Combination NISSAN PATROL 2004 Electronic Owner's Manual

Wiring Diagram Ð TURN Ð/Type B
FOR CHINARear combination lamps are located on rear bumper.
TEL004N
TURN SIGNAL AND HAZARD WARNING LAMPS/WAGON AND HARDTOPMODELS
EL-4073

Wiring Diagram Ð TURN Ð/Type C
FOR EUROPERear combination lamps are located on rear bumper.
TEL006N
TURN SIGNAL AND HAZARD WARNING LAMPS/WAGON AND HARDTOPMODELS
EL-4075

Wiring Diagram Ð TURN Ð/Type D
FOR AUSTRALIA AND SOUTH AFRICARear combination lamps are located on rear bumper.
TEL008N
TURN SIGNAL AND HAZARD WARNING LAMPS/WAGON AND HARDTOPMODELS
EL-4077

Combination Meter
CEL587M
METER AND GAUGES/WAGON AND HARDTOP MODELS
EL-4095

2. CHECK HARNESS
1. Turn ignition switch OFF.
2. Disconnect transfer unit connector and display connector.
3. Check continuity between transfer unit harness connector M173 terminals 19, 20 (B) and display harness connectorM112 terminals 17, 16 (B).
SKIA9225E
19 - 17 Continuity should exist.
20 (B) - 16 (B) Continuity should exist.
4. Check continuity between transfer unit harness connector M173 terminals 19, 20 (B) and ground. 19, 20 (B) - Ground Continuity should not exist. OK or NG
OK ©Replace transfer unit.
NG ©Repair harness or connector.
VEHICLE SPEED SIGNAL CHECK
1. CHECK VEHICLE SPEED OPERATION
Does speedometer is operated normally?
YesorNo
Ye s ©GO TO 2.
No ©Check combination meter.
2. CHECK HARNESS
1. Turn ignition switch OFF.
2. Disconnect NAVI control unit connector and combination meter connector.
3. Check continuity between NAVI control unit harness connector M168 terminal 28 (R/W) and Uni®ed meter control unit
harness connector M143 terminal 64 (R/W).
PKIB0549E
28 (R/W) - 64 (R/W) Continuity should exist.
4. Check continuity between NAVI control unit harness connector M168 terminal 28 (R/W) and ground. 28 (R/W) - Ground Continuity should not exist. OK or NG
OK ©GO TO 3.
NG ©Repair harness or connector.
NAVIGATION SYSTEM
Trouble Diagnoses (Cont'd)
EL-4206

3. CHECK VEHICLE SPEED SIGNAL
1. Connect NAVI control unit and combination meter connector.
2. Start engine and drive vehicle at more than 40 km/h (25 MPH).
3. Check the signal between NAVI control unit harness connector M168 terminal 28 (R/W) and ground with CONSULT-ll oroscilloscope.
SKIA9106E
28 (R/W) - Ground: Refer to EL-4183. OK or NG
OK ©Replace NAVI control unit.
NG ©Replace uni®ed meter control unit.
ILLUMINATION SIGNAL CHECK
1. CHECK TAIL LAMP OPERATION
When lighting switch turned 1st or 2nd position, does tail lamp illuminate?
YesorNo
Ye s ©GO TO 2.
No ©Go to tail lamp trouble diagnosis.
2. CHECK ILLUMINATION SIGNAL
Check voltage between NAVI control unit and ground.
SKIB0315E
OK or NG
OK ©Replace NAVI control unit.
NG ©Repair harness or connector.
Terminals
Lighting switch position Voltage
(+)
(þ)
Connector Terminal (wire color)
M168 25 (L/B) Ground 1st or 2nd position Battery voltage
OFF Approx. 0V
NAVIGATION SYSTEM
Trouble Diagnoses (Cont'd)
EL-4207

jB
Note
CHECK VOLTAGE FOR COMBINATION
METER. (COMPRESSOR ON SIGNAL)
Do approx. 12V exist between combina-
tion meter harness connector terminal No.
j
42and ground?
Ye s
cNo
CHECK CIRCUIT CONTI-
NUITY BETWEEN COMBI-
NATION METER HAR-
NESS CONNECTOR TER-
MINAL NO.j
42AND ECM
HARNESS CONNECTOR
TERMINAL NO.j
86.
Continuity should exist.
If OK, check harness for
short.
OK
Replace ECM.
CHECK VOLTAGE FOR COMBINATION
METER. (FAN ON SIGNAL)
Do approx. 12V exist between combina-
tion meter harness connector terminal No.
j
43and ground?
Ye s
cNo
Replace combination
meter.
Disconnect combination meter and auto
amp. harness connector.
Note
CHECK CIRCUIT CONTINUITY
BETWEEN COMBINATION METER HAR-
NESS CONNECTOR TERMINAL NO.j
43
AND AUTO AMP. HARNESS CONNEC-
TOR TERMINAL NO.j
19.
Continuity should exist.
If OK, check harness for short.
OK
CHECK REFRIGERANT PRESSURE
SENSOR.
Refer to EC-498 (publication No. SM2E-
Y61FG1).
OK
cNG
Replace refrigerant pres-
sure sensor.
Replace auto amp.
Note:
If the result is NG or No after checking circuit continuity, repair harness
or connector.
SHA693FA
SHA694F
RHA387I
SHA697F
.
.
.
.
.
.
.
TROUBLE DIAGNOSESAUTO
Magnet Clutch (Cont'd)
HA-4042

