reset NISSAN VERSA 2007 1.G Quick Reference Guide

CHILD SAFETY REAR DOOR LOCK
Child safety locks help prevent the rear doors from being
opened accidentally, especially when small children are
in the vehicle. The child safety lock levers are located
on the edge of the rear doors. When the lever is in the
LOCK position, the door can be opened only from the
outside.
HEADLIGHT AND TURN SIGNAL CONTROL
HEADLIGHT SWITCH
 Turn the headlight switch to the position to turn
on the front parking, tail, license plate and instrument
panel lights.
 Turn the headlight switch to the position to turn on
the headlights. All other lights remain on.
HIGH BEAM
 Push the headlight switch forward to select the high beam function. The blue
indicator light illuminates. Pull the headlight switch back to the original position to
select the low beam. The blue indicator light goes off.
 Pull and release the headlight switch to flash the headlight high beams on and off.
TURN SIGNAL SWITCH
 Move the headlight control switch up or down to signal the turning direction. When
the turn is completed, the turn signals cancel automatically.
 To signal a lane change, move the headlight control switch up or down to the point
where the indicator light begins to flash, but the headlight control switch does not
latch.
FOG LIGHT OPERATION (if so equipped)
NOTE: The headlights must be on and the low beams selected for the fog lights to
operate.
 Turn the switch to the position to turn on the fog lights. The indicator light

illuminates.
 Turn the switch to the OFF position to turn off the fog lights. The indicator light

goes off.
TWIN TRIP ODOMETER
 The twin trip odometer records the distance of
individual trips.
 Press the button 01 to change the display as

follows: Trip A Trip B Trip A.
 Press and hold the button for more than 1 second to
reset the trip odometer to zero.
01

WINDSHIELD WIPER/WASHER SWITCH
 The ignition switch must be in the ON position to
activate the windshield wipers.
 Push the lever down to operate the windshield wipers.
 Switch operation includes:
Intermittent – Wipers operate intermittently and can be adjusted by turning the
time control.
Low speed – Wipers operate at a continuous low speed.
High speed – Wipers operate at a continuous high speed.
Mist – Lift the lever up for one sweep operation of the wiper.
Wash – Pull the lever toward you. Wipers automatically wipe several times.

Rear wiper and washer switch (Hatchback only) – The rear window wiper and
washer operates when the ignition switch is in the ON position. Turn the switch
forward to operate rear window wipers. Switch operation includes:
Intermittent (not adjustable) – Wipers operate intermittently.
On – Wipers operate at a continuous speed.
Wash – Push the lever away from you. Wipers automatically wipe several
times.
INT
LO
HI
MIST
INT
ON
LCN0042
LCN0042
CRUISE CONTROL (if so equipped)
 To activate the cruise control, push the ON/OFF
switch. The indicator light in the instrument panel will
illuminate.
 To set cruising speed, accelerate the vehicle to the
desired speed, push the COAST/SET switch and
release it. The SET indicator light in the instrument
panel will illuminate.
 To reset at a faster cruising speed, push and hold the ACCEL/RES switch. When the
vehicle reaches the speed you desire, release the switch.
 To reset at a slower cruising speed, push and hold the COAST/SET switch. Release
the switch when the vehicle slows to the desired speed.
 To resume a preset speed, push and release the ACCEL/RES switch. The vehicle
returns to the last set cruising speed when the vehicle speed is over 24 MPH (38
km/h).
 To cancel cruise control, push the CANCEL switch or tap the brake pedal. The SET
indicator light in the instrument panel will go out.
 To turn off cruise control, push the ON/OFF switch. Both the CRUISE indicator light
and the SET indicator light in the instrument panel will go out.

XTRONIC CONTINUOUSLY VARIABLE
TRANSMISSION (CVT) ™ (if so equipped)
 The Xtronic CVT™ does not produce a gear change sensation like traditional automatic transmissions.
 R (Reverse) speed, for CVT vehicles, is limited to 15 MPH (25 km/h).
STARTING THE ENGINE WITH CVT (Intelligent Key models only)
 Push the ignition knob in.
 Confirm the Intelligent Key warning light is illuminated green.
 Turn the ignition knob to start the engine.
TURNING THE ENGINE OFF WITH CVT (Intelligent Key models only)
 Shift transmission into P (Park).
 Turn ignition knob to LOCK position.
OVERDRIVE (O/D) OFF SWITCH
 Each time your vehicle is started, the transmission is automatically “reset” to Overdrive on.
 To turn Overdrive mode off, push the O/D OFF switch 01. The
LCN0030
O/DOFF light in the instrument panel will illuminate.
 Use the Overdrive off mode when you need improved engine braking.
The transmission in your Versa requires a special fluid (NS-2) available only at your NISSAN dealer. No other fluid will meet the exact requirements of the new Xtronic CVT™.
6-SPEED MANUAL TRANSMISSION (if so equipped)
LOCK OUT
 In 6-speed manual transmission equipped vehicles, the shift lever is equipped with a Reverse lock-out feature that prevents accidental selection of Reverse (instead of 1st gear).
SHIFTING TO REVERSE
 Lift up on the collar just below the shift lever, then move it to the left and up into Reverse.
PUSH RELEASE BUTTON (Intelligent Key Models with Manual Transmission only)
 The ignition knob can only be turned to the LOCK position when the PUSH release button 01 has been pressed.
 The LCN0129
LOCK Intelligent Key lock warning light blinks and the buzzer sounds if the PUSH release button has not been pressed completely when the ignition knob is turned to
the LOCK position.
01
01

