light
flashes while driving, avoid sudden
steering maneuvers or abrupt braking,
reduce vehicle speed, pull off the road
to a safe location and stop the vehicl

Page 294 of 336

NISSAN PATHFINDER 2005 R51 / 3.G Owners Manual 1. Wear indicator
2. Location mark
Tire wear and damage
WARNING
cTires should be periodically inspected
for wear, cracking, bulging or objects
caught in the tread. If excessive wear,
cracks, bulging o

Page 308 of 336

NISSAN PATHFINDER 2005 R51 / 3.G Owners Manual Use the following steps to mount the front license
plate:
s1Make holes on the plastic finisher at the
location mark (small dimple) using a 0.20 in
(5 mm) drill. Apply light pressure to the drill.
Inst