A
A/C operational check ................................HA-4032
A/C self-diagnoses (auto A/C)....................HA-4025
A/C, A - Wiring diagram .............................HA-4009
A/CCUT - Wiring diagram ..........................EC-4058
Air cleaner ®lter replacement .....................MA-4003
Air ¯ow meter - See Mass air ¯ow
sensor .....................................................EC-4047
Air mix. door motor.....................................HA-4036
Antenna .......................................................EL-4164
ASCD (automatic speed control
device) .....................................................EL-4233
ASCD - Wiring diagram ..............................EL-4234
A/T - Wiring diagram ...................................AT-4003
A/T trouble diagnoses .................................AT-4011
A/T Wiring diagram AT - NONDTC .............AT-4012
Audio ...........................................................EL-4136
AUDIO - Wiring diagram .............................EL-4137
Audio and A/C control removal and
installation - See Instrument panel .........BT-4006
Auto air conditioner - Wiring diagram ........HA-4009
Automatic speed control system - See
ASCD ......................................................EL-4233
AV and NAVI control unit ............................EL-4164
B
Back-up lamp ..............................................EL-4055
BACK/L - Wiring diagram............................EL-4055
Blower motor ..............................................HA-4038
Bumper, front ..............................................BT-4002
Bumper, rear ...............................................BT-4005
C
Camshaft ....................................................EM-4003
CHIME - Wiring diagram .............................EL-4113
Combination meter......................................EL-4095
Combination meter removal and instal-
lation - See Instrument panel..................BT-4006
Combination switch .....................................EL-4034
COMPAS - Wiring diagram .........................EL-4099
Console box - See Instrument panel ..........BT-4006
CONSULT-II general information.................GI-4002
Cruise control - See ASCD .........................EL-4233
Cylinder head .............................................EM-4016
D
Daytime light system...................................EL-4047
DEF - Wiring diagram .................................EL-4126
DEICER - Wiring diagram...........................EL-4125
Dimensions ..................................................GI-4008
D/LOCK - Wiring diagram ...........................EL-4245Dome light - See Interior lamp ...................EL-4088
DTRL - Wiring diagram ...............................EL-4047
E
ECM input/output signal .............................EC-4040
Electrical load signal circuit ...EC-4008, 4016, 4025
Electrical units location ...............................EL-4300
Engine control circuit
diagram .............................EC-4003, 4005, 4013,
4022, 4037, 4059
Exhaust system ..........................................FE-4008
Exterior ........................................................BT-4009
F
F/FOG - Wiring diagram .............................EL-4061
FICD - Wiring diagram ...............................EC-4036
Fog lamp, front............................................EL-4061
Fog lamp, rear ............................................EL-4064
Front bumper ..............................................BT-4002
Front fog lamp.............................................EL-4061
Front washer ...............................................EL-4117
Front wiper ..................................................EL-4117
Fuel gauge ..................................................EL-4095
Fuse ..............................................................Foldout
Fusible link....................................................Foldout
G
Gauges........................................................EL-4095
GLOW - Wiring diagram.............................EC-4033
GPS antenna ..............................................EL-4164
Ground distribution......................................EL-4016
H
Harness layout ..................................EL-4307, 4308
Headlamp ....................................................EL-4040
Headlamp washer .......................................EL-4122
Heat up switch............................................EC-4054
Heated seat.................................................EL-4231
HEATUP - Wiring diagram .........................EC-4054
Height (Dimensions) ....................................GI-4008
H/LAMP - Wiring diagram ...........................EL-4040
HLC - Wiring diagram .................................EL-4122
Hood............................................................BT-4002
Horn ............................................................EL-4124
HORN - Wiring diagram..............................EL-4124
HSEAT - Wiring diagram.............................EL-4231
I
ILL - Wiring diagram ...................................EL-4080
ALPHABETICAL INDEX
IDX-4002