seats NISSAN PICK-UP 1999 Repair Manual

Side and Floor Trim
CAUTION:
Wrap the tip of flat-bladed screwdriver with a cloth when removing metal clips from garnishes.
REMOVAL Ð Body side trim
V1Remove front and rear seats. Refer to ªSEATº for details, in BT section of Service Manual Pub. No.
SM8E-0D22E0E.
V2Remove front and rear seat belts. Refer to ªSEAT BELTSº in RS section details.
V3Remove front and rear kicking plate.
V4Remove dash side lower finishers.
V5Remove front and rear body side welts.
V6Remove front pillar garnishes.
V7Remove center pillar lower garnishes.
V8Remove center pillar upper garnishes.
V9Remove lock pillar garnishes.
INTERIOR TRIM
BT-2007

Roof Trim
REMOVAL Ð Headlining
V1Remove front and rear seats. Refer to ªSEATº for details, in BT section of Service Manual Pub. No.
SM8E-0D22E0E.
V2Remove front and rear seat belts. Refer to ªSEAT BELTSº in RS section for details.
V3Remove body side trim. Refer to ªSide and Floor Trimº for details, BT-2007.
V4Remove sun visors.
V5Remove spot lamp assembly.
V6Remove inside mirror assembly.
V7Remove interior lamp assembly.
V8Remove assist grips.
V9Remove rear window weatherstrip and remove rear window glass.
V10Remove clips, then remove headlining.
SBT834
INTERIOR TRIM
BT-2010

4. Heat cylinder head to 120 to 140ÉC (248 to 284ÉF) and press
service valve guide onto cylinder head.
Projection ªLº:
13.3 - 13.9 mm (0.524 - 0.547 in)
5. Ream valve guide.
Finished size:
Intake & Exhaust
7.000 - 7.018 mm (0.2756 - 0.2763 in)
VALVE SEATS
Check valve seats for pitting at contact surface. Resurface or
replace if excessively worn.
lBefore repairing valve seats, check valve and valve
guide for wear. If they have worn, replace them. Then
correct valve seat.
lUse both hands to cut uniformly.
REPLACING VALVE SEAT FOR SERVICE PARTS
1. Bore out old seat until it collapses. Boring should not con-
tinue beyond the bottom face of the seat recess in cylinder
head. Set the machine depth stop to ensure this.
2. Ream cylinder head recess.
Reaming bore for service valve seat
Oversize [0.5 mm (0.020 in)]:
Intake 38.000 - 38.016 mm (1.4961 - 1.4967 in)
Exhaust 32.700 - 32.716 mm (1.2874 - 1.2880 in)
Use the valve guide center for reaming to ensure valve seat
will have the correct fit.
3. Heat cylinder head to 120 to 140ÉC (248 to 284ÉF).
4. Press fit valve seat until it seats on the bottom.
SEM301D
SEM300D
SEM302D
SEM795A
SEM008A
CYLINDER HEADKA24DE
Inspection (Cont'd)
EM-2030