tow bar NISSAN TITAN 2007 1.G Quick Reference Guide

FOLDING THE REAR BENCH SEAT
To fold the rear bench seat for storage capacity behind the front seats, or to remove the jacking tools from the storage area:
 Lift up on the lever 01, located on the side of the seat, while lifting the front of the seat cushion up.
 Fold the bottom of the seat cushion toward the back of the vehicle until it locks in place.
 Repeat this process to raise and secure the seat cushion on the other side of the vehicle for maximum storage capacity.
FRONT SEAT ADJUSTMENTS
With manual seats (if so equipped):
 Pull up on the lever under the front of the seat and slide
backward or forward; release.
 Lift the lever 01 on the side of the seat to adjust your
seatback backward or forward; release when you have
found a comfortable angle and the seat belt fits properly.
With power seats (if so equipped):
 Move the control 02 forward or backward to adjust the
seat cushion forward or backward.
 Pull up on the control 02 to raise the seat cushion;
press down to lower the cushion.
 Push the switch 03 forward to move the seatback
forward; push it back to move the seatback backward.
LUMBAR SUPPORT (if so equipped):
Your driver’s seat has a lumbar support; adjust it by moving
the lever 04 up or down.
0302
01
04
causes lower tire pressure. This may cause the low tire pressure warning light to illuminate.
If the low tire pressure warning light illuminates, check the tire pressure in all four tires. To turn the low tire pressure warning light off, adjust the low tire pressure to the recommended COLD tire pressure shown on the Tire and Loading Information label located in the driver’s door opening.
If TPMS is not functioning properly, the low tire pressure warning light will flash for approximately 60 seconds when the key is turned on. After 60 seconds, the light will remain on. Have the system checked by a NISSAN dealer.
01