0102
0305
07
06
04
FM/AM/SAT* RADIO WITH CD C HANGER (if so equipped)
05
08
07
06
SEEK/TRACK/FILE BUTTON
Press the SEEK/TRACK/FILE button to skip from one track to another on a CD.
Each time the button is pressed, the CD will advance or skip back one track.
TUNE/FF.REW/FOLDER BUTTON
Press the TUNE/FF.REW/FOLDER button to manually tune the radio. If playing
a CD, press to fast forward or rewind a CD. If playing a CD that is formatted for
MP3s, press the TUNE/FF.REW/FOLDER button to skip folders. Press and hold
the button to fast forward or rewind an MP3 CD.
RADIO BUTTON
Press the RADIO select button to change the band to either FM, AM or SAT* radio
stations.
SCAN BUTTON
Press the SCAN button to quickly scan through each broadcasting station. The tuner
will pause for 5 seconds on each broadcasting station.
PRESET A
.B.
C BU TTON
Press the PRESET A.B.C button until you reach the desired setting. The radio is
equipped with three separate banks, each with six station presets. You may store any
combination of FM, AM or SAT* radio presets on each bank.
CD PLAY BUTTON
Press the CD button to begin CD play.
SCROLL BUTTON
Press the SCRL button to scroll through CD/MP3 text that is too long to be
displayed on the first line of the display.
AUX BUTTON
Press the AUX button to play a compatible device such as an MP3 player when it is plugged into the AUX IN jack.
04
03
02
01
0908
10
12
The antenna should be placed in the rearward position for maximum radio reception.
11

AUDIO BUTTON
Press the AUDIO button to change the audio settings. Adjust the bass, treble,
balance, fade and Speed Sensitive Volume (SSV) and beep on /off by pressing the
AUDIO button until the desired mode appears in the display. Press the TUNE/
FF.REW/FOLDER button up or down to adjust to the desired level.
STATION AND CD SELE CT BU TTONS
To store a station in a preset you must first select A, B, or C memory bank by
pressing the PRESET A.B.C button and tune to the desired FM, AM or SAT*
station. Then press and hold the desired station select button for at least 2
seconds. When the preset indicator illuminates, a beep will sound, indicating
memorization is complete. To retrieve a previously set station, select the memory
bank where the preset was set, then press the corresponding station select button.
LOAD BUTTON
LOAD A SINGLE DISC - Press the LOAD button for less than 1.5 seconds. Select
the loading slot by pressing the CD insert button (1- 6), then insert the CD.
LOAD UP TO 6 DISCS - Press and hold the LOAD button for less than 1.5
seconds. The slot numbers (1- 6) will illuminate on the display when the CDs are
loaded into the charger.
10
STEERING WHEEL SWITCHES FOR AUDIO
CONTROL (if so equipped)
 To choose Preset A, B, C, CD or SAT (if so equipped)
press SOURCE repeatedly.
 The tuning up or down switch can be used to
perform the following:
•
Push the switch for less than 1.5 seconds to

change to a preset station.
• Push and hold the
switch for more than 1.5 seconds to seek the next or

previous broadcasting radio station.
• Push the
switch while playing a CD (if so equipped) for less than 1.5 seconds to

change tracks on the CD.
• If the vehicle is equipped with a CD changer, push and hold for more than 1.5
seconds to change between CDs.
09
* SAT presets are only available on SAT equipped vehicles.
CLOCK/SET ADJUSTMENT (if so equipped)
CLOCK OPERATION
 Pressing the CLOCK button displays the clock with the radio on or off. Press
the CLOCK button again to turn off the clock display.
CLOCK SET
1. Press and hold the CLOCK button for more than 1.5 seconds to enter the clock
set mode.
2. Press the SEEK/TRACK/FILE button 01 to adjust the hours.
3. Press the TUNE/FF.REW/FOLDER button 02 to adjust the minutes.
4. Press the CLOCK button again to exit the clock set mode.
12
11