NISSAN TITAN 2014 1.G Owners Manual

NISSAN TITAN 2014 1.G Owners Manual https://www.carmanualsonline.info/img/5/399/w960_399-0.png NISSAN TITAN 2014 1.G Owners Manual

Page 391 of 455

NISSAN TITAN 2014 1.G Owners Manual The tire pressures should be checked when the
tires are cold. The tires are considered COLD
after the vehicle has been parked for 3 or more
hours, or driven less than 1 mile (1.6 km) at
moderate speed

Page 392 of 455

NISSAN TITAN 2014 1.G Owners Manual Tire and loading information label
1Seating capacity: The maximum num-
ber of occupants that can be seated
in the vehicle.
2Vehicle load limit: See loading infor-
mation in the “Technical and con-

Page 393 of 455

NISSAN TITAN 2014 1.G Owners Manual Checking tire pressure
1. Remove the valve stem cap from thetire.
2. Press the pressure gauge squarely onto the valve stem. Do not press too
hard or force the valve stem side-
ways, or air will escape

Page 394 of 455

NISSAN TITAN 2014 1.G Owners Manual TIRE LABELING
Federal law requires tire manufacturers to
place standardized information on the
sidewall of all tires. This information iden-
tifies and describes the fundamental
characteristics of the

Page 395 of 455

NISSAN TITAN 2014 1.G Owners Manual 2TIN (Tire Identification Number) for a
new tire (example: DOT XX XX XXX
XXXX)
1. DOT: Abbreviation for the “Depart- ment Of Transportation”. The symbol
can be placed above, below or to the
left

Page 396 of 455

NISSAN TITAN 2014 1.G Owners Manual 7The word “radial”
The word “radial” is shown if the tire has
radial structure.
8Manufacturer or brand name
Manufacturer or brand name is shown.
Other Tire-related Terminology
In addition to

Page 397 of 455

NISSAN TITAN 2014 1.G Owners Manual Generally, snow tires have lower speed ratings
than factory equipped tires and may not match
the potential maximum vehicle speed. Never ex-
ceed the maximum speed rating of the tire.
If you install sn

Page 398 of 455

NISSAN TITAN 2014 1.G Owners Manual Wheel nut tightening torque:98 ft-lb (133 N·m)
The wheel nuts must be kept tight-
ened to specifications at all times. It
is recommended that wheel nuts be
tightened to specification at each
tire rot

Page 399 of 455

NISSAN TITAN 2014 1.G Owners Manual Replacing wheels and tires
When replacing a tire, use the same size, tread
design, speed rating and load carrying capacity
as originally equipped. Recommended types and
sizes are shown in “Wheels an

Page 400 of 455

NISSAN TITAN 2014 1.G Owners Manual If excessive tire wear is found, it is recommended
that all four tires be replaced with tires of the
same size, brand, construction and tread pattern.
The tire pressure and wheel alignment should
also