wheel NISSAN ROGUE SELECT 2015 2.G Quick Reference Guide
[x] Cancel search | Manufacturer: NISSAN, Model Year: 2015, Model line: ROGUE SELECT, Model: NISSAN ROGUE SELECT 2015 2.GPages: 20, PDF Size: 1.61 MB
Page 2 of 20
*See your Owner’s Manual for information.1 Vehicle Information Display*2 Headlight and Turn Signal Switch3 Low Tire Pressure Warning Light4 Instrument Brightness Control Switch*5 Trip Change Button*
6 Windshield Wiper and Washer Switch7 Outside Mirror Control Switch8 Steering Wheel Switches for
Audio Control* / Bluetooth
®
9 Cruise Control
10 AWD Lock Switch*11 Vehicle Dynamic Control (VDC)
Off Switch*12 Steering Wheel Tilt Adjustment*13 Hood Release*
14 Audio System15 Manual Climate Controls16 Power Outlet*17 Front Passenger Air Bag
Status Light*
1
3
7
14
4
15
5
6
17
16
2
8
9
13
12
10
11
1706218_15a_Rogue_Select_QRG_111814.indd 411/18/14 2:43 PM
Page 6 of 20
4
TOWING YOUR VEHICLE
ALL-WHEEL DRIVE (AWD) VEHICLE (if so equipped)
An all-wheel drive vehicle must be towed with all wheels off the ground \
even if the
vehicle is placed in the 2WD mode.
For proper towing and to avoid accidental damage to your vehicle, NISSAN recommends
that a service operator tow your vehicle after carefully reading the Own\
er’s Manual precautions.
For more information, refer to the “In case of emergency (section 6)” of your Owner’s Manual.
OUTSIDE TEMPERATURE DISPLAY
When the ignition switch is in the ON position, the
outside air temperature will appear in the vehicle
information display
1.
If the outside air temperature is below 25°F (-4°C),
the outside temperature display will blink for 20
seconds then remain on when the ignition is
switched on.
If the outside air temperature is between 27°F and 37°F (-3°C and +3°C), the outside
temperature display will blink continuously with the ignition switch in the ON position.
To stop the outside temperature display from blinking, stop the vehicle i\
n a safe place
and move the shift lever to the P (PARK) position. Perform the following procedure:
1. Press the
switch
2 until the Settings mode is displayed.
2. Turn the switch 2 until it reaches the Alarms mode then press to select.
3. Turn the switch until it reaches the Outside temp mode then press to select.
4. Turn the
switch until it reaches the Off mode then press to select.
5. To exit, press the
switch again.
LOW OUTSIDE TEMPERATURE WARNING
The Low outside temperature warning message will appear in the vehicle information
display
3 when the outside temperature drops below 37°F (+3°C) with the ignition
switch in the ON position.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
1
3
2
ESSE NTIAL I N FOR MATION
1706218_15a_Rogue_Select_QRG_111814.indd 411/18/14 2:44 PM
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.
Page 16 of 20
14
SYSTEM GUIDE
When speaking phonebook names, please be aware some phones require the la\
st name
to be spoken before the first name. For example, “Michael Smith” may be spoken as
“Smith Michael”.
To cancel a Voice Recognition session, say “Exit” or press and hold the button.
To decrease or increase the volume of the voice prompts, push the volume \
control
switches
or
on the steering wheel or turn the VOL (volume) control knob on the
audio system while the system is responding.
Voice commands can be used to operate various Bluetooth® System features using the
NISSAN Voice Recognition System. See your Owner’s Manual for detailed information.
For more detailed information and instructions, refer to your cellular phone’s Owner’s
Manual and visit www.nissanusa.com/bluetooth.
CONNECTING PROCEDURE
The vehicle must be stationary when connecting the phone.
1. Press the
button on the steering wheel. The system announces the
available commands.
2. Say: “Connect Phone”. The system acknowledges the command and announces the next
set of available commands.
3. Say: “Add Phone”. The system acknowledges the command and asks you to initiate
connecting from the phone handset.
4. Initiate connecting from the phone:
• The connecting procedure varies according to each cellular phone model.
For detailed connecting instructions and compatible phones, please visit
www.nissanusa.com/bluetooth.
• When prompted for a PIN, enter “1234” from the handset. (The PIN is assigned by
NISSAN and cannot be changed.)
5. Say a name for the phone when the system asks you to provide one. You can give the
phone a name of your choice.
PHONEBOOK SETUP
Depending on your cellular phone, the system may automatically download \
your cellular
phone’s entire phonebook to the vehicle’s Bluetooth® system.
If the phonebook does not download automatically, 40 entries can be
individually downloaded.
To manually download entries:
1. Push the
button on the steering wheel.
2. After the tone, say “Phonebook”.
3. After the next tone, say “Transfer Entry”. The system acknowledges the command and
asks you to initiate the transfer from the phone handset. The new contact’s phone
number will be transferred from the cellular phone to the vehicle.
1706218_15a_Rogue_Select_QRG_111814.indd 1411/18/14 2:44 PM
